Manuel d’utilisation Auto Page RF-350

16 pages 0.3 mb
Télécharger

Aller à la page of 16

Summary
  • Auto Page RF-350 - page 1

    1 RF - 350 PROFESSIONAL VEHICLE SECURITY SYSTEM WITH KEYLESS ENTRY INSTALLATION & USERS MANUAL (For Authorized Dealers Only) Please register your product at www.autopageusa.com THIS PRODUCT IS DES IGNED FOR PROFESSIONAL INSTALLATION ONLY ...

  • Auto Page RF-350 - page 2

    2 WIR ING DIAGRAM ...

  • Auto Page RF-350 - page 3

    3 (RELAY REQUIRED) 8. GRAY ...2ND CHANNEL OUTPUT 2. WHITE ...DOME LIGHT / 3RD CHANNEL OUTPUT 7. ORANGE ...STARTER INTERUPT OUTPUT (RELAY REQUIRED) 5. GREEN ...NEGATIVE DOOR TRIGGER (-) INPUT 6. YELLOW ...IGNITION INPUT 3. VIOLET ...POSITIVE DOOR TRIGGER (+) INPUT 1. BROWN/WHITE ...(-) HORN OUTPUT 4. BLUE ...NEGATIVE INSTANT (-) INPUT H1: MAIN 5 PIN ...

  • Auto Page RF-350 - page 4

    4 VACUUM OPERATED CENTRAL LOCKING Green Wire Blue Wire +12V X Cut Compressor Door Switch 30 86 87a 85 87 30 86 87a 85 87 3 Pin Plug To Alarm VACUUM OPERATED DOOR LOCKING SYSTEM: TYPICAL OF MERCEDES BENZ AND AUDI. Locate the wire under the driver's kick panel. Use the voltmeter connecting to ground, verify that you have the correct wire with th ...

  • Auto Page RF-350 - page 5

    5 2 STEP DOOR UNLOCK WIRE CONNECTION FOR POSITIVE SWITCHED DOOR LOCKS Cut Existing Unlock X Lock Unlock OEM Door Master Lock Switch To All Other Door Lock Motors 8 - Pin Plug From Alarm H2/ 8 Gray Wire OEM Driver's Door Lock Motor + 12V Existing Pos. Lock Wire Existing Pos. Unlock Wire 30 87A 87 86 85 +12V + 12V OEM Door Lock Relay 86 30 85 87 ...

  • Auto Page RF-350 - page 6

    6 Note: If more than 4 transmitters are programmed, the system will only keep the last 4 transmitters and delete the others. ALARM FEATURE “ A ” PROGRAMMING: 1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position. 2. Push the Valet switch 3 times and hold in on the 3 rd push . When a long chirp is heard, release the val ...

  • Auto Page RF-350 - page 7

    7 ALARM FEATURE “ B ” PROGRAMMING: 1 Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position. 2 Push the Valet switch 5 times and hold in on the 5 th push. When a long chirp is heard, release the valet swit ch. You are now in the Alarm feature ‘B ’ programming mode. 3 Press the transmitter button corresponding to the fe ...

  • Auto Page RF-350 - page 8

    8 ALARM FEATURE “ C ” PROGRAMMING: 1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIME S and stay in OFF position. 2. Push the Valet switch 7 times and hold on the 7 th push until Three chirps with a long chirp is heard then release the valet switch. You are now in the Alarm feature ‘C’ programming mode. 3. Press and hold the transmitter ...

  • Auto Page RF-350 - page 9

    9 O peration Manual TRANSMITTER OPERATION: Transmitter Button System Function Remark Lock Doors & Arm System Panic function Press and Hold for 3 seconds Car Locator Under armed mode - Arm and Delete The 2 Stage Shock Sensor Press twice wit hin 3 seconds + Silent Arming / Disarming Ignition in "off" position. Unlock Doors & Disarm ...

  • Auto Page RF-350 - page 10

    10 / hood / trunk, the security system LED will stop flashing. It will b egin flashing again once all vehicle entrances are closed. 2. After 30 - second timer has elapsed, the security system will automatically “ARM”. The siren will chirp [1] time and the parking lights will flash [1] time. PASSIVE DOOR LOCKING: The vehicle doors will automatic ...

  • Auto Page RF-350 - page 11

    11 ANTI CAR - JACKING: ( OPTIONAL) If alarm option is installed. Warning: If you don't need the carjacking function in this alarm system, be sure to set carjacking feature “OFF”. This system is default setting Car - jacking “OFF”. 1. TRANSMITTER ACTIVATE THE CAR JACKING: Press and hold + button on the transmitter for 1 second while the ...

  • Auto Page RF-350 - page 12

    12 TRUNK RELEASE. Press and hold button on transmitter for two seconds to remote control the trunk release or other electric device s. CAR LOCATOR Press the button on the transmitter to active car locator function. The siren will chirp 6 times. The parking light will flash 12 times, allowing you to easily locate your car. P. PATHWAY ILLUMINAT ION W ...

  • Auto Page RF-350 - page 13

    13 CHANGING THE BATTERY IN YOUR TRANSMITTERS XT - 33: The XT - 33 transmitter uses two (2) 3 - volt lithium ion batteries (#CR2016) that are sandwiched together wit h the (+) side facing upward. To replace the battery, you will need to use a small flat blade screwdriver. Locate the small notch on the lower right side of the transmitter case next to ...

  • Auto Page RF-350 - page 14

    14 LIMITED LIFETIME WARRANTY PROVISIONS ( U.S. ,Continental U.S. and Canada Only) 1. Auto Page, Inc. WARRANTS that this new unit has been thoroughly inspected and tested at the factory prior to delivery. Your Auto Page equipment is guaranteed for “life” to the original purchaser/user of the equipment and the original vehicle in which it was ins ...

  • Auto Page RF-350 - page 15

    15 You must register your product online at http://www.autopageu sa.com to receive any warranty service. Please go to the customer service tab and select product registration. It is the purchaser’s responsibility to register this product for any future warranty service. Warning: Some batteries may contain Perchlorate What is Perchlorate? Perchlor ...

  • Auto Page RF-350 - page 16

    16 960 Knox Stre et Unit B, Torrance, CA 90502 Tel: (310) 323 - 1800 or (800) 262 - 2527 www.autopageusa.com Technical Support: 800 - 945 - 2527 (For Authorized Dealers Only) ...

Fabricant Auto Page Catégorie Automobile Alarm

Les documents que nous recevons du fabricant de l'appareilAuto Page RF-350 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Auto Page
- manuels d’utilisations RF-350
- fiches produit Auto Page
- dépliants
- ou étiquettes-énergie Auto Page RF-350
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Auto Page RF-350.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Auto Page RF-350, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Auto Page RF-350. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Auto Page RF-350.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Auto Page RF-350, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Auto Page RF-350 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Auto Page RF-350.

Le manuel d’utilisation complet Auto Page, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Auto Page RF-350 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Auto Page RF-350, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lAuto Page RF-350 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Auto Page RF-350 - qui devraient nous aider dans les premières étapes lors de l'utilisation Auto Page RF-350
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Auto Page RF-350
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Auto Page RF-350 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Auto Page RF-350?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Auto Page RF-350, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Auto Page RF-350 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (1)

Roland Baumgartner

Sehr geehrte Damen und Herren, Bei meinen ausdrucken von meinem Gerät: aficio sp c 220n bekomme ich immer feine Farb-Streifen bei jedem Ausdruck. An den Tonern liegt es nicht! Diese habe ich alle bereits gewechselt. Welches Modul ist dafür verantwortlich? Herzlichen Dank schon mal für Ihr Bemühen und Ihre Hilfe mfg Roland Baumgartner