-
AirLink APSUSB203 - page 1
Quick Installation Guide Model # APSUSB203 Ve r . 1 A 3-Port Print Server ...
-
AirLink APSUSB203 - page 2
Connecting the Print Server Section 1 W arning: Only a USB printer may be connected to the USB port of the Print Server . Connecting any other USB device to the Print Server may damage the Print Server . Note: Do not plug the power cord to the Print Server until you have reached Step 4 of this section. Step 1 Connect one end of the network cable to ...
-
AirLink APSUSB203 - page 3
Section 2 Installing PS Utility Step 1 Insert the provided CD and wait for the autorun screen to appear . Step 2 Click on Inst all PS Utility . Step 3 Click Next . Note: If the autorun screen does not appear automatically , go to S t art , Run , type D:autorun.exe (where D is the letter of your CD drive) and click OK . ...
-
AirLink APSUSB203 - page 4
Step 4 Click Next . Step 5 Click Ye s . Step 6 Click Finish . ...
-
AirLink APSUSB203 - page 5
Section 3 Configuring Network Setting Before configuring the Print Server ’ s network setting, please t ake note of your computer ’ s TCP/IP setting. Step 1 Click on Start , Run , and type command (for Windows 95/98/ME) or cmd (for Windows 2000/ XP) and click OK . Step 2 At the command prompt, type ipconfig and press Enter . Step 3 Write down t ...
-
AirLink APSUSB203 - page 6
S tep 6 In the IP Address field, enter a valid IP address, subnet mask, and default gateway that matches your local area network. For example : If your computer ’s IP Address is 192.168.1 .100 , enter the same three numbers: 192.168.1 in the corresponding fields. Note: Y ou can leave the last IP Address number 254 as is unless another network dev ...
-
AirLink APSUSB203 - page 7
V erifying Network Connection Section 4 Step 1 Run the PS Utility by going to St art , (All) Programs , PS-Utility , PS-Utility v3.00 . Step 2 Make sure the Print Server is detected under the Device Name . Step 3 Click on Show W eb Setup to display the Print Server ’s Web Configuration Utility . Step 4 V erify that the Printer S t atus for the co ...
-
AirLink APSUSB203 - page 8
Step 5 Click on the T ools link, select the port you want to test and click the T est button. The Print Server will perform a low-level print test, bypassing the operating system layer . Note: Y our printer should print out a test p age. If not, verify that the printer is powered on and all cables are securely connected and try again. If the printe ...
-
AirLink APSUSB203 - page 9
Section 5 Running PS Wizard W arning: Make sure you have installed the printer driver locally on every computer that will use the Print Server in your network before running the PS Wizard. Otherwise, the PS Wizard will not run properly . Be sure to run the PS Wizard on all the computers that will use the Print Server in your network. Step 1 Insert ...
-
AirLink APSUSB203 - page 10
Section 4 Step 3 Click Next . Step 4 Select the printer that is connected to the print server and click Next . ...
-
AirLink APSUSB203 - page 11
Step 5 Double-click on the Print Server , select the Printer Port that the printer is connected to and click Next . Step 6 Click Finish and OK . (For Windows 95/98/ME, you’ll need to reboot the computer). S tep 7 Re-run the PS Wizard and setup any remaining printer(s) that are connected to the print server . Step 8 Run the PS Wizard on all the co ...
-
AirLink APSUSB203 - page 12
Section 6 Performing Operating System Print T est The final step in setting up the Print Server is to perform an operating system print test. Please note that the instructions below are for Windows XP , but the steps are similar for all the other Windows operating systems. Step 1 Click on Start , Settings , Printers and Faxes . Step 2 Right-click o ...
-
AirLink APSUSB203 - page 13
Section 7 T echnical Support E-mail: support@airlink101.com T oll Free: 1-888-746-3238 Web Site: www .airlink101.com Y ou have successfully configured the Print Server for printing. For more information on how to use the Web Configuration Utility or setup for Mac OS, please refer to the User ’ s Manual in the provided CD. Step 3 Click on the Prin ...
-
AirLink APSUSB203 - page 14
Copyright © 2006 AirLink101. All rights reserved. AirLink101, the stylized AirLink101 logo, specific product designations, and all other words and logos that are identified as trademarks and/or service marks are, unless noted otherwise, the trademarks and service marks of A irLink101. All other product or service names are the property of their re ...
AirLink APSUSB203についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもAirLink APSUSB203の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがAirLink APSUSB203で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。