-
Pentair JSAYDL - page 1
DURA-JET TM PUMP O W N E R’ S M A N U A L INST ALLA TION, OPERA TION & P AR TS MODELS 1/2 HP 3/4 HP 3/4 HP 1 HP 1 HP 1-1/2 HP (2-Speed) (2-Speed) JSA CL JSADL JSA YDL JSAEL JSA YEL JSAFL JSADL-2A JSAEL-2A JSAEFL JSA YFL This manual should be given to the end user of this pump; its use will reduce service calls and chance of injury and will le ...
-
Pentair JSAYDL - page 2
2 DURA-JET SP A PUMP To avoid unneeded service calls, prevent possible injuries, and get the most out of your pump, READ THIS MANUAL CAREFULLY! The Sta-Rite ‘JS’ Series Tub Pump: • Is designed to circulate hot water in spas and hot tubs. • Is an excellent performer; durable, reliable. T able of Contents Safety Instructions ................. ...
-
Pentair JSAYDL - page 3
3 READ AND FOLLO W ALL INSTR UCTIONS! This is the safety alert symbol. When you see this symbol on your sys- tem or in this manual, look for one of the following signal words and be alert to the potential for personal injury. warns about hazards that will cause death, serious personal in- jury, or major property damage if ignored. warns about hazar ...
-
Pentair JSAYDL - page 4
4 INST ALLA TION Installation and wiring of pump should only be done by qualified, licensed personnel. Pump mount must: Be Solid - Level - Rigid - Vibration free. (To reduce vibration and pipe stress, bolt pump to mount.) Be installed with pump suction inlet below water level at all times (this al- lows pump to prime). Be installed with pump discha ...
-
Pentair JSAYDL - page 5
5 ELECTRICAL Ground motor before connecting to electrical power supply! Failure to ground pump motor can cause serious or fatal electrical shock hazard! Do not ground to a gas supply line! To avoid dangerous or fatal electrical shock, turn OFF power to motor before working on electrical connections. GFCI tripping indicates an electrical problem. If ...
-
Pentair JSAYDL - page 6
6 V oltage: Voltage at motor must be not more than 10% above or below motor name- plate rated voltage or motor may overheat, causing overload tripping and re- duced component life. If voltage is less than 90% or more than 110% of rated voltage when motor is running at full load, consult power company. Values given in tables below are for PUMP MOTOR ...
-
Pentair JSAYDL - page 7
7 OPERA TION Priming Pump: NEVER run pump dry! Running pump dry may damage seals, causing leakage and flooding! Fill pump with water before starting motor. Do not add chemicals to spa system directly in front of pump suction. Adding undiluted chemicals may damage pump and voids warranty. Open gate valves before starting system. Pump will prime itse ...
-
Pentair JSAYDL - page 8
8 Pump should only be serviced by qualified personnel. To avoid dangerous or fatal electrical shock hazard, disconnect power to motor before working on pump or motor! No lubrication or regular maintenance are needed. If shaft seal is damaged, repair as follows: Removing Old Seal: 1. Disconnect power to pump motor. 2. Drain tub and pump; disconnect ...
-
Pentair JSAYDL - page 9
9 5. Screw impeller onto shaft until it seats against shaft shoulder. Work slinger over end of impeller sleeve so it rides on sleeve (Figure 6). 6. Remount front plate; using pattern, shown in Figure 7, torque bolts to 30 inch-lbs. (34.5 cm-kg). BE SURE to start with bolt in 3 o’clock position as shown. 7. Reconnect unions; tighten hand tight onl ...
-
Pentair JSAYDL - page 10
10 Draining Pump: To avoid dangerous or fatal electrical shock hazard, turn OFF power to motor before draining pump. NOTICE: Do not use anti-freeze solutions (except propylene glycol) in your spa system. Most anti-freezes are hightly toxic and may damage plastic components in the system. Propylene glycol is non-toxic and will not damage pump compon ...
-
Pentair JSAYDL - page 11
11 TR OUBLESHOO TING GUIDE Read and understand safety and operating instructions in this manual before doing any work on pump! A. PUMP DOES NO T OPERA TE 1. Check GFCI for proper operation according to GFCI manufacturer’s in- structions. 2. Check for plugged impeller. Follow disassembly/assembly instructions under “ Pump Service”, Page 8. 3. ...
-
Pentair JSAYDL - page 12
12 1161 0695 1 5 8 9 7 3 4 6 2 11 11 12 1 2 13 7A • Not illustrated. * JSAFL-A, JSAEFL-A only. REP AIR P AR TS LIST DURA-JET TM SP A PUMP 3/4 through 1-1/2 HP Models Parts are common to all models listed except as noted; Key Nos. 1, Motor; and 8, Impeller, are listed below. Model Motor No. Impeller No. No. HP (Key No. 1) (Key No. 6) 115 Volt Sing ...
-
Pentair JSAYDL - page 13
13 ...
-
Pentair JSAYDL - page 14
14 ...
-
Pentair JSAYDL - page 15
15 ...
-
Pentair JSAYDL - page 16
S196 (Rev . A) 04-15-10 *S 196 * ...
Pentair JSAYDLについてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもPentair JSAYDLの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがPentair JSAYDLで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。