Orange Micro The Grapplerの取扱説明書

19ページ 0.16 mb
ダウンロード

ページに移動 of 19

Summary
  • Orange Micro The Grappler - page 1

    ...

  • Orange Micro The Grappler - page 2

    INTRODUCTION TM The Grappler Interface is a Centronics compatible parallel interface for the Apple II/II+ Computer. In addition to advanced text features, it offers high resolution dot graphics (HIRES) dump routines located in firmware. These are easily invoked using simple control commands. There is no standardization among printer manufacturers f ...

  • Orange Micro The Grappler - page 3

    5. Be sure the power is off. Insert the Grappler card into slot #1 (or any other slot except zero) with a gentle rocking motion until fully seated. 6. Pass the cable through one of the vertical openings in the back of the Apple case. 7. Replace the Apple’s cover. Slide the front edge of the cover into place, and then press down on the rear corner ...

  • Orange Micro The Grappler - page 4

    To type a control character, hold down the control key (marked “CTRL’ on the Apple) and then press the appropriate letter. Then release the letter key, and then the control key. Control characters do not appear on the screen as they are typed. You may also use the CHR$ function found in Applesoft Basic (consult your Apple manual and Appendix A) ...

  • Orange Micro The Grappler - page 5

    CTRL-I X Don’t output the high order bit to the printer. This puts the printer back in standard text mode. CTRL-InN Set line length to n characters from left side of page (not from left margin). After issuing this command, characters will only be printed on the printer, and not on the Apple video screen. A carriage return will automatically be ge ...

  • Orange Micro The Grappler - page 6

    lines per page (this may vary with the type of printer). Therefore if you specify a printed page length of 6Ø lines (CTRL—I 6ØP), your printer will print 6Ø lines and automatically skip over the perforation with 6 line feeds. CTRL—I B Turn on bell. This allows a CTRL—G to ring the printer bell. Many printers do not have a bell so check you ...

  • Orange Micro The Grappler - page 7

    GRAPHICS FEATURES AND COMMANDS The Grappler Interface can output the HIRES screen to the printer by using simple commands. All graphics commands consist of the command character (usually CTRL—I) followed by a “G", and any options described below. If no other options are used (i.e. CTRL—I G [carriage return]), HIRES page 1 will be printed ...

  • Orange Micro The Grappler - page 8

    R — Rotate the picture 90 degrees in a clockwise direction. Some printers require this option when printing the image double- size. (See D above.) An example of a graphics command would be CTRL-I GDIR2 followed with a carriage return. This will print the inverse of HIRES page 2, double size, rotated 90 degrees. Options may be listed in any order, ...

  • Orange Micro The Grappler - page 9

    PASCAL AND CP/M COMPATIBILITY The Grappler is compatible with both PASCAL and CP/M. PASCAL l.Ø and CP/M will both recognize the card as a serial interface. Entry points have been provided to mimic a serial interface so that the card will function properly with these systems. PASCAL 1.1 will correctly interpret that it is a firm- ware printer inter ...

  • Orange Micro The Grappler - page 10

    FOR ADVANCED PROGRAMMERS: MEMORY LOCATIONS USED BY THE GRAPPLER The Grappler Interface uses those RAM locations set aside for its particular slot and the slot scratchpad area common to all slots. The ROM is turned on using the standard ROM expansion protocol and resides in locations $C8ØØ to $CFFF. The entry points and the various RAM variables a ...

  • Orange Micro The Grappler - page 11

    CUSTOM DRIVERS If you are writing your own drivers the following locations are used to access the card CY = NO where N = slot#) Printer Status — $CØSl,Y (READ) Output Latch - $CØ8l,Y (WRITE) Strobe Low — $CØ82,Y (WRITE) Strobe High — $CØ84,Y (WRITE) The following routine gives an example of how to output a character using these locations: ...

  • Orange Micro The Grappler - page 12

    APPENDIX A TM USING GRAPPLER CONMANDS WITHIN A PROGRAM The following table illustrates how a few Grappler commands would be used within a program: INTEGER BASIC DESCRIPTION TM 1Ø PRINT “CTRL-D”;”PR#l” 10 PRINT CHR$(4);”PR#l" Turns on Grappler If you are not using DOS (disk operating SYSTEM) thEn enter the line as: 1Ø PR#1 2Ø PRINT ...

  • Orange Micro The Grappler - page 13

    The following prograas allow you to rest the graphics capability of the Grappler. For Applesoft basic users: 5 TEXT 1Ø HOME 2Ø PRINT ‘ENTER THE SLOT YOUR GRAPPLER IS IN AND” 3Ø INPUT “HIT THE RETURN KEY: “:S 5Ø HGR 6Ø HCOLOR=3 7Ø POKE 49234,!6 6Ø HPLOT Ø,Ø TO 279,Ø TO 279,19Ø TO Ø,19Ø TO Ø,Ø 9Ø FOR X=Ø TO 279 STEP 9: HPLOT ...

  • Orange Micro The Grappler - page 14

    For Pascal Users: PROGRAM DEMO, USES TURTLEGRAPHICS, APPLESTUFF, VAR ANGLE, DISTANCE: INTEGER; PRINT, TEXT, BEGIN ANGLE;8-Ø; INITTURTLE; PNNCOLOR(NHITE); FOR DISTANCE:= TO 99 DO BEGIN MOVE (2*DISTAMCE); TURN ANGLE); END, REWRITE (PRINT,’PRINTER;"), NRITELN (PRINT,CHR(25),G');(*USE CHR(25) [CTPL—Y]IN PASCAL*); END. —13— ...

  • Orange Micro The Grappler - page 15

    The following program will allow you to print a graph that has been previously saved to the disk. For e,~as~ple, after saving the qreph created by one of the popular graphing programs for the Apple, run this program to print it on your printer. Note: If your Grappler is not in slot #1 change line 5 so that S equals the clot number of your Grappler. ...

  • Orange Micro The Grappler - page 16

    APPENDIX B DIP SWITCH SETTINGS FOR YOUR PRINTER All printers must configure to a Centronics type psrallel interface. ANADEX 95ØØ — 93Ø1 All switches on S—3 must be off. Set switches on S-1 snd S—2 appropriately. CENTRONICS 739—1 All four switches oust be off. EPSON MX-7Ø Shorting plug must be hooked up to the red post for no auto—line ...

  • Orange Micro The Grappler - page 17

    TM GRAPPLER PIN ASSIGNMENTS Normal IDS Function GRAPPLER GRAPPLER* -- STE 1 5 3 2 Dl 5 25 D2 7 23 D3 9 21 D4 11 19 D5 13 17 D6 15 4 D7 17 -- -- ACK 19 18 BUSY 21 12 -- P.E. 23 22,26 SLCT 25 7 N/C -- 10,20 GND all others all others *GRAPPLERs designed for use with IDS Paper Tiger printers may be identified by a white asterisk on the upper right hand ...

  • Orange Micro The Grappler - page 18

    ...

  • Orange Micro The Grappler - page 19

    LIMITED WARRANTY Every GRAPPLER INTERFACE is fully tested and quality checked before shipment and is warranted to be free from defects in materials and workmanship for a period of 90 days from date of purchase. During that time period. Orange Micro will, at no charge, repair or replace any defective unit returned to its Service Department in accord ...

メーカー Orange Micro カテゴリー Network Card

Orange Micro The Grapplerのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- The Grapplerの取扱説明書
- Orange Microの製品カード
- パンフレット
- またはOrange Micro The Grapplerの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Orange Micro The Grapplerの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Orange Micro The Grapplerの取り付け説明書、サービスマニュアル、簡易説明書、またはOrange Micro The Grapplerのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Orange Micro The Grapplerの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Orange Micro The Grapplerデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがOrange Micro The Grapplerを使用するのを助ける技術的文書のことです。説明書は通常、全てのOrange Micro The Grapplerユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Orange Microの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Orange Micro The Grapplerの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははOrange Micro The Grapplerの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Orange Micro The Grapplerに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Orange Micro The Grapplerデバイスの基本機能を使うにあたってのヒント。 Orange Micro The Grapplerのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Orange Micro The Grapplerに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるOrange Micro The Grapplerのメーカー/サービスへの連絡先に関する情報。

Orange Micro The Grapplerについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもOrange Micro The Grapplerの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがOrange Micro The Grapplerで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)