Manuale per l’uso Metra Electronics Automobile Parts

16 pagine 1.16 mb
Scarica

Vai alla pagina of 16

Summary
  • Metra Electronics Automobile Parts - page 1

    © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORA TION 1-800-221-0932 axxessinterf ace.com INST ALLA TION INSTRUCTIONS FOR PART ASWCST ALK The ASWCST ALK is the newest addition to the Axxess steering wheel control solution, allowing you to add steering wheel control options to your vehicle. Using an aftermarket radio that is equipped with a steering ...

  • Metra Electronics Automobile Parts - page 2

    T OOLS REQUIRED FOR INST ALLA TION •Cutting T ool •T ape •Crimping T ool •Connectors (I.E. butt-connectors, bell caps, ECT…) • Female Spade Connectors IGNITION TERMINALS WIRE CUTTER M3.5 M2.6 M3 M5 M4 ISO 6 2.5 1.5 *Impor tant: Please chec k steering shroud before drilling to mak e sure you hav e enough depth. *After mar k et r adio mus ...

  • Metra Electronics Automobile Parts - page 3

    ASWCST ALK ASSEMBL Y 1. Remove and drill a 3/8 hole in the steering wheel shroud. 2. Select desired length rod and thread a 3/8 hex nut on to the shorter threaded section. 3. Run the four wires from the ASWCST ALK through the rod of choice and screw it into the ASWCST ALK 4. T ake the twist on cover , run the wires through, and twist the cap on to ...

  • Metra Electronics Automobile Parts - page 4

    Wiring Of ASWCST ALK And Interface 1. Connect the BLACK wires of the ASWCST ALK and the BLACK wire of the interface to ground. Y ou may use the same ground point that is used for the radio. 2. Connect the GREEN/ORANGE and BLACK/GREEN wires of the ASWCST ALK to the corresponding wires on the interface. 3. Connect the RED wire to 12 volt accessory 4. ...

  • Metra Electronics Automobile Parts - page 5

    Programming the ASWCST ALK * If this is the rst time the ASWCST ALK is being installed: 1. T urn the ignition on; the led will start ashing rapidly which means the interface is looking for the ASWCST ALK and the radio. Go to step 3. OR * If the ASWCST ALK was installed before: 1. T urn the ignition on, the led will ash slowly 2. Hold down ...

  • Metra Electronics Automobile Parts - page 6

    4. The ASWCST ALK is now congured for the right side. T roubleshooting the Auto Detect Mode So you tried the auto detect feature and at the end the led did not stay on solid red, it started ashing, or the steering wheel controls did not function properly . That means the interface did not detect the ASWCST ALK or the proper radio. Follow thes ...

  • Metra Electronics Automobile Parts - page 7

    • Long ashes represent the wire(s) that are connected to the interface • 3rd led ash is the Green/Orange wire on the interface • 5th led ash is the Black/Green wire on the interface If during the auto detect sequence there was no long led ash, just short ones, the interface was not connected to the correct wire on the ASWCST ALK o ...

  • Metra Electronics Automobile Parts - page 8

    1. V olume up 2. V olume down 3. Seek up 4. Seek down 5. Mode (source) 1. V olume up 2. V olume down 3. Seek up 4. Seek down 5. Mode (source) Remapping the ASWCST ALK Let’s say you have the ASWCST ALK programmed to your radio and you want to change the button assignment for the steering wheel controls. For instance you would like Seek Up to be Mu ...

  • Metra Electronics Automobile Parts - page 9

    NOTES: • The interface must have detected the ASWCST ALK and radio it is attached to before you can remap any buttons. • Y ou can only start the remapping of the steering wheel controls process within the rst 20 seconds of turning the ignition key on. If you wait longer then the 20 seconds you will have to turn the ignition off then back on ...

  • Metra Electronics Automobile Parts - page 10

    5. Source/Mode 6. Mute 7. Preset Up 8. Preset Down 9. Power 10. Band 1 1. Play/Enter 12. PTT (Push T o T alk) 13. On Hook 14. Off Hook 15. Fan Up 16. Fan Down 17. T emp Up 18. T emp Down * Note: Remember not all radios will have all these commands. Please refer to the radios’ owners manual for specic commands recognized by the radio. For insta ...

  • Metra Electronics Automobile Parts - page 11

    After the 18th button is programmed or skipped the led will go out and the remapping is completed. If for any reason after remapping the steering wheel controls you want to go back to the original steering wheel control settings, follow the step in “IF the ASWCST ALK was installed before”. Manually Setting The Radio T ype 1. Within the rst 2 ...

  • Metra Electronics Automobile Parts - page 12

    programmed Kenwood. 5) Here is the chart to show how many presses of the V olume Up button is needed for which radio you are trying to program: 1st led ash is for Eclipse 2nd led ash is for Kenwood 3rd led ash is for Clarion 4th led ash is for Sony and Dual 5th led ash is for JVC 6th led ash is for Pioneer and Jensen 7th led as ...

  • Metra Electronics Automobile Parts - page 13

    NO TES ...

  • Metra Electronics Automobile Parts - page 14

    NO TES ...

  • Metra Electronics Automobile Parts - page 15

    NO TES ...

  • Metra Electronics Automobile Parts - page 16

    REV . 8/22/1 1 1-800-221-0932 axxessinterf ace.com © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORA TION INST ALLA TION INSTRUCTIONS FOR PART ASWCST ALK K NO WLEDGE IS P OW ER E nhance your installation and fabrication skills by enrolling in the most re cognized and re spected mobile electronics school in our industry . Log onto www .installerinsti ...

Fabbricante Metra Electronics Categoria Automobile Parts

I documenti che otteniamo dal fabbricante del dispositivoMetra Electronics Automobile Parts possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Metra Electronics
- manuali per l’uso Automobile Parts
- schede prodotto Metra Electronics
- opuscoli
- o etichette energetiche Metra Electronics Automobile Parts
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Metra Electronics Automobile Parts.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Metra Electronics Automobile Parts, manuali di manutenzione, brevi manuali o manuali utente Metra Electronics Automobile Parts. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Metra Electronics Automobile Parts.

Manuale completo del dispositivo Metra Electronics Automobile Parts, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Metra Electronics Automobile Parts dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Metra Electronics Automobile Parts.

Il manuale per l’uso completo Metra Electronics, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Metra Electronics Automobile Parts - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Metra Electronics Automobile Parts, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Metra Electronics Automobile Parts che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Metra Electronics Automobile Parts - che ci dovrebbe aiutare nei primi passi durante l'uso Metra Electronics Automobile Parts
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Metra Electronics Automobile Parts
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Metra Electronics Automobile Parts in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Metra Electronics Automobile Parts?

Utilizza il modulo sottostante

Se non hai risolto il problema con Metra Electronics Automobile Parts con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Metra Electronics Automobile Parts è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)