Italiano dropdown-ico

Manuale per l’uso Wayne-Dalton 9800

20 pagine 5.35 mb
Scarica

Vai alla pagina of 20

Summary
  • Wayne-Dalton 9800 - page 1

    IMPORT ANT NO TICES! The complete Installation Instructions and Owner’ s Manual are available at no charge from: Wayne-Dalton, a Division Of Overhead Door Corporation, P .O. Box 67, Mt. Hope, OH., 44660, Or Online At www.W ayne-Dalton.com Wayne-Dalton highly recommends that you read and fully understand the Installation Instructions and Owner’ ...

  • Wayne-Dalton 9800 - page 2

    Important Safety Instructions DEFINITION OF KEY WORDS USED IN THIS MANUAL: W ARNING W ARNING INDICA TES A POTENTIALL Y HAZARDOUS SITUA TION WHICH; IF NOT AVOIDED , COULD RESUL T IN SEVERE OR FA T AL INJURY . CAUTION: PROPER TY DAMAGE OR INJURY CAN RESUL T FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORT ANT : REQUIRED STEP FOR SAFE AND PROPER DOOR OPERA ...

  • Wayne-Dalton 9800 - page 3

    3/8”- 16 Hex nuts (as required) 1/4”- 20 Flanged hex nuts (as required) (2) 5/16” Washers 5/16”-18 Hex nuts (as required) 1/4”-14 x 5/8” Self tapping screws (as required) 3/8”-16 x 3/4” Truss head bolts (as required) 1/4”-20 x 11/16” Self drilling screws (as required) (2) 5/16”-18 x 3/4” Carriage bolts (as required) 1/4”-2 ...

  • Wayne-Dalton 9800 - page 4

    side of the jamb, fit the weatherstrip up tight against the temporarily attached weatherstrip in the header and flush with the inside edge of the jamb. T emporarily secure the weatherstrip with equally spaced nails. Repeat for other side. This will keep the bottom section from falling out of the opening during installation. Equally space nails ap ...

  • Wayne-Dalton 9800 - page 5

    5 A. FLAG ANGLES (AS REQUIRED): A1. Quick Install (Q.I.) Flag Angles A2. Fully Adjustable (F .A.) Flag Angles B. JAMB BRACKETS (AS REQUIRED): B1. Quick Install (Q.I.) Jamb Brackets B2. Fully Adjustable (F .A.) Jamb Brackets C. TRACK ROLLERS (AS REQUIRED): C1. Short Stem T rack Rollers C2. Long Stem T rack Rollers D. GRADUA TED END HINGES: D1. Singl ...

  • Wayne-Dalton 9800 - page 6

    INST ALLA TION Before installing your door , be certain that you have read and followed all of the instruc- tions covered in the pre-installation section of this manual. Failure to do so may result in an improperly installed door . NOTE: Reference TDS 160 for general garage door terminology at www.dasma.com . Quick Install Flag Angles Tools Require ...

  • Wayne-Dalton 9800 - page 7

    pattern. Secure jamb bracket using (1) 1/4” - 20 x 9/16” track bolt and (1) 1/4” - 20 flange hex nut. Repeat for other side. T o attach the center jamb bracket, locate lower hole of the hole / slot pattern of the 2nd hole set on the vertical track. Secure jamb bracket using (1) 1/4” - 20 x 9/16” track bolt and (1) 1/4” - 20 flange hex ...

  • Wayne-Dalton 9800 - page 8

    Stacking Sections Tools Required: Power drill, 7/16” Socket driver 8 NOTE: The sections can be identified by the graduation of the factory installed end hinges. The smallest graduated end hinge on section should be stacked on top of the bottom section, with each graduated end hinge increasing as the sections are stacked, see Parts Breakdown. NOT ...

  • Wayne-Dalton 9800 - page 9

    T op section T op section Nail Door width + 3-3/8” to 3-1/2” 1-11/16” to 1-3/4” Flag angle Flag angle Vertical track against track rollers Horizontal Tracks Tools Required: Ratchet wrench, 9/16” Socket, 9/16” Wrench, level, Step ladder 12 NOTE: Depending on your door , you may have Quick Install Flag Angles, Fully Adjustable Flag Angles ...

  • Wayne-Dalton 9800 - page 10

    on top of the flag angles. NOTE: Cable drum assemblies are marked right and left hand. Cable drums and T orqueMas- ter ® spring tube assembly is cam shaped to fit together only one way . Starting on the right hand side, pre-wrap the cable drum with the counterbalance lift cable 1-1/2 wraps, as shown. Position the T orqueMaster ® spring tube ass ...

  • Wayne-Dalton 9800 - page 11

    seated in the first and second grooves of the cable drum. Pull on the end of the cable to remove all cable slack. Snug the set screw and then tighten an additional 1-1/2 turns. Measure approximately 6” of cable and cut off excess cable. Insert end of the cable into the hole of cable drum. Repeat for left hand cable drum assembly . IMPORT ANT : E ...

  • Wayne-Dalton 9800 - page 12

    perforated angle (may not be supplied), (2) 5/16” x 1-5/8” hex head lag screws and (3) 5/16” bolts with nuts (may not be supplied), fabricate rear back hangs for the horizontal tracks. Attach the horizontal tracks to the rear back hangs with 5/16” - 18 x 1” hex bolts and nuts (may not be supplied). Horizontal tracks must be level and para ...

  • Wayne-Dalton 9800 - page 13

    roller . This is to prevent the garage door from rising while adjusting the counterbalance spring(s). IMPORT ANT : TO ADJUST SPRINGS, ONL Y ADD OR REMOVE A MAXIMUM OF 3/10 OF A TURN (THREE TEETH ON THE RATCHET WHEEL) A T A TIME. BOTH SIDES NEED TO BE ADJUSTED EQUALL Y ON DOUBLE SPRING DOORS. Add spring tension: The ratchet wheel is made of 10 teeth ...

  • Wayne-Dalton 9800 - page 14

    TorqueMaster ® Plus Reset Instructions IMPORT ANT : THE DRA WBAR OPERA TOR FORCE SETTINGS MUST BE ADJUSTED AC- CORDING TO THE MANUF ACTURER’S INSTR UCTIONS. SOME LIGHTER WEIGHT DOORS ARE DESIGNED TO OPERA TE WITH A SINGLE COUNTERBALANCE SPRING. IF THA T COUNTER- BALANCE SPRING BREAKS AND THE DRAWBAR OPERA TOR’S FORCE SETTINGS ARE NOT ADJUSTED ...

  • Wayne-Dalton 9800 - page 15

    Pull Down Rope W ARNING W ARNING DO NOT INST ALL PULL DOWN ROPE ON DOORS WITH OPERA TORS. CHILDREN MA Y BECOME ENT ANGLED IN THE ROPE CAUSING SEVERE OR F A T AL INJURY . Measure and mark the jamb approximately 48” to 50” (1220 to 1270 mm) from floor on the right or left side of jamb. Drill 1/8” pilot hole for no. 6 screw eye. Tie the pull do ...

  • Wayne-Dalton 9800 - page 16

    Cleaning Y our Garage Door IMPORT ANT : DO NOT USE A PRESSURE WASHER ON YOUR GARAGE DOOR! While factory-applied finishes on garage doors are durable, it is desirable to clean them on a routine basis. Some discoloration of the finish may occur when a door has been exposed to dirt-laden atmosphere for a period of time. Slight chalking may also occu ...

  • Wayne-Dalton 9800 - page 17

    W ARNING W ARNING NEVER REMOVE, ADJUST , OR LOOSEN THE BOL TS, SCREWS AND/OR LAG SCREWS ON THE COUNTERBALANCE (END OR CENTER BEARING BRACKETS) SYSTEM OR BO TTOM CORNER BRACKETS OF THE DOOR. THESE BRACKETS ARE CONNECTED TO THE SPRING(S) AND ARE UNDER EXTREME TENSION. TO AVOID POSSIBLE SEVERE OR FA T AL INJURY , HAVE ANY SUCH WORK PERFORMED BY A TRAI ...

  • Wayne-Dalton 9800 - page 18

    Limited Warranty Model 9800 Wayne Dalton, a division of Overhead Door Corporation (“Seller”) warrants to the original purchaser of the Model 9800 (“Product”), subject to all of the terms and conditions hereof, tha t the Product and all components thereof will be free from defects in materials and workmanship for the following period(s) of t ...

  • Wayne-Dalton 9800 - page 19

    ...

  • Wayne-Dalton 9800 - page 20

    AFTER INST ALLA TION IS COMPLETE, F ASTEN THIS MANUAL NEAR GARAGE DOOR FOR EASY REFERENCE. PLEASE DO NO T RETURN THIS PRODUCT TO THE STORE Thank you for your pur chase. Please Do Not Return This Product T o The Store. Please call 1-866-569-3799 (Press Option 1) and follow the prompts to contact the appropriate customer ser vice agent. They will be ...

Fabbricante Wayne-Dalton Categoria Garage Door Opener

I documenti che otteniamo dal fabbricante del dispositivoWayne-Dalton 9800 possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Wayne-Dalton
- manuali per l’uso 9800
- schede prodotto Wayne-Dalton
- opuscoli
- o etichette energetiche Wayne-Dalton 9800
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Wayne-Dalton 9800.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Wayne-Dalton 9800, manuali di manutenzione, brevi manuali o manuali utente Wayne-Dalton 9800. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Wayne-Dalton 9800.

Manuali per l’uso simili

Manuale completo del dispositivo Wayne-Dalton 9800, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Wayne-Dalton 9800 dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Wayne-Dalton 9800.

Il manuale per l’uso completo Wayne-Dalton, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Wayne-Dalton 9800 - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Wayne-Dalton 9800, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Wayne-Dalton 9800 che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Wayne-Dalton 9800 - che ci dovrebbe aiutare nei primi passi durante l'uso Wayne-Dalton 9800
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Wayne-Dalton 9800
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Wayne-Dalton 9800 in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Wayne-Dalton 9800?

Utilizza il modulo sottostante

Se non hai risolto il problema con Wayne-Dalton 9800 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Wayne-Dalton 9800 è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Captcha
Nuova immagine

Commenti (0)