Carrier HUMCCLFP1025-Aの取扱説明書

12ページ 0.18 mb
ダウンロード

ページに移動 of 12

Summary
  • Carrier HUMCCLFP1025-A - page 1

    Humidifiers and Humidistat Installation, Start-Up, and Operating Instructions NOTE: Read the entire instruction in manual applicable to specific unit before starting the installation. This symbol → indicates a change since the last issue. SAFETY CONSIDERATIONS Improper installation, adjustment, alteration, service, maintenance, or use can cause e ...

  • Carrier HUMCCLFP1025-A - page 2

    Step 1—Inspect Package and Check Equipment Inspect contents of packaged humidifier. File claim with shipping company prior to installation if shipment is damaged or incom- plete. The package should contain: 1. Humidifier and media assembly 2. Humidistat 3. Template 4. Owner’s Manual 5. Warranty Certificate 6. Solenoid valve with bridge rectifie ...

  • Carrier HUMCCLFP1025-A - page 3

    Step 7—Make Water Connection If garden hose is not used for water supply: 1. Mount saddle valve on water line according to instructions supplied with valve. 2. Run 1/4-in. diameter (water line grade) tubing from saddle valve to adapter on solenoid valve and tighten compression fittings. IMPORTANT: If water pressure is higher than normal (60 psi), ...

  • Carrier HUMCCLFP1025-A - page 4

    Remember to provide clearance for maintenance and evaporator pad removal. To access pad remove top or bottom cover to expose assembly (turn knob counter-clockwise). Step 3—Prepare Plenum Opening (See Fig. 2.) 1. Use template for marking humidifier opening. 2. Tape in place on plenum making sure template is level. IMPORTANT: For humidifier to oper ...

  • Carrier HUMCCLFP1025-A - page 5

    7. Saddle valve assembly with adapter 8. Four sheet metal screws 9. Foam tape 10. Noise suppressor (use for water pressure over 60 psi) 11. Worm clamp for field-supplied drain tube 12. Humidifier maintenance instruction sticker 13. Carrier logo label Step 2— Select Location (See Fig. 7.) Humidifier must be installed on supply plenum only. If furn ...

  • Carrier HUMCCLFP1025-A - page 6

    Step 6—Mount Solenoid Valve The water solenoid valve should be mounted on top of humidifier enclosure. 1. To mount solenoid on top, see Fig. 10. a. Firmly press valve into the top inlet hole on enclosure. Seat valve flush against inlet hole. 2. If alternate mounting of solenoid is required, see Fig. 11. a. To mount solenoid on side, use 3/8-in. I ...

  • Carrier HUMCCLFP1025-A - page 7

    Step 1—Inspect Package and Check Equipment Inspect the contents of packaged humidifier. File claim with shipping company prior to installation if shipment is damaged or incomplete. The package should contain: 1. Humidifier and media assembly 2. Humidistat 3. Template 4. 6-in. damper 5. Owner’s Manual 6. Warranty Certificate 7. Solenoid valve wi ...

  • Carrier HUMCCLFP1025-A - page 8

    Step 5—Install Bypass Duct Attach field-supplied 6-in. diameter duct, elbow, or starting collar with field-supplied 1/4-in. zip screws. Install supplied 6-in. damper in 6-in. duct connector. IMPORTANT: On systems with central cooling, the damper should be closed during cooling season to prevent bypass air. Do not support weight of bypass duct fro ...

  • Carrier HUMCCLFP1025-A - page 9

    Step 3—Prepare Plenum Opening (See Fig. 2.) 1. Use template for marking humidifier opening. 2. Tape in place on plenum making sure template is level. IMPORTANT: For humidifier to operate properly it must be level and mounted on a vertical surface. 3. Drill four 1/8-in. holes in plenum. 4. Cut opening in plenum using heavy solid lines on template ...

  • Carrier HUMCCLFP1025-A - page 10

    compression fittings. Plastic compression nut supplied with float valve should not be torqued greater than 25 in.-lb. For copper tubing installations: copper tubing may be connected to float valve by using a field-supplied 1/4 to 1/4 in. straight- through compression union. Run copper tubing to 1 side of compression union and use a standard compres ...

  • Carrier HUMCCLFP1025-A - page 11

    5. Mount case horizontally over wires directly to wall using 2 long screws provided. 6. Replace faceplate and knob. Step 2—Duct Mounting (Low Voltage) 1. Locate humidistat at least 8 in. upstream of humidifier in return-air duct. If mounting near elbow area, keep device 6 in. upstream of elbow so element will be affected by normal airflow. (See F ...

  • Carrier HUMCCLFP1025-A - page 12

    Step 5—Operation When relative humidity falls to humidistat set point, the humidistat switch makes contact and starts humidifier. In some central unit humidifier systems, furnace fan must be operating before humidi- fier will start. An increase in relative humidity above set point will stop humidifier. Step 6—Checkout Place system in operation ...

メーカー Carrier カテゴリー Humidifier

Carrier HUMCCLFP1025-Aのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- HUMCCLFP1025-Aの取扱説明書
- Carrierの製品カード
- パンフレット
- またはCarrier HUMCCLFP1025-Aの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Carrier HUMCCLFP1025-Aの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Carrier HUMCCLFP1025-Aの取り付け説明書、サービスマニュアル、簡易説明書、またはCarrier HUMCCLFP1025-Aのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Carrier HUMCCLFP1025-Aの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Carrier HUMCCLFP1025-Aデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがCarrier HUMCCLFP1025-Aを使用するのを助ける技術的文書のことです。説明書は通常、全てのCarrier HUMCCLFP1025-Aユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Carrierの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Carrier HUMCCLFP1025-Aの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははCarrier HUMCCLFP1025-Aの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Carrier HUMCCLFP1025-Aに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Carrier HUMCCLFP1025-Aデバイスの基本機能を使うにあたってのヒント。 Carrier HUMCCLFP1025-Aのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Carrier HUMCCLFP1025-Aに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるCarrier HUMCCLFP1025-Aのメーカー/サービスへの連絡先に関する情報。

Carrier HUMCCLFP1025-Aについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもCarrier HUMCCLFP1025-Aの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがCarrier HUMCCLFP1025-Aで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)