English dropdown-ico

Manual Auto Page RF-350

16 pages 0.3 mb
Download

Go to site of 16

Summary
  • Auto Page RF-350 - page 1

    1 RF - 350 PROFESSIONAL VEHICLE SECURITY SYSTEM WITH KEYLESS ENTRY INSTALLATION & USERS MANUAL (For Authorized Dealers Only) Please register your product at www.autopageusa.com THIS PRODUCT IS DES IGNED FOR PROFESSIONAL INSTALLATION ONLY ...

  • Auto Page RF-350 - page 2

    2 WIR ING DIAGRAM ...

  • Auto Page RF-350 - page 3

    3 (RELAY REQUIRED) 8. GRAY ...2ND CHANNEL OUTPUT 2. WHITE ...DOME LIGHT / 3RD CHANNEL OUTPUT 7. ORANGE ...STARTER INTERUPT OUTPUT (RELAY REQUIRED) 5. GREEN ...NEGATIVE DOOR TRIGGER (-) INPUT 6. YELLOW ...IGNITION INPUT 3. VIOLET ...POSITIVE DOOR TRIGGER (+) INPUT 1. BROWN/WHITE ...(-) HORN OUTPUT 4. BLUE ...NEGATIVE INSTANT (-) INPUT H1: MAIN 5 PIN ...

  • Auto Page RF-350 - page 4

    4 VACUUM OPERATED CENTRAL LOCKING Green Wire Blue Wire +12V X Cut Compressor Door Switch 30 86 87a 85 87 30 86 87a 85 87 3 Pin Plug To Alarm VACUUM OPERATED DOOR LOCKING SYSTEM: TYPICAL OF MERCEDES BENZ AND AUDI. Locate the wire under the driver's kick panel. Use the voltmeter connecting to ground, verify that you have the correct wire with th ...

  • Auto Page RF-350 - page 5

    5 2 STEP DOOR UNLOCK WIRE CONNECTION FOR POSITIVE SWITCHED DOOR LOCKS Cut Existing Unlock X Lock Unlock OEM Door Master Lock Switch To All Other Door Lock Motors 8 - Pin Plug From Alarm H2/ 8 Gray Wire OEM Driver's Door Lock Motor + 12V Existing Pos. Lock Wire Existing Pos. Unlock Wire 30 87A 87 86 85 +12V + 12V OEM Door Lock Relay 86 30 85 87 ...

  • Auto Page RF-350 - page 6

    6 Note: If more than 4 transmitters are programmed, the system will only keep the last 4 transmitters and delete the others. ALARM FEATURE “ A ” PROGRAMMING: 1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position. 2. Push the Valet switch 3 times and hold in on the 3 rd push . When a long chirp is heard, release the val ...

  • Auto Page RF-350 - page 7

    7 ALARM FEATURE “ B ” PROGRAMMING: 1 Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position. 2 Push the Valet switch 5 times and hold in on the 5 th push. When a long chirp is heard, release the valet swit ch. You are now in the Alarm feature ‘B ’ programming mode. 3 Press the transmitter button corresponding to the fe ...

  • Auto Page RF-350 - page 8

    8 ALARM FEATURE “ C ” PROGRAMMING: 1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIME S and stay in OFF position. 2. Push the Valet switch 7 times and hold on the 7 th push until Three chirps with a long chirp is heard then release the valet switch. You are now in the Alarm feature ‘C’ programming mode. 3. Press and hold the transmitter ...

  • Auto Page RF-350 - page 9

    9 O peration Manual TRANSMITTER OPERATION: Transmitter Button System Function Remark Lock Doors & Arm System Panic function Press and Hold for 3 seconds Car Locator Under armed mode - Arm and Delete The 2 Stage Shock Sensor Press twice wit hin 3 seconds + Silent Arming / Disarming Ignition in "off" position. Unlock Doors & Disarm ...

  • Auto Page RF-350 - page 10

    10 / hood / trunk, the security system LED will stop flashing. It will b egin flashing again once all vehicle entrances are closed. 2. After 30 - second timer has elapsed, the security system will automatically “ARM”. The siren will chirp [1] time and the parking lights will flash [1] time. PASSIVE DOOR LOCKING: The vehicle doors will automatic ...

  • Auto Page RF-350 - page 11

    11 ANTI CAR - JACKING: ( OPTIONAL) If alarm option is installed. Warning: If you don't need the carjacking function in this alarm system, be sure to set carjacking feature “OFF”. This system is default setting Car - jacking “OFF”. 1. TRANSMITTER ACTIVATE THE CAR JACKING: Press and hold + button on the transmitter for 1 second while the ...

  • Auto Page RF-350 - page 12

    12 TRUNK RELEASE. Press and hold button on transmitter for two seconds to remote control the trunk release or other electric device s. CAR LOCATOR Press the button on the transmitter to active car locator function. The siren will chirp 6 times. The parking light will flash 12 times, allowing you to easily locate your car. P. PATHWAY ILLUMINAT ION W ...

  • Auto Page RF-350 - page 13

    13 CHANGING THE BATTERY IN YOUR TRANSMITTERS XT - 33: The XT - 33 transmitter uses two (2) 3 - volt lithium ion batteries (#CR2016) that are sandwiched together wit h the (+) side facing upward. To replace the battery, you will need to use a small flat blade screwdriver. Locate the small notch on the lower right side of the transmitter case next to ...

  • Auto Page RF-350 - page 14

    14 LIMITED LIFETIME WARRANTY PROVISIONS ( U.S. ,Continental U.S. and Canada Only) 1. Auto Page, Inc. WARRANTS that this new unit has been thoroughly inspected and tested at the factory prior to delivery. Your Auto Page equipment is guaranteed for “life” to the original purchaser/user of the equipment and the original vehicle in which it was ins ...

  • Auto Page RF-350 - page 15

    15 You must register your product online at http://www.autopageu sa.com to receive any warranty service. Please go to the customer service tab and select product registration. It is the purchaser’s responsibility to register this product for any future warranty service. Warning: Some batteries may contain Perchlorate What is Perchlorate? Perchlor ...

  • Auto Page RF-350 - page 16

    16 960 Knox Stre et Unit B, Torrance, CA 90502 Tel: (310) 323 - 1800 or (800) 262 - 2527 www.autopageusa.com Technical Support: 800 - 945 - 2527 (For Authorized Dealers Only) ...

Manufacturer Auto Page Category Automobile Alarm

Documents that we receive from a manufacturer of a Auto Page RF-350 can be divided into several groups. They are, among others:
- Auto Page technical drawings
- RF-350 manuals
- Auto Page product data sheets
- information booklets
- or energy labels Auto Page RF-350
All of them are important, but the most important information from the point of view of use of the device are in the user manual Auto Page RF-350.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Auto Page RF-350, service manual, brief instructions and user manuals Auto Page RF-350. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Auto Page RF-350.

Similar manuals

A complete manual for the device Auto Page RF-350, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Auto Page RF-350 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Auto Page RF-350.

A complete Auto Page manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Auto Page RF-350 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Auto Page RF-350, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Auto Page RF-350, that we can find in the current document
3. Tips how to use the basic functions of the device Auto Page RF-350 - which should help us in our first steps of using Auto Page RF-350
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Auto Page RF-350
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Auto Page RF-350 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Auto Page RF-350?

Use the form below

If you did not solve your problem by using a manual Auto Page RF-350, ask a question using the form below. If a user had a similar problem with Auto Page RF-350 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (1)

Roland Baumgartner

Sehr geehrte Damen und Herren, Bei meinen ausdrucken von meinem Gerät: aficio sp c 220n bekomme ich immer feine Farb-Streifen bei jedem Ausdruck. An den Tonern liegt es nicht! Diese habe ich alle bereits gewechselt. Welches Modul ist dafür verantwortlich? Herzlichen Dank schon mal für Ihr Bemühen und Ihre Hilfe mfg Roland Baumgartner