Français dropdown-ico

Manuel d’utilisation Orange Micro The Grappler

19 pages 0.16 mb
Télécharger

Aller à la page of 19

Summary
  • Orange Micro The Grappler - page 1

    ...

  • Orange Micro The Grappler - page 2

    INTRODUCTION TM The Grappler Interface is a Centronics compatible parallel interface for the Apple II/II+ Computer. In addition to advanced text features, it offers high resolution dot graphics (HIRES) dump routines located in firmware. These are easily invoked using simple control commands. There is no standardization among printer manufacturers f ...

  • Orange Micro The Grappler - page 3

    5. Be sure the power is off. Insert the Grappler card into slot #1 (or any other slot except zero) with a gentle rocking motion until fully seated. 6. Pass the cable through one of the vertical openings in the back of the Apple case. 7. Replace the Apple’s cover. Slide the front edge of the cover into place, and then press down on the rear corner ...

  • Orange Micro The Grappler - page 4

    To type a control character, hold down the control key (marked “CTRL’ on the Apple) and then press the appropriate letter. Then release the letter key, and then the control key. Control characters do not appear on the screen as they are typed. You may also use the CHR$ function found in Applesoft Basic (consult your Apple manual and Appendix A) ...

  • Orange Micro The Grappler - page 5

    CTRL-I X Don’t output the high order bit to the printer. This puts the printer back in standard text mode. CTRL-InN Set line length to n characters from left side of page (not from left margin). After issuing this command, characters will only be printed on the printer, and not on the Apple video screen. A carriage return will automatically be ge ...

  • Orange Micro The Grappler - page 6

    lines per page (this may vary with the type of printer). Therefore if you specify a printed page length of 6Ø lines (CTRL—I 6ØP), your printer will print 6Ø lines and automatically skip over the perforation with 6 line feeds. CTRL—I B Turn on bell. This allows a CTRL—G to ring the printer bell. Many printers do not have a bell so check you ...

  • Orange Micro The Grappler - page 7

    GRAPHICS FEATURES AND COMMANDS The Grappler Interface can output the HIRES screen to the printer by using simple commands. All graphics commands consist of the command character (usually CTRL—I) followed by a “G", and any options described below. If no other options are used (i.e. CTRL—I G [carriage return]), HIRES page 1 will be printed ...

  • Orange Micro The Grappler - page 8

    R — Rotate the picture 90 degrees in a clockwise direction. Some printers require this option when printing the image double- size. (See D above.) An example of a graphics command would be CTRL-I GDIR2 followed with a carriage return. This will print the inverse of HIRES page 2, double size, rotated 90 degrees. Options may be listed in any order, ...

  • Orange Micro The Grappler - page 9

    PASCAL AND CP/M COMPATIBILITY The Grappler is compatible with both PASCAL and CP/M. PASCAL l.Ø and CP/M will both recognize the card as a serial interface. Entry points have been provided to mimic a serial interface so that the card will function properly with these systems. PASCAL 1.1 will correctly interpret that it is a firm- ware printer inter ...

  • Orange Micro The Grappler - page 10

    FOR ADVANCED PROGRAMMERS: MEMORY LOCATIONS USED BY THE GRAPPLER The Grappler Interface uses those RAM locations set aside for its particular slot and the slot scratchpad area common to all slots. The ROM is turned on using the standard ROM expansion protocol and resides in locations $C8ØØ to $CFFF. The entry points and the various RAM variables a ...

  • Orange Micro The Grappler - page 11

    CUSTOM DRIVERS If you are writing your own drivers the following locations are used to access the card CY = NO where N = slot#) Printer Status — $CØSl,Y (READ) Output Latch - $CØ8l,Y (WRITE) Strobe Low — $CØ82,Y (WRITE) Strobe High — $CØ84,Y (WRITE) The following routine gives an example of how to output a character using these locations: ...

  • Orange Micro The Grappler - page 12

    APPENDIX A TM USING GRAPPLER CONMANDS WITHIN A PROGRAM The following table illustrates how a few Grappler commands would be used within a program: INTEGER BASIC DESCRIPTION TM 1Ø PRINT “CTRL-D”;”PR#l” 10 PRINT CHR$(4);”PR#l" Turns on Grappler If you are not using DOS (disk operating SYSTEM) thEn enter the line as: 1Ø PR#1 2Ø PRINT ...

  • Orange Micro The Grappler - page 13

    The following prograas allow you to rest the graphics capability of the Grappler. For Applesoft basic users: 5 TEXT 1Ø HOME 2Ø PRINT ‘ENTER THE SLOT YOUR GRAPPLER IS IN AND” 3Ø INPUT “HIT THE RETURN KEY: “:S 5Ø HGR 6Ø HCOLOR=3 7Ø POKE 49234,!6 6Ø HPLOT Ø,Ø TO 279,Ø TO 279,19Ø TO Ø,19Ø TO Ø,Ø 9Ø FOR X=Ø TO 279 STEP 9: HPLOT ...

  • Orange Micro The Grappler - page 14

    For Pascal Users: PROGRAM DEMO, USES TURTLEGRAPHICS, APPLESTUFF, VAR ANGLE, DISTANCE: INTEGER; PRINT, TEXT, BEGIN ANGLE;8-Ø; INITTURTLE; PNNCOLOR(NHITE); FOR DISTANCE:= TO 99 DO BEGIN MOVE (2*DISTAMCE); TURN ANGLE); END, REWRITE (PRINT,’PRINTER;"), NRITELN (PRINT,CHR(25),G');(*USE CHR(25) [CTPL—Y]IN PASCAL*); END. —13— ...

  • Orange Micro The Grappler - page 15

    The following program will allow you to print a graph that has been previously saved to the disk. For e,~as~ple, after saving the qreph created by one of the popular graphing programs for the Apple, run this program to print it on your printer. Note: If your Grappler is not in slot #1 change line 5 so that S equals the clot number of your Grappler. ...

  • Orange Micro The Grappler - page 16

    APPENDIX B DIP SWITCH SETTINGS FOR YOUR PRINTER All printers must configure to a Centronics type psrallel interface. ANADEX 95ØØ — 93Ø1 All switches on S—3 must be off. Set switches on S-1 snd S—2 appropriately. CENTRONICS 739—1 All four switches oust be off. EPSON MX-7Ø Shorting plug must be hooked up to the red post for no auto—line ...

  • Orange Micro The Grappler - page 17

    TM GRAPPLER PIN ASSIGNMENTS Normal IDS Function GRAPPLER GRAPPLER* -- STE 1 5 3 2 Dl 5 25 D2 7 23 D3 9 21 D4 11 19 D5 13 17 D6 15 4 D7 17 -- -- ACK 19 18 BUSY 21 12 -- P.E. 23 22,26 SLCT 25 7 N/C -- 10,20 GND all others all others *GRAPPLERs designed for use with IDS Paper Tiger printers may be identified by a white asterisk on the upper right hand ...

  • Orange Micro The Grappler - page 18

    ...

  • Orange Micro The Grappler - page 19

    LIMITED WARRANTY Every GRAPPLER INTERFACE is fully tested and quality checked before shipment and is warranted to be free from defects in materials and workmanship for a period of 90 days from date of purchase. During that time period. Orange Micro will, at no charge, repair or replace any defective unit returned to its Service Department in accord ...

Fabricant Orange Micro Catégorie Network Card

Les documents que nous recevons du fabricant de l'appareilOrange Micro The Grappler peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Orange Micro
- manuels d’utilisations The Grappler
- fiches produit Orange Micro
- dépliants
- ou étiquettes-énergie Orange Micro The Grappler
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Orange Micro The Grappler.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Orange Micro The Grappler, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Orange Micro The Grappler. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Orange Micro The Grappler.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Orange Micro The Grappler, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Orange Micro The Grappler par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Orange Micro The Grappler.

Le manuel d’utilisation complet Orange Micro, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Orange Micro The Grappler - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Orange Micro The Grappler, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lOrange Micro The Grappler qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Orange Micro The Grappler - qui devraient nous aider dans les premières étapes lors de l'utilisation Orange Micro The Grappler
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Orange Micro The Grappler
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Orange Micro The Grappler dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Orange Micro The Grappler?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Orange Micro The Grappler, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Orange Micro The Grappler il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)