-
Boca Systems Muon Liquid Handling System None - page 1
Muon Liquid Handling System User Guide C. Johnson, S.P. Cottrell et al Version 0.2 - 1 - ...
-
Boca Systems Muon Liquid Handling System None - page 2
Contents 1 Getting Started 3 1.1 Layout of the liquid handling system 3 1.2 Layout of the in situ sample stick 4 1.3 Layout of the pump 4 2 General procedures 6 2.1 Sample loading 6 2.1.1 Loading Vessel 1 6 2.1.2 Loading Vessel 2 6 2.2 Evacuation of the system 6 2.2.1 Removing air from Vessel 1 7 2.2.2 Removing air from Vessel 2 7 2.2.3 Removing ai ...
-
Boca Systems Muon Liquid Handling System None - page 3
1 Getting S t arted This manual describes the liquid handling system and the in situ sample cell as use d on the DEVA instrument with the “RF” spect rometer, for either norm al muon spins relaxation or RF resonance experiments. 1.1 Layout of the liquid handling sy stem The Muon Liquid Handling System has been designed to facilitate the in situ ...
-
Boca Systems Muon Liquid Handling System None - page 4
1.2 Layout of the in situ sample stick The liquid sample stick is designed to fit into the DEVA flow cryostat, de tails of which can be found in the DEVA manual. It consists of a shapol target cell 30 mm x 30 mm with a mylar window upon which may be mounted an RF coil. Two stainless steel capillaries provide a mean s of flowing liquid into and out ...
-
Boca Systems Muon Liquid Handling System None - page 5
Roughing/ Turbo switch Off/Run switch Pressure reading Turbo control panel Turbo Pump Rotary Pump Figure 2 The layout of the fr ont panel on t he vacuum pump use d with the m uon liquid handling system. - 5 - ...
-
Boca Systems Muon Liquid Handling System None - page 6
2 General procedures 2.1 Sample loading At this point, the system will be open to the atmo sphere, ensure that valve V2 is closed to prevent air cond ensation in the cold trap. 2.1.1 Loading Vessel 1 • Open the tap on the right-hand side of Vessel 1. • Open tap A and valve V11. • The liquid should be poured into the system very slowly to avoi ...
-
Boca Systems Muon Liquid Handling System None - page 7
2.2.1 Removing air from Vessel 1 Once the system has been pressuris ed, tap A on Vessel 1 can be opened. It is possible to bubbled helium gas through the sample liqui d against the non-retu rn valve, V13. If this is required, first ensure th at valves V 5, V7 and V8 are closed. Open valves V10 and V6, finally opening tap B slowly in order to regula ...
-
Boca Systems Muon Liquid Handling System None - page 8
2.3 Freeze-Pump-Thaw cycle Using this system it is p ossible to op erat e freeze-pump-thaw cycles on sam ple liquids held in any of the three vessels. Procedur es appropriate to ea ch vessel are outlined below. 2.3.1 Sample in Vessel 1 • All taps and valves should be closed. • Open valve V2 and tap A on Vessel 1, and freeze the sample liquid by ...
-
Boca Systems Muon Liquid Handling System None - page 9
2.3.3 Sample in Vessel 3 • All taps and valves should be closed. • Open valves V2 and V3 along with tap C on Vessel 3 and freeze the sample liquid by slowly raising a dewa r of liquid nitrogen around it. • When it has been determined that the liquid ha s completely frozen switch the pump to roughing mode and open valve V1. • Switch the pump ...
-
Boca Systems Muon Liquid Handling System None - page 10
2.4.2 Vessel 3 to sample cell The transfer of liquid from Vessel 3 to the sample cell is brought about by the difference in pressure between that in the Vessel and a vacuum in the cell. However, in order to control the transfer of liquid th e pressure difference shou ld be as small as possible but not so low that the liquid starts to boil. • Swit ...
-
Boca Systems Muon Liquid Handling System None - page 11
2.4.4 Recovery of liquid in sample cell to Vessel 1 The liquid in the sample cell cannot be recovered to Vessel 1 using the liquid handling rig as presently configured. 2.4.5 Recovery of liquid in sample cell to Vessel 2 The liquid in the sample cell can be r ecovered to Vessel 2 using the following procedure. • Vessel 2 should be under vacuum al ...
-
Boca Systems Muon Liquid Handling System None - page 12
• All the liquid may not return in a single pass and repea ting the evacuation procedure may be required. However, some liquid m ay be present in the system and care should be taken during evacuation that th e trap does not become blocked. The liquid may also be encouraged to leave the sample cell by using a small amount of gas. • Close valve V ...
-
Boca Systems Muon Liquid Handling System None - page 13
3 Example Experiment The paramagnetic signal in liquid n-hexane is difficult to observe because the muonium polarisation is found to decay on a microsecond time scale, which is further reduced by the presence of dissolved oxygen. A series of commi ssioning experim ents were carried out using n-hexane in order to gauge the ability of the liquid hand ...
-
Boca Systems Muon Liquid Handling System None - page 14
0.0 0.5 1.0 1.5 2.0 2.5 3.0 11.0 11.5 12.0 12.5 13.0 13.5 Initial asymmetry (%) Time ( µ s) 0.0 0.5 1.0 1.5 2.0 2.5 3.0 11.0 11.5 12.0 12.5 13.0 Initial asymmetry (%) Time ( µ s) 1.5 2.0 2.5 3.0 0.0 0.5 1.0 11.0 11.5 12.0 12.5 13.0 13.5 Initial asymmetry (%) Time ( µ s) a) b) c) Figure 1 Muonium precessio n signal at 2G in n-he xane after a) 4, ...
Boca Systems Muon Liquid Handling System Noneについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもBoca Systems Muon Liquid Handling System Noneの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがBoca Systems Muon Liquid Handling System Noneで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。