Wayne-Dalton 105/110の取扱説明書

22ページ 8.61 mb
ダウンロード

ページに移動 of 22

Summary
  • Wayne-Dalton 105/110 - page 1

    GARAGE DOORS & OPENERS Part No. IMPORT ANT NO TICES! Wayne-Dalton highly recommends that you read and fully under - stand the Installation Instructions and Owner’ s Manual before you attempt this installation. T o avoid possible injur y , read the enclosed instructions carefully before installing and operating the garage door . Pay close atte ...

  • Wayne-Dalton 105/110 - page 2

    2 Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com A. TRACK ROLLERS (AS REQUIRED): A1. Short Stem T rack Rollers A2. Long Stem T rack Rollers A3. Sh ...

  • Wayne-Dalton 105/110 - page 3

    I m p o r t a n t S a f e t y I n s t r u c t i o n s DEFINITION OF KEY WORDS USED IN THIS MANUAL: W ARNING W ARNING INDICA TES A POTENTIALL Y HAZARDOUS SITUA TION WHICH; IF NOT AVOIDED , COULD RESUL T IN SEVERE OR FA T AL INJURY . CAUTION: PROPER TY DAMAGE OR INJURY CAN RESUL T FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORT ANT : REQUIRED STEP FOR SA ...

  • Wayne-Dalton 105/110 - page 4

    Cable drums RH/LH Torsion springs RH/LH Cotter pin (as required) 5/16” x 1-1/4” Clevis pin (as required) Center bearing bracket assembly (as required) Center bearing bracket assembly (as required) (2) Cable sheaves Key shafts (as required) Hinges Half Center hinges (as required) Strut clips (as required) Center coupler assembly (as required) Co ...

  • Wayne-Dalton 105/110 - page 5

    Graduated End Hinge Schedule 6 Section High Door 2” T op N/A Intermediate IV 5# Intermediate III 4# Intermediate II 3# Intermediate I 2# Bottom 1# 3” T op N/A Intermediate IV 7# Intermediate III 6# Intermediate II 5# Intermediate I 4# Bottom 3# 7 Section High Door 2” T op N/A Intermediate V 6# Intermediate IV 5# Intermediate III 4# Intermedia ...

  • Wayne-Dalton 105/110 - page 6

    Door Height T rack Manual Lift Motor Operated 6’0” to 7’0” 15” Radius 102” (2591 mm) 125” (3175 mm) 7’1” to 8’0” 114” (2896 mm) 137” (3480 mm) 8’1” to 9’0” 126” (3200 mm) 168” (4267 mm) 9’1” to 10’0” 138” (3505 mm) 168” (4267 mm) 10’1” to 12’0” 162” (4115 mm) * HEADROOM REQUIREMENTS T rack ...

  • Wayne-Dalton 105/110 - page 7

    INST ALLA TION Before installing your door , be certain that you have read and followed all of the instruc- tions covered in the pre-installation section of this manual. Failure to do so may result in an improperly installed door . IMPORT ANT : WOOD DOORS MUST BE COMPLETEL Y FINISHED (3 TOT AL COATS, INCLUDING PRIMER COA T) PRIOR TO INST ALLA TION, ...

  • Wayne-Dalton 105/110 - page 8

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com T ypical left hand bottom corner bracket Bottom section (3) 1/4” - 20 x 1-7/8” Carriage bolts ( ...

  • Wayne-Dalton 105/110 - page 9

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com the upper leg of strut to the bottom section using (1) 1/4”-20 x 1-7/8” carriage bolt and (1) 1 ...

  • Wayne-Dalton 105/110 - page 10

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Weather seal Level Bottom section Wooden shims (If necessary) V ertical T racks T ools: Power Drill ...

  • Wayne-Dalton 105/110 - page 11

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com side. IMPORT ANT : THE DIMENSION BETWEEN THE FLAG ANGLES MUST BE: FOR 2” TRACK APPLICA TIONS: DOO ...

  • Wayne-Dalton 105/110 - page 12

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com first, then through the rear support bracket and the 5/16”-18 nuts are in the inside of the hori ...

  • Wayne-Dalton 105/110 - page 13

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com 1a. Center bearing bracket T orsion shaft or T orsion keyed shaft 1b. Center bearing Black cable dr ...

  • Wayne-Dalton 105/110 - page 14

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com T orsion keyed shafts Horizontal track End bearing bracket Center bracket End bearing bracket Cente ...

  • Wayne-Dalton 105/110 - page 15

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Locking Pliers Perforated angle Rear back hang assembly Shaft Spring Horizontal track End bearing b ...

  • Wayne-Dalton 105/110 - page 16

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com 6.) Clamp locking pliers onto track and rewind springs. IMPORT ANT : IF DOOR STILL DOES NOT OPERA T ...

  • Wayne-Dalton 105/110 - page 17

    Door Arm Hookup T ools: Needle nose pliers At the center of the top section, measure horizontally from the top of center hinge to the bottom of strut. Using that dimension, measure and cut (2) pieces of perforated angles. Assemble the (2) pieces together using (2) 3/8” bolts and nuts (supplied by others). Now, secure to the top section using carr ...

  • Wayne-Dalton 105/110 - page 18

    Cleaning Y our Garage Door IMPORT ANT : DO NOT USE A PRESSURE W ASHER ON YOUR GARAGE DOOR! An annual inspection of all the surfaces of your garage door(s) will reveal the extent of weather - ing and the possible need for refinishing. When the finish becomes eroded or thin, clean and prime any areas showing deterioration. Then completely refinish ...

  • Wayne-Dalton 105/110 - page 19

    3. Lubrication: The door should open and close smoothly. Ensure the door track rollers are rotating freely when opening and closing the door . If track rollers do not rotate freely, clean the door tracks, removing dirt and any foreign substances. Clean and lubricate (use a non-silicon based lubricant) graduated end hinges, steel track rollers, spri ...

  • Wayne-Dalton 105/110 - page 20

    Limited warranty Wayne W ood, Raised Panel, 105/110, 310/311 Subject to the terms and conditions contained in this Limited Warranty , Wayne-Dalton (“Manufacturer”) warrants the sections of the door , against defects in material and workmanship, for a period of ONE (1) YEAR from the time of delivery provided: i) (i) The interior and exterior sur ...

  • Wayne-Dalton 105/110 - page 21

    ...

  • Wayne-Dalton 105/110 - page 22

    AFTER INST ALLA TION IS COMPLETE, F ASTEN THIS MANUAL NEAR THE GARAGE DOOR. Please Do Not Return This Product T o The Store Thank you for your pur chase. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pa ges business listings or go to the Find a Dealer section online at www .Wayne-Dalt ...

メーカー Wayne-Dalton カテゴリー Garage Door Opener

Wayne-Dalton 105/110のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 105/110の取扱説明書
- Wayne-Daltonの製品カード
- パンフレット
- またはWayne-Dalton 105/110の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Wayne-Dalton 105/110の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Wayne-Dalton 105/110の取り付け説明書、サービスマニュアル、簡易説明書、またはWayne-Dalton 105/110のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Wayne-Dalton 105/110の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Wayne-Dalton 105/110デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがWayne-Dalton 105/110を使用するのを助ける技術的文書のことです。説明書は通常、全てのWayne-Dalton 105/110ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Wayne-Daltonの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Wayne-Dalton 105/110の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははWayne-Dalton 105/110の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Wayne-Dalton 105/110に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Wayne-Dalton 105/110デバイスの基本機能を使うにあたってのヒント。 Wayne-Dalton 105/110のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Wayne-Dalton 105/110に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるWayne-Dalton 105/110のメーカー/サービスへの連絡先に関する情報。

Wayne-Dalton 105/110についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもWayne-Dalton 105/110の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがWayne-Dalton 105/110で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)