Manuale per l’uso Taylor 371

16 pagine 1.56 mb
Scarica

Vai alla pagina of 16

Summary
  • Taylor 371 - page 1

    OPERA T OR’S MANUAL Granit a Merchandising Freezers Model 369 (FBM 1P) Model 370 (FBM 2) Model 371 (FBM 3) ROCKTON, ILLINOIS 61072 ...

  • Taylor 371 - page 2

    Complete this page for quick re ference when service is required: Taylor Distributor: __________________________________________________________ Address:_________________________________________________________________ Phone:____________________________________________________ _______ ________ Service:_______________________________________________ ...

  • Taylor 371 - page 3

    Models 369/370/371 3 ENGLISH Note: Continuing research results in st eady improve menets; there fore, information in this man ual is subject to change without notice. This dispenser is manufact ured under one or more of th e following U.S.patents and /or other pending patents : U.S.A. 4,900,158 U.S.A. 4,696,417 U.S.A. 5,713,214 U.S.A. 5,906,105 TAB ...

  • Taylor 371 - page 4

    4 Models 369/ 37 0 / 37 1 1 TECHNICAL CHARACTERISTICS The electric diagram o f the dispenser is located inside inner part o f the dispen sing side pa nel. Specifications are subject to cha nge without notice. 2 INTRODUCTION Please read all sections of this man ual thoroughly to fami liarize yourself with all aspects of the unit. Like all mechanical ...

  • Taylor 371 - page 5

    Models 369/370/371 5 ENGLISH 4 TO OPERATE SAFELY 1 - Do not opera te the dispenser without rea ding this operator’s manual. 2 - Do not operate the dispenser unless it is properly grounded. 3 - Do not use extensio n cords to connect the dispenser. 4 - Do not operate the dispenser un less all panels are restrained with screws. 5 - Do not obstruct a ...

  • Taylor 371 - page 6

    6 Models 369/ 37 0 / 37 1 Safety pressure swit ch warnin g light (C) To operate the unit: 1 - Set the power sw itch to I position. 2 - Set the mixer/refrigerat ion switches as follows: - to the I position to get soft drink. - to the II position to get Granita. 3 - Set the light swi tch to I positi on. 5. 2 OPERATION HELPFUL HINTS 1 - Gra nita visco ...

  • Taylor 371 - page 7

    Models 369/370/371 7 ENGLISH side up and off the hook located on th e opposite side (see figure 6). figure 6 3 - Remove the bowl by lifting its faucet side up and off the fastening hooks (see figure 7) and slide it out (see figure 8). figure 7 figure 8 4 - Slide th e outer spiral out (see figure 9) and the n the inside auger (see figure 10). figure ...

  • Taylor 371 - page 8

    8 Models 369/ 37 0 / 37 1 5 - Remove the bowl gasket from its seat (see figure 11). figure 11 6 - Dismantle the faucet assembly (see figure 12). figure 12 7 - Slide the drip tray out and empty it. 5. 3. 2 CLEANING 1 - Prepare at least two gallo ns of a mild cleaning solution of warm (45-60 °C / 120-14 0 °F) potable water and dishwashing detergent ...

  • Taylor 371 - page 9

    Models 369/370/371 9 ENGLISH (see figure 12) 4 - Fit bowl gasket around i ts seat. Note: the largest brim of g asket must face again st th e rear wall (see figure 14). figure 14 5 - Carefully in sert the auger into the evapora tor use caution to prevent it from h itting the rear wall (see figure 15). figure 15 6 - Install the outer spiral. Slide it ...

  • Taylor 371 - page 10

    10 Models 369/ 37 0 / 37 1 from the condenser filter. Remove the only left panel (fro m faucet side) unscrewing the two plastic coated screws (see figure 18). figure 18 3 - Replacement of lighted top co ver bulb: remove the scre w placed in the upper pa rt of the top cover, remove the lo wer part and replace the bulb (using a 24 -28V 21W max bu lb) ...

  • Taylor 371 - page 11

    Models 369/370/371 11 ENGLISH time of day with the arrow B o n the timer face. Th is is a 24 hour timer showing both A.M. and P.M. 2 - Program the defrost timer by pushing ou t on the tabs C that correspond to the hours desired to defrost. Each tab represents 15 minutes. A minimum of four to eight h ours are required to defrost frozen beverage (d e ...

  • Taylor 371 - page 12

    OPERATOR PARTS IDE NTIFICATION MODEL 369/370/371 2471_01 V 3.5 04I0 9 ...

  • Taylor 371 - page 13

    1 047634 Cover-Ho pper-Transparent 27 >>> Relay-Start (Compresso r) 57 046510 Knob-Temperature Control 2 046456 Hopper-10.7 Qt./10 Liter 28 >>> Overload protector 58 PPP Transformer-Light bulb 3 046457 Valve-Draw 29 >>> Capacitors 59 052212 Insulation-Flange-Foam 4 046458 O-Ring-Draw Valve 30 047405 Leg-4” 8MM Thread 60 ...

  • Taylor 371 - page 14

    GEAR MOTOR 052213-12 052213-27 052213-34 052213-44 Motor-Gear *369,370,371* GEN 3 (Magnetic Drive - BR 0067955/Up) Include: 1 052042 Bracket-Gear Motor w/Bushing 8 052047 Cap-Ball Bearing 19 052052 Gasket-Gear Motor 2 057900 Stator-Gear Motor (230V / 50Hz) 9 057878 O-Ring-Gearshaft 20 052053 Cover-Gear box 2 057901 Stator-Gear Motor (220V / 60Hz) 1 ...

  • Taylor 371 - page 15

    Models 369/370/371 15 IMPORTANT: The display light bulb must be replaced with the fact ory authorized replacement bulb. Failure to comply may result in component damag e or severe persona l injury du e to broken glass. Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY 1 - Product is too stiff. a - Improper mi xi ng of product. b - Mix low conditi ...

  • Taylor 371 - page 16

    046445-M 2471_01 R0.4 04I09 ...

Fabbricante Taylor Categoria Juicer

I documenti che otteniamo dal fabbricante del dispositivoTaylor 371 possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Taylor
- manuali per l’uso 371
- schede prodotto Taylor
- opuscoli
- o etichette energetiche Taylor 371
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Taylor 371.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Taylor 371, manuali di manutenzione, brevi manuali o manuali utente Taylor 371. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Taylor 371.

Manuali per l’uso simili

Manuale completo del dispositivo Taylor 371, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Taylor 371 dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Taylor 371.

Il manuale per l’uso completo Taylor, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Taylor 371 - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Taylor 371, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Taylor 371 che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Taylor 371 - che ci dovrebbe aiutare nei primi passi durante l'uso Taylor 371
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Taylor 371
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Taylor 371 in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Taylor 371?

Utilizza il modulo sottostante

Se non hai risolto il problema con Taylor 371 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Taylor 371 è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)