Manuel d’utilisation ADIC FastStor

15 pages 0.31 mb
Télécharger

Aller à la page of 15

Summary
  • ADIC FastStor - page 1

    FastStor ® 1 Quick Installation Guide Advanced Digital Information Corporation ...

  • ADIC FastStor - page 2

    Copyright © 2005 ADIC The information contained in this document is subject to change without notice. This document contains proprietary informati on which is protected by copyright. All rights are reserved. No part of this document may be reproduced, modified, distributed, or translated to another language without prior written consent of ADIC. A ...

  • ADIC FastStor - page 3

    FastStor 1 Quick Installation Guide i Table of Contents Introducti on ...................................................................................... 1 Step 1. Unpacking the FastStor 1 .................................................... 2 Step 2. Installing the Fa stStor 1 in a Rack ....................................... 2 Step 3. Connecti ...

  • ADIC FastStor - page 4

    Advanced Digital Information Corporation FastStor 1 ii FastStor 1 Quick Installation Guide ...

  • ADIC FastStor - page 5

    FastStor 1 Quick Installation Guide 1 Introduction This guide is designed to enable quick installation of the ADIC FastStor 1 autoloader. For additional product and operation details, please refer to the ADIC FastStor 1 Installation and User Manual. The following steps summarize FastStor 1 installation: • Unpack the FastStor 1 • Install the Fas ...

  • ADIC FastStor - page 6

    Advanced Digital Information Corporation FastStor 1 2 FastStor 1 Quick Installation Guide Front Panel of the FastStor 1 Magazine front bezel LED indicators Standby switch LCD display Control buttons Magazine front bezel Figure 1. The FastStor 1's front side Step 1. Unpacking the FastStor 1 Carefully unpack the unit from the shipping container. ...

  • ADIC FastStor - page 7

    FastStor 1 Quick Installation Guide 3 Attention: The FastStor 1 is designed to operate in a horizontal position. Do not attempt to operate the FastStor 1 in any position other than horizontally. Also make sure that: • The airflow around the front and back of the FastStor 1 is not obstructed. • There is a minimum of 60cm free space in front of t ...

  • ADIC FastStor - page 8

    Advanced Digital Information Corporation FastStor 1 4 FastStor 1 Quick Installation Guide Figure 2. Rack Mounting kit Installing the Rack Mounting Kit • Determine the proper position of the rails in the rack. Caution: Consider rack stability when deciding where to place the FastStor 1. Hazardous conditions can result from uneven mechanical rack l ...

  • ADIC FastStor - page 9

    FastStor 1 Quick Installation Guide 5 Installing the “Rail Left Assembly” 1. Measure the length between the rear rack mount rails and the front rack mount rails. If the measurement is shorter than the FastStor 1, move the two sets of screws M4x12, washers and nuts shown in Figure 4. 2. Adjust the “Rail Left Assembly” to fit the measurement ...

  • ADIC FastStor - page 10

    Advanced Digital Information Corporation FastStor 1 6 FastStor 1 Quick Installation Guide Figure 5 shows step 5 in the description: Rack mounting kit mounted in rack with one screw M6x12 in upper hole on both left and right sides. On the rear side, two screws must be used on both left and right sides. A total of six screws are used to install the r ...

  • ADIC FastStor - page 11

    FastStor 1 Quick Installation Guide 7 Figure 8. Fasten the rear of the FastStor 1 to the rails. Step 3. Connecting Power Cable Before connecting the FastStor 1 to your host computer system, you should run the unit’s self-diagnostic test. (This preparation requires power to the FastStor 1.) Follow these steps to perform this test: 1. Use the power ...

  • ADIC FastStor - page 12

    Advanced Digital Information Corporation FastStor 1 8 FastStor 1 Quick Installation Guide Step 4. Removing the Transport Lock The robot mechanism is protected from damage during shipment by a screw holding the robotics in a locked position. This locking screw is marked with a red plastic tab protruding between the right magazine and the front panel ...

  • ADIC FastStor - page 13

    FastStor 1 Quick Installation Guide 9 Step 6. Setting the SCSI Address There is a LCD display on the front panel, and four control buttons. After the Power- on sequence is finished, select Menu and scroll down until you can select Setup. Then scroll down until the display looks like the figure below, and select SCSI setup. ▲ Exit SCSI setup ▼ S ...

  • ADIC FastStor - page 14

    Advanced Digital Information Corporation FastStor 1 10 FastStor 1 Quick Installation Guide 1. Add the length of all external and internal SCSI cables on the bus 2. Add 80 cm (31.5 inches) for the internal cable length in the FastStor 1. 3. If the number of SCSI devices exceeds two, the maximum allowed length of an LVD SCSI bus is 12 m (39 ft). 4. F ...

  • ADIC FastStor - page 15

    FastStor 1 Quick Installation Guide 11 Step 8. Connecting the Ethernet Connector To connect the FastStor 1 to the Ethernet port, use the provided cable from the accessory kit box. 1. Insert one end of the cable into the FastStor 1 Ethernet port. Push until it snaps into place. (The open port shown in Figure 11 is for Ethernet connection.) 2. Connec ...

Fabricant ADIC Catégorie Computer Drive

Les documents que nous recevons du fabricant de l'appareilADIC FastStor peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques ADIC
- manuels d’utilisations FastStor
- fiches produit ADIC
- dépliants
- ou étiquettes-énergie ADIC FastStor
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation ADIC FastStor.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation ADIC FastStor, manuels d’entretien, brefs manuels ou manuels de l’utilisateur ADIC FastStor. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit ADIC FastStor.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil ADIC FastStor, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser ADIC FastStor par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs ADIC FastStor.

Le manuel d’utilisation complet ADIC, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel ADIC FastStor - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières ADIC FastStor, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lADIC FastStor qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil ADIC FastStor - qui devraient nous aider dans les premières étapes lors de l'utilisation ADIC FastStor
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de ADIC FastStor
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service ADIC FastStor dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de ADIC FastStor?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec ADIC FastStor, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec ADIC FastStor il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)