Audiovox PRO9801Cの取扱説明書

24ページ 0.38 mb
ダウンロード

ページに移動 of 24

Summary
  • Audiovox PRO9801C - page 1

    128-8794 1 of 24 Page 1 Model PRO9801C Owner ’s Manual IMPORT ANT ! In order to provide you with the highest level of security to your vehicle, this system is equipped with selectable manual override circuitry . It is possible that you will need to override your security system if the transmitter becomes lost, or inoperative due to battery failur ...

  • Audiovox PRO9801C - page 2

    128-8794 2 of 24 Page 2  Protected Push Button LED V alet/Override Switch In Windshield Receiver  7-Function LED-Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / V alet / Arming  Intrusion Alert With Memory  Instant Siren Activation When Used  S t arter Disable Output  Additional Engine Immobilizer Output, (Optional Relay Required)  T ...

  • Audiovox PRO9801C - page 3

    128-8794 3 of 24 Page 3 known as a code grabber , which will receive and store the signal from your keychain transmitter and re-transmit at a later time to disarm your system. Y our Keeloq Code Hopping transmitters will change their signal every time the button is pressed, so when a thief grabs then re-transmits your signal, the alarm system will n ...

  • Audiovox PRO9801C - page 4

    128-8794 4 of 24 Page 4  The dash mounted LED begins to flash slowly .  Parking Lights flash one time.  Siren will not sound. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Clo ...

  • Audiovox PRO9801C - page 5

    128-8794 5 of 24 Page 5  Any mild impact to the vehicle’s glass will cause the alarm to sound a short series of warning tones.  Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle. NOTE: If the optional interior illumination circuit was installed, the interior light will flash as wel ...

  • Audiovox PRO9801C - page 6

    128-8794 6 of 24 Page 6  Parking Lights flash two times. If the parking lights flashed three times, then the alarm was triggered in your absence. Before turning the key on, examine the LED to identify which zone was triggered.  Siren will not sound. If the siren sounds 4 chirps, then the alarm was triggered in your absence. Before turning the ...

  • Audiovox PRO9801C - page 7

    128-8794 7 of 24 Page 7 3 . T o return to normal operation, press and release the Push-Button switch any time the ignition is on. NOTE: Always remember to return the vehicle to the valet off position. This will ensure that the vehicle remains protected at all times. MANUALL Y OVERRIDING YOUR SYSTEM: Using The Receiver's Push-Button Override Sw ...

  • Audiovox PRO9801C - page 8

    128-8794 8 of 24 Page 8 2 . Turn the ignition switch to the on position. 3 . Within 10 seconds, press and release the Receivers Push-button switch, 3 times. 4 . Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will beep and the lights will flash one time.) 5 . Within 10 seconds, begin to press and release the ...

  • Audiovox PRO9801C - page 9

    128-8794 9 of 24 Page 9 NOTE: Y our system must be programmed by the inst allation center to enable this feature. REMOTE P ANIC OPERA TION The Lock or Unlock button on your keychain transmitter also functions as a panic switch for use in emergency situations. T o use remote panic: 1. Press and hold the Lock or Unlock button on the keychain transmit ...

  • Audiovox PRO9801C - page 10

    128-8794 10 of 24 Page 10 T o change or adjust the shock sensor , press and release the ARM button of your keychain transmitter . 1. Within 2 seconds of arming, press and release the ARM button 1 time to defeat the pre-detect stage of the shock sensor . (The lights will flash and the siren will chirp once.) 2. Within 2 seconds of step 1, press and ...

  • Audiovox PRO9801C - page 11

    128-8794 11 of 24 Page 11 lights will flash or turn on depending on the programming set up by your installation center . When you arrive at your vehicle, disarm the alarm system by pressing and releasing the arm/disarm button of your keychain transmitter . Enter the vehicle and turn the ignition key to the on position. NOTE: This system has the abi ...

  • Audiovox PRO9801C - page 12

    128-8794 12 of 24 Page 12 The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated. CANCELING THE AUTOMA TIC ST ART UP TIMER T o cancel the automatic start up timer do one of the following: 1. S tart the vehicle manually with the use of the ignition key and depress the brake pedal. 2. Remote start ...

  • Audiovox PRO9801C - page 13

    128-8794 13 of 24 Page 13 ADDITIONAL REMOTE FUNCTION (CHANNEL 6 ) Channel 6 is an alternate output that can be controlled by the unlock button of the transmitter , or by and independent button or combination of buttons. For your vehicle this output is: Controlled By:  Trunk/Key Button  Option Button  Lock + Unlock Buttons  Lock + Trunk/ ...

  • Audiovox PRO9801C - page 14

    128-8794 14 of 24 Page 14 2. Set the parking, (hand), brake. 3. Be certain your foot is off the brake pedal. 4. Press the receiver's program/Push-Button switch 2 times within 5 seconds. The parking lights will flash two times indicating the mode was successfully entered. If your parking lights flashed four times, this indicates the turbo mode ...

  • Audiovox PRO9801C - page 15

    128-8794 15 of 24 Page 15 NOTE: The engine can be started in many modes armed, disarmed, valet, etc... The screen shown is Locked/Armed and running. When the Panic Mode has been activated and the system is armed, the vehicle's lights will flash, the siren and lock icon will be displayed on the LCD screen and the siren will beep. If the system ...

  • Audiovox PRO9801C - page 16

    128-8794 16 of 24 Page 16 ADDITIONAL ICONS THA T MA Y BE DISPLA YED ARE: If the arm/disarm chirp tones have been turned off at the vehicle, when you arm, or disarm, the display will indicate this as shown and there will be no arm/disarm chirps at the transmitter . This is true if the transmitter is set for vibrate mode. When the vehicle is armed, a ...

  • Audiovox PRO9801C - page 17

    128-8794 17 of 24 Page 17 ADDITIONAL REMOTE FEA TURES: The two way remote control unit allows you to access status information from the vehicle, check temperature, light the display , toggle the transmitter from beep tones to vibrate mode, initiate daily start timer , and temperature start. Selection of these and other features are shown below: NOT ...

  • Audiovox PRO9801C - page 18

    128-8794 18 of 24 Page 18 Note this feature must be activated at the vehicle at the prescribed time. Once activated at the vehicle, you can toggle the feature on by simultaneously pressing the Lock + Option buttons of the transmitter . The 24 hour icon will appear and the transmitter will emit a tone confirming the feature is active. NOTE: The unit ...

  • Audiovox PRO9801C - page 19

    128-8794 19 of 24 Page 19 Battery Indicator: Y our transmitter has a battery indicator that is shown in the upper right corner of the screen as shown left. This icon indicates a new battery shown with 3 bars. As the battery deterio- rates, the bars will disappear . 1 bar indicates the battery should be replaced. Replace battery with a fresh 1.5V AA ...

  • Audiovox PRO9801C - page 20

    128-8794 20 of 24 Page 20 T emperature Start Mode. This icon will appear when the temp start mode is activated. The vehicle will start one time automatically when the temperature reaches 0*. Caution Be certain vehicle is outside before activating this mode. T o toggle this feature on or off, from the Locked/Armed mode, press the Option and Lock but ...

  • Audiovox PRO9801C - page 21

    128-8794 21 of 24 Page 21 ...

  • Audiovox PRO9801C - page 22

    128-8794 22 of 24 Page 22 THIS P AGE LEFT BLANK INTENTIONALL Y ...

  • Audiovox PRO9801C - page 23

    128-8794 23 of 24 Page 23 PRO9801C SYSTEM FUNCTIONS A T A GLANCE DASH LED INDICA TORS RAPID FLASHING = P ASSIVE ARMING/ACTIVE REARMING SLOW FLASHING = ARMED OF F = DISARMED ON SOLID = V ALET MODE 3 FLASH...P AUSE = INT RUSI ON ZON E 3 2 FLASH...P AUSE = INT RUSI ON ZON E 2 1 FLASH...P AUSE = INT RUSI ON ZON E 1 SIREN CHIRP INDICA TORS 1 CHIRP * = A ...

  • Audiovox PRO9801C - page 24

    128-8794 24 of 24 Page 24 © 2010 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-8794 ...

メーカー Audiovox カテゴリー Automobile Alarm

Audiovox PRO9801Cのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- PRO9801Cの取扱説明書
- Audiovoxの製品カード
- パンフレット
- またはAudiovox PRO9801Cの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Audiovox PRO9801Cの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Audiovox PRO9801Cの取り付け説明書、サービスマニュアル、簡易説明書、またはAudiovox PRO9801Cのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Audiovox PRO9801Cの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Audiovox PRO9801Cデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがAudiovox PRO9801Cを使用するのを助ける技術的文書のことです。説明書は通常、全てのAudiovox PRO9801Cユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Audiovoxの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Audiovox PRO9801Cの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははAudiovox PRO9801Cの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Audiovox PRO9801Cに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Audiovox PRO9801Cデバイスの基本機能を使うにあたってのヒント。 Audiovox PRO9801Cのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Audiovox PRO9801Cに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるAudiovox PRO9801Cのメーカー/サービスへの連絡先に関する情報。

Audiovox PRO9801Cについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもAudiovox PRO9801Cの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがAudiovox PRO9801Cで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (1)

Михалис

как установить поперечные реленги на багажник