-
Anton/Bauer DUAL 2722 - page 1
PowerCharger DUAL 2722 Charger / Power Supply OWNER’S MANUAL ...
-
Anton/Bauer DUAL 2722 - page 2
...
-
Anton/Bauer DUAL 2722 - page 3
TABLE OF CONTENTS INTRODUCTION…………………………………………………………………....1 FEATURES…………………………………………………………………………..1 SAFEGUARDS………………………………………………………………………2 GROUNDING/EARTHING…………………………? ...
-
Anton/Bauer DUAL 2722 - page 4
INTRODUCTION The DUAL 2722 is a simultaneous 2 position Interactive 2000 PowerCharger fast charger with 70 watt DC camera power supply. It incorporates all of the Logic Series circuits that are employed in ev ery Anton/Bauer charger. The InterActive charge programm ing provides all charge t erm inati on and protection routines for safe, reliable, c ...
-
Anton/Bauer DUAL 2722 - page 5
SAFEGUARDS Power Sources: This unit was designed to operate at mains vol tages from 90 to 264 Volts AC, 50-60 Hz. Risk of Electrical Shock: Refer servicing to quali fied service personnel. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. GROUNDING/EARTHING IMPORTANT WARNING: THIS APPARATUS MUST BE EARTHED. To ensure saf ...
-
Anton/Bauer DUAL 2722 - page 6
Charging As with all Anton/Bauer chargers, chargi ng with DUAL 2722 is fully automatic. M ount any Digital Logic Series or Logic Se ries battery to the DUAL 2722 and it will automatically determine the appropriate ch arge routine and execute it. Applications The DUAL 2722 will charge any Anton/Baue r Logic Series Gold Mount battery including model ...
-
Anton/Bauer DUAL 2722 - page 7
Three Stage Charging Methodology In general, the DUAL 2722 will deliver a three stage charge routine to each battery. 1. Stage One will deliver a high rate charge matched to the capabilities of the battery (typi cally a one or two hour rate , depending on battery t ype). During this stage, six separate cutoff m ethods are in operation, sim ultaneou ...
-
Anton/Bauer DUAL 2722 - page 8
LED Indications The DUAL 2722 has two sets of two LEDs (one red, one green) and one green st atus LED in the center. The green status LED indicates: Steady green – line voltage is present; Off – line voltage not present.. The red and green charge status LED’s indicat e the charging status of the battery. The following tab le identifies all of ...
-
Anton/Bauer DUAL 2722 - page 9
1 - - - - - - - 2 - - - - - - - LCD Indications Each PowerCharger’s liquid crystal displa y (LCD) will display the status of each battery, as well as, important PowerCharg er operating indications. The fol lowing information expl ains the indications which appear in t he LCD. The levels of the LCD display on each Powe rCharger can be obtai ned by ...
-
Anton/Bauer DUAL 2722 - page 10
DDM (DIAGNOSTIC/DISCHARGE MODULE) A standard feature with the DUAL 2722, the DDM completes a battery m anagement system, capable of testin g battery capacity and identifying battery anomalies before they appear in the field. The DDM will perform a standard or a 24 hour test . The standard test is a full charge-discharge-full charge routine , which ...
-
Anton/Bauer DUAL 2722 - page 11
To Operate The DDM 1. Mount the battery to any position on the PowerCharger. When the PowerCharger has completed its communication with the battery, the ALTERNATING RED and GREEN LEDs will stop and the battery will begin its char ge routine. The battery information and position number will appear on the LCD display. (If the battery is already on th ...
-
Anton/Bauer DUAL 2722 - page 12
“AUTOCAL” Feature When a DDM is installed in the PowerC harger, a special InterActive m ode is automatically enabled for DIGITAL batteries placed on the PowerCharger at any time. The PowerCharger will interrogate the status of the DIGITAL battery to determine whether the battery has receive d a “learning” cycle or “calibrate” cycle with ...
-
Anton/Bauer DUAL 2722 - page 13
OPERATION AS DC CAMERA SUPPLY FROM MAINS The DUAL 2722 can operate cameras and camcorders using t he four pin camera output connector located on the back of the DUAL 2722. To power the camera, attach one end of the XLR4 accessory cable (available separately) to the DUAL 2722. Attach the other end to the “DC in” four pin XLR on the camera/camcor ...
-
Anton/Bauer DUAL 2722 - page 14
FCC NOTICE This equipment has been tested and found to comply with the li mits for a Class A digital device pursuant t o Part 15 of the FCC Rules. These lim its are designed t o provide reasonable protection against harmful interference when the equi pment is operated in a comm ercial environm ent. Th is equipment generat es, uses, and can radiate ...
-
Anton/Bauer DUAL 2722 - page 15
WARRANTY IMPORTANT: PLEASE MAIL WARRANTY REGISTRATION CARD WITHIN TEN (10) DAYS OF PURCHASE. We must ha ve this card on file with our Custom er Support Group to establish t his warranty. Proper registrati on will also enable us t o provide update inform ation on the battery syst em. All new Anton/Bauer products have been thoroughly tested and i nsp ...
Anton/Bauer DUAL 2722についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもAnton/Bauer DUAL 2722の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがAnton/Bauer DUAL 2722で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。