Manuale per l’uso NEC MultiSync E232WMT

19 pagine Non applicabile
Scarica

Vai alla pagina of 19

Summary
  • NEC MultiSync E232WMT - page 1

    MultiSync E232WMT User’s Manual ...

  • NEC MultiSync E232WMT - page 2

    Index W arning, Caution ........................................................................................................................................... English-1 Registration Information ................................................................................................................................ English-2 Recommended ...

  • NEC MultiSync E232WMT - page 3

    English English-1 TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT’S POLARIZED PLUG WITH AN EXTENSION CORD RECEPT ACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULL Y INSER TED. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOL T AGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SER ...

  • NEC MultiSync E232WMT - page 4

    English-2 Registration Information FCC Information 1. Use the attached specied cables with the MultiSync E232WMT (L233QV) monitor so as not to interfere with radio and television reception. (1) The power supply cord you use must have been approved by and comply with the safety standards of U.S.A., and meet the following condition. Power supply c ...

  • NEC MultiSync E232WMT - page 5

    English English-3 Recommended use Safety Precautions and Maintenance FOR OPTIMUM PERFORMANCE, PLEASE NOTE THE FOLLOWING WHEN SETTING UP AND USING THE LCD COLOR MONIT OR: • DO NOT OPEN THE MONITOR. There are no user serviceable parts inside and opening or removing covers may expose you to dangerous shock hazards or other risks. Refer all servicing ...

  • NEC MultiSync E232WMT - page 6

    English-4 CORRECT PLACEMENT AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK F A TIGUE. CHECK THE FOLLOWING WHEN YOU POSITION THE MONITOR: • For optimum performance, allow 20 minutes for the display to warm up. • Adjust the monitor height so that the top of the screen is at or slightly below eye level. Y our eyes should look slig ...

  • NEC MultiSync E232WMT - page 7

    English English-5 Contents Y our new NEC monitor box* should contain the following: • MultiSync monitor with tilt/height adjust stand • Power Cord* 1 • Video Signal Cable (DVI-D to DVI-D cable)* 2 • Video Signal Cable (Mini D-SUB 15 pin to Mini D-SUB 15 pin) • USB Cable* 3 • Audio Cable (ø 3.5 stereo mini plug) • Setup Manual. Mini D ...

  • NEC MultiSync E232WMT - page 8

    English-6 Quick Start T o connect the LCD monitor to your system, follow these instructions: NOTE: Make sure to read “Recommended use” (page 3) before installation. 1. Turn of f the power of your computer . 2. For a PC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your system ( Figure A.1 ). T igh ...

  • NEC MultiSync E232WMT - page 9

    English English-7 3. Place hands on each side of the monitor to tilt the LCD panel and lift up to the highest position. NOTE: Handle with care when tilting the monitor screen. 4. Connect all cables to the appropriate connectors ( Figure C.1 ). For using the USB cable, connect the B type connector to the USB upstream port on the right back side of t ...

  • NEC MultiSync E232WMT - page 10

    English-8 UP DOWN AUTO MENU POWER Figure E.1 LED Indicates that the power is on or off. LED The white light is lit up while the camera is in operation. Microphone Microphone Camera Raise and Lower Monitor Screen T o raise or lower screen, place a hand on each side of the monitor and lift or lower to the desired height ( Figure RL.1 ). NOTE: Handle ...

  • NEC MultiSync E232WMT - page 11

    English English-9 Remove Monitor Stand for Mounting T o prepare the monitor for alternate mounting purposes: 1. Disconnect all cables. 2. Place a hand on each side of the monitor and lift up to the highest position. 3. Place monitor face down on a non-abrasive surface ( Figure S.1 ). NOTE: Handle with care when the monitor is facing down. 4. Remove ...

  • NEC MultiSync E232WMT - page 12

    English-10 Controls OSD (On-Screen Display) control keys on the side of the monitor function are as follows: T o access OSD menu, press the MENU key . T o change signal input, press the AUTO/EXIT key . NOTE: Exit OSD in order to change signal input. UP DOWN AUTO MENU POWER 1 2 3 4 5 6 1 s / UP Navigates up or increases values through the OSD Contro ...

  • NEC MultiSync E232WMT - page 13

    English English-1 1 BRIGHTNESS / CONTRAST Contrast (Only when Eco Mode Off) Adjusts the overall image and background screen brightness by input signal level. Brightness (Only when Eco Mode Off) Adjusts the overall image and background screen brightness. Eco Mode Decreases the amount of power consumption by reducing the brightness level. Off : No fu ...

  • NEC MultiSync E232WMT - page 14

    English-12 OSD Setup Timeout Y ou can select how long the monitor waits after the last touch of a key to shut of f the OSD menu. Language Selects the language used by the OSD. Extra Input Select Changes the video input source. Reset Allows you to reset all OSD control settings back to the factory settings. Information Provides information about the ...

  • NEC MultiSync E232WMT - page 15

    English English-13 Specications Monitor Specications MultiSync E232WMT Notes LCD Module Diagonal: Viewable Image Size: Native Resolution (Pixel Count): 58.42 cm/23.0 inches 58.42 cm/23.0 inches 1920 x 1080 Active matrix; thin lm transistor (TFT) liquid crystal display (LCD); 0.265 mm dot pitch; 250 cd/m 2 white luminance; 1000:1 contrast r ...

  • NEC MultiSync E232WMT - page 16

    English-14 T roubleshooting No picture • The signal cable should be completely connected to the display card/computer . • The display card should be completely seated in its slot. • The monitor does not support DisplayPort converter signal. • Power Switch and computer power switch should be in the ON position. • Check to make sure that a ...

  • NEC MultiSync E232WMT - page 17

    English English-15 USB Hub does not operate • Check to make sure the USB cable is properly connected. Refer to your USB devise User’s Manual. • Check if the USB upstream port on the monitor is connected to the USB downstream port on the computer . And make sure the computer is ON. The touch panel does not work • Check to make sure the USB c ...

  • NEC MultiSync E232WMT - page 18

    English-16 TCO Certied Displays 6 Congratulations! This product is TCO Certied – for Sustainable IT TCO Certied is an international third party sustainability certication for IT products. TCO Certied ensures that the manufacture, use and recycling of IT products reect environmental, social and economic responsibility . Every TCO ...

  • NEC MultiSync E232WMT - page 19

    English English-17 Manufacturer’s Recycling and Energy Information NEC DISPLA Y SOLUTIONS is strongly committed to environmental protection and sees recycling as one of the company’s top priorities in trying to minimize the burden placed on the environment. We are engaged in developing environmentally-friendly products, and always strive to hel ...

Fabbricante NEC Categoria Monitor

I documenti che otteniamo dal fabbricante del dispositivoNEC MultiSync E232WMT possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici NEC
- manuali per l’uso MultiSync E232WMT
- schede prodotto NEC
- opuscoli
- o etichette energetiche NEC MultiSync E232WMT
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso NEC MultiSync E232WMT.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione NEC MultiSync E232WMT, manuali di manutenzione, brevi manuali o manuali utente NEC MultiSync E232WMT. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto NEC MultiSync E232WMT.

Manuali per l’uso simili

Manuale completo del dispositivo NEC MultiSync E232WMT, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare NEC MultiSync E232WMT dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti NEC MultiSync E232WMT.

Il manuale per l’uso completo NEC, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale NEC MultiSync E232WMT - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice NEC MultiSync E232WMT, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per NEC MultiSync E232WMT che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo NEC MultiSync E232WMT - che ci dovrebbe aiutare nei primi passi durante l'uso NEC MultiSync E232WMT
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del NEC MultiSync E232WMT
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio NEC MultiSync E232WMT in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su NEC MultiSync E232WMT?

Utilizza il modulo sottostante

Se non hai risolto il problema con NEC MultiSync E232WMT con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con NEC MultiSync E232WMT è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Commenti (0)