-
Kraun KR.XN - page 1
www .kraun.it Wireless Router 54MB 4 Ports User’s Manual Cod. KR.XN ...
-
Kraun KR.XN - page 2
www .kraun.it 2 User’s Manual Contents Package contents 4 1. About this Guide 4 1.1 Purposes 4 1.2 Conventions 4 1.3 Overview of this User Guide 4 2. Introduction 4 2.1 Overview of the Router 4 2.2 Features 4 2.2.1 The Front Panel 5 2.2.2 The Rear Panel 5 3. Connecting the Router 5 3.1 System Requirements 5 3.2 Installation Environment Requiremen ...
-
Kraun KR.XN - page 3
www .kraun.it 3 User’s Manual 5.8.3 Domain Filtering 20 5.8.4 MAC Filtering 20 5.8.5 Remote Management 21 5.8.6 Advanced Security 21 5.9 Static Routing 22 5.10 DDNS 22 5.11 System Tools 22 5.11.1 Time 22 5.11.2 Firmware 23 5.11.3 Factory Defaults 23 5.11.4 Backup and Restore 23 5.11.5 Reboot 23 5.11.6 Password 24 5.11.7 Log 24 5.11.8 Statistics 2 ...
-
Kraun KR.XN - page 4
www .kraun.it 4 User’s Manual Package contents The following contents should be found in your box: • One KR.XN Wireless Router 54MB 4 Ports • One AC power Adapter for KR.XN Wireless Router 54MB 4 Ports • Quick Installation Guide • One Resource CD for KR.XN Wireless Router 54MB 4 Ports, includ- ing: • This Guide • Other Helpful Informa ...
-
Kraun KR.XN - page 5
www .kraun.it 5 User’s Manual 2.2.1 The Front Panel The front panel of the KR.XN consists of several LED indicators, which is designed to indicate connections. View from left to right. Table 2-1 describes the LEDs on the front panel of the router. Figure 2-1 Front Panel sketch Name Action Description Power Not lit No Power Lit up Power on System ...
-
Kraun KR.XN - page 6
www .kraun.it 6 User’s Manual 4. Quick Installation Guide After connecting the KR.XN Router into your network, you should con- figure it. This chapter describes how to configure the basic functions of your KR.XN Wireless Router 54MB 4 Ports. These procedures only take you a few minutes. You can access the Internet via the router immedi- ately aft ...
-
Kraun KR.XN - page 7
www .kraun.it 7 User’s Manual router using the web browser. Please click the Quick Setup link on the left of the main menu and the Quick Setup screen will appear. Figure 4-5 Quick Setup Click Next, then Choose WAN Connection Type page will appear, shown in figure 4-6. Figure 4-6 Choose WAN Connection Type The router supports three popular ways to ...
-
Kraun KR.XN - page 8
www .kraun.it 8 User’s Manual These settings are only for basic wireless parameters, for advanced set- tings, please refer to Section 5.5: “Wireless.” Note: The change of wireless settings won’t take effect until the router reboots! You can reboot it manually. If you need instructions as to how to do this, please refer to Section 5.11.5: ? ...
-
Kraun KR.XN - page 9
www .kraun.it 9 User’s Manual • MAC Address - The physical address of the router, as seen from the LAN. The value can’t be changed. • IP Address - Enter the IP address of your router in dotted-decimal notation (factory default: 192.168.1.1). • Subnet Mask - An address code that determines the size of the net- work. Normally use 255.255.25 ...
-
Kraun KR.XN - page 10
www .kraun.it 10 User’s Manual • User Name/Password - Enter the User Name and Password pro- vided by your ISP. These fields are case-sensitive. • Connect on Demand - You can configure the router to disconnect your Internet connection after a specified period of inactivity (Max Idle Time). If your Internet connection has been terminated due to ...
-
Kraun KR.XN - page 11
www .kraun.it 11 User’s Manual Figure 5-9 802.1X + Static IP Settings • User Name - Enter the user name for 802.1X authentication pro- vided by your ISP • Password - Enter the password for 802.1X authentication pro- vided by your ISP. Click Login to start 802.1X authentication. Click Logout to end 802.1X authentication. • IP Address - Enter ...
-
Kraun KR.XN - page 12
www .kraun.it 12 User’s Manual Figure 5-11 L2TP Settings • User Name/Password - Enter the User Name and Password pro- vided by your ISP. These fields are case-sensitive. • Dynamic IP/ Static IP – Choose either as you are given by your ISP. Click the Connect button to connect immediately, Click the Discon- nect button to disconnect immediate ...
-
Kraun KR.XN - page 13
www .kraun.it 13 User’s Manual Figure 5-13 MAC Address Clone Some ISPs require that you register the MAC Address of your adapter, which is connected to your cable, DSL modem or Ethernet during instal- lation. Changes are rarely needed here. • WAN MAC Address - This field displays the current MAC address of the WAN port, which is used for the WA ...
-
Kraun KR.XN - page 14
www .kraun.it 14 User’s Manual you choose this option to encrypt your wireless network. The encryp- tion settings are described below. • Authentication Type - You can select one of the following authentica- tion types: • WEP - Select WEP authentication type based on 802.11 authenti- cations. • WPA-PSK/WPA2-PSK - Select WPA/WPA2 authenticati ...
-
Kraun KR.XN - page 15
www .kraun.it 15 User’s Manual Figure 5-17 Add or Modify Wireless MAC Address Filtering entry To add or modify a MAC Address Filtering entry, follow these instruc- tions: 1. Enter the appropriate MAC Address into the MAC Address field. The format of the MAC Address is XX-XX-XX-XX-XX-XX (X is any hexa- decimal digit). For example: 00-0A-EB-B0-00-0 ...
-
Kraun KR.XN - page 16
www .kraun.it 16 User’s Manual There are three submenus under the DHCP menu (shown in figure 5- 19): DHCP Settings, DHCP Clients List and Address Reservation. Click any of them, and you will be able to configure the corresponding function. The detailed explanations for each submenu are provided below. 5.6.1 DHCP Settings The router is set up by d ...
-
Kraun KR.XN - page 17
www .kraun.it 17 User’s Manual 5.7 Forwarding Figure 5-24 The Forwarding menu There are four submenus under the Forwarding menu (shown in figure 5-24): Virtual Servers, Port Triggering, DMZ and UPnP. Click any of them, and you will be able to configure the corresponding function. The de- tailed explanations for each submenu are provided below. 5. ...
-
Kraun KR.XN - page 18
www .kraun.it 18 User’s Manual 3. Select the protocol used for Trigger Port from the pull-down list, ei- ther TCP, UDP, or All. 4. Enter the range of port numbers used by the remote system when it responds to the PC’s request. 5. Select the protocol used for Incoming Ports Range from the pull- down list, either TCP or UDP, or All. 6. Select the ...
-
Kraun KR.XN - page 19
www .kraun.it 19 User’s Manual and MAC Filtering are enabled, their settings are ineffective. Figure 5-32 Firewall Settings • Enable Firewall - the general firewall switch is on or off. • Enable IP Address Filtering - set IP Address Filtering is enabled or disabled. There are two default filtering rules of IP Address Filtering, either Allow o ...
-
Kraun KR.XN - page 20
www .kraun.it 20 User’s Manual For example: If you desire to block E-mail received and sent by the IP Address 192.168.1.7 on your local network, and to make the PC with IP Address 192.168.1.8 unable to visit the website of IP Address 202.96.134.12, while other PCs have no limit you should specify the fol- lowing IP address filtering list: 5.8.3 D ...
-
Kraun KR.XN - page 21
www .kraun.it 21 User’s Manual 3. Status - Select Enabled or Disabled for this entry on the Status pull- down list. 4. Click the Save button to save this entry. To add additional entries, repeat steps 1-4. When finished, click the Return button to return to the MAC Address Fil- tering page. To modify or delete an existing entry: 1. Click the Modi ...
-
Kraun KR.XN - page 22
www .kraun.it 22 User’s Manual • Forbid Ping Packet from LAN Port - Enable or Disable forbidding Ping Packet to access the router from the LAN port. The default value is disabled. If enabled, the ping packet from the LAN port cannot ac- cess the router. (Defends against some viruses) Click the Save button to save the settings. Click the Blocked ...
-
Kraun KR.XN - page 23
www .kraun.it 23 User’s Manual 2. Enter date and time in the right blanks 3. Click Save. Click the Get GMT button to get GMT time from Internet if you have con- nected to Internet. If you’re using Daylight saving time, please follow the steps below. 1. Select using daylight saving time. 2. Enter daylight saving beginning time and end time in th ...
-
Kraun KR.XN - page 24
www .kraun.it 24 User’s Manual • Upgrade the firmware of the router (system will reboot automati- cally). • Restore the router’s settings to factory default (system will reboot au- tomatically). 5.11.6 Password This page (shown in figure 5-53) allows you to change the factory de- fault user name and password of the router. Figure 5-53 Passw ...
-
Kraun KR.XN - page 25
www .kraun.it 25 User’s Manual 2) Connect the Ethernet cable from your ADSL modem to the WAN port on the router. The telephone cord plugs into the Line port of the ADSL modem. 3) Login to the router, click the “Network” menu on the left of your browser, and click “WAN” submenu. On the WAN page, select “PPPoE” for WAN Connection Type. ...
-
Kraun KR.XN - page 26
www .kraun.it 26 User’s Manual 4. I want to build a WEB Server on the LAN, what should I do? 1) Because the WEB Server port 80 will interfere with the WEB man- agement port 80 on the router, you must change the WEB man- agement port number to avoid interference. 2) To change the WEB management port number: Login to the rout- er, click the “Secu ...
-
Kraun KR.XN - page 27
www .kraun.it 27 User’s Manual Figure B-3 Configuration tab 3) Click on Properties. The following TCP/IP Properties window will display and the IP Address tab is open on this window by default. 4) Now you have two ways to configure the TCP/IP protocol below: -> Assigned by DHCP Sever a. Select Obtain an IP address automatically, as shown in th ...
-
Kraun KR.XN - page 28
www .kraun.it 28 User’s Manual Figure B-7 IP Address tab b. Type the router’s LAN IP address (the default IP is 192.168.1.1) into the New gateway field on the Gateway tab, and click on the Add button, as shown in the figure: Figure B-8 Gateway tab c. On the DNS Configuration tab, click Enable DNS radio, and type your computer name in to the Hos ...
-
Kraun KR.XN - page 29
www .kraun.it 29 User’s Manual Appendix D: Glossary • 2x to 3x eXtended Range™ WLAN Transmission Technology - The WLAN device with 2x to 3x eXtended Range™ WLAN transmission technology make its sensitivity up to 105 dB, which gives users the ability to have robust, longer-range wireless connections. With this range-enhancing technology, a 2 ...
Kraun KR.XNについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもKraun KR.XNの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがKraun KR.XNで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。