English dropdown-ico

Manual Audiovox PRO9801C

24 pages 0.38 mb
Download

Go to site of 24

Summary
  • Audiovox PRO9801C - page 1

    128-8794 1 of 24 Page 1 Model PRO9801C Owner ’s Manual IMPORT ANT ! In order to provide you with the highest level of security to your vehicle, this system is equipped with selectable manual override circuitry . It is possible that you will need to override your security system if the transmitter becomes lost, or inoperative due to battery failur ...

  • Audiovox PRO9801C - page 2

    128-8794 2 of 24 Page 2  Protected Push Button LED V alet/Override Switch In Windshield Receiver  7-Function LED-Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / V alet / Arming  Intrusion Alert With Memory  Instant Siren Activation When Used  S t arter Disable Output  Additional Engine Immobilizer Output, (Optional Relay Required)  T ...

  • Audiovox PRO9801C - page 3

    128-8794 3 of 24 Page 3 known as a code grabber , which will receive and store the signal from your keychain transmitter and re-transmit at a later time to disarm your system. Y our Keeloq Code Hopping transmitters will change their signal every time the button is pressed, so when a thief grabs then re-transmits your signal, the alarm system will n ...

  • Audiovox PRO9801C - page 4

    128-8794 4 of 24 Page 4  The dash mounted LED begins to flash slowly .  Parking Lights flash one time.  Siren will not sound. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Clo ...

  • Audiovox PRO9801C - page 5

    128-8794 5 of 24 Page 5  Any mild impact to the vehicle’s glass will cause the alarm to sound a short series of warning tones.  Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle. NOTE: If the optional interior illumination circuit was installed, the interior light will flash as wel ...

  • Audiovox PRO9801C - page 6

    128-8794 6 of 24 Page 6  Parking Lights flash two times. If the parking lights flashed three times, then the alarm was triggered in your absence. Before turning the key on, examine the LED to identify which zone was triggered.  Siren will not sound. If the siren sounds 4 chirps, then the alarm was triggered in your absence. Before turning the ...

  • Audiovox PRO9801C - page 7

    128-8794 7 of 24 Page 7 3 . T o return to normal operation, press and release the Push-Button switch any time the ignition is on. NOTE: Always remember to return the vehicle to the valet off position. This will ensure that the vehicle remains protected at all times. MANUALL Y OVERRIDING YOUR SYSTEM: Using The Receiver's Push-Button Override Sw ...

  • Audiovox PRO9801C - page 8

    128-8794 8 of 24 Page 8 2 . Turn the ignition switch to the on position. 3 . Within 10 seconds, press and release the Receivers Push-button switch, 3 times. 4 . Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will beep and the lights will flash one time.) 5 . Within 10 seconds, begin to press and release the ...

  • Audiovox PRO9801C - page 9

    128-8794 9 of 24 Page 9 NOTE: Y our system must be programmed by the inst allation center to enable this feature. REMOTE P ANIC OPERA TION The Lock or Unlock button on your keychain transmitter also functions as a panic switch for use in emergency situations. T o use remote panic: 1. Press and hold the Lock or Unlock button on the keychain transmit ...

  • Audiovox PRO9801C - page 10

    128-8794 10 of 24 Page 10 T o change or adjust the shock sensor , press and release the ARM button of your keychain transmitter . 1. Within 2 seconds of arming, press and release the ARM button 1 time to defeat the pre-detect stage of the shock sensor . (The lights will flash and the siren will chirp once.) 2. Within 2 seconds of step 1, press and ...

  • Audiovox PRO9801C - page 11

    128-8794 11 of 24 Page 11 lights will flash or turn on depending on the programming set up by your installation center . When you arrive at your vehicle, disarm the alarm system by pressing and releasing the arm/disarm button of your keychain transmitter . Enter the vehicle and turn the ignition key to the on position. NOTE: This system has the abi ...

  • Audiovox PRO9801C - page 12

    128-8794 12 of 24 Page 12 The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated. CANCELING THE AUTOMA TIC ST ART UP TIMER T o cancel the automatic start up timer do one of the following: 1. S tart the vehicle manually with the use of the ignition key and depress the brake pedal. 2. Remote start ...

  • Audiovox PRO9801C - page 13

    128-8794 13 of 24 Page 13 ADDITIONAL REMOTE FUNCTION (CHANNEL 6 ) Channel 6 is an alternate output that can be controlled by the unlock button of the transmitter , or by and independent button or combination of buttons. For your vehicle this output is: Controlled By:  Trunk/Key Button  Option Button  Lock + Unlock Buttons  Lock + Trunk/ ...

  • Audiovox PRO9801C - page 14

    128-8794 14 of 24 Page 14 2. Set the parking, (hand), brake. 3. Be certain your foot is off the brake pedal. 4. Press the receiver's program/Push-Button switch 2 times within 5 seconds. The parking lights will flash two times indicating the mode was successfully entered. If your parking lights flashed four times, this indicates the turbo mode ...

  • Audiovox PRO9801C - page 15

    128-8794 15 of 24 Page 15 NOTE: The engine can be started in many modes armed, disarmed, valet, etc... The screen shown is Locked/Armed and running. When the Panic Mode has been activated and the system is armed, the vehicle's lights will flash, the siren and lock icon will be displayed on the LCD screen and the siren will beep. If the system ...

  • Audiovox PRO9801C - page 16

    128-8794 16 of 24 Page 16 ADDITIONAL ICONS THA T MA Y BE DISPLA YED ARE: If the arm/disarm chirp tones have been turned off at the vehicle, when you arm, or disarm, the display will indicate this as shown and there will be no arm/disarm chirps at the transmitter . This is true if the transmitter is set for vibrate mode. When the vehicle is armed, a ...

  • Audiovox PRO9801C - page 17

    128-8794 17 of 24 Page 17 ADDITIONAL REMOTE FEA TURES: The two way remote control unit allows you to access status information from the vehicle, check temperature, light the display , toggle the transmitter from beep tones to vibrate mode, initiate daily start timer , and temperature start. Selection of these and other features are shown below: NOT ...

  • Audiovox PRO9801C - page 18

    128-8794 18 of 24 Page 18 Note this feature must be activated at the vehicle at the prescribed time. Once activated at the vehicle, you can toggle the feature on by simultaneously pressing the Lock + Option buttons of the transmitter . The 24 hour icon will appear and the transmitter will emit a tone confirming the feature is active. NOTE: The unit ...

  • Audiovox PRO9801C - page 19

    128-8794 19 of 24 Page 19 Battery Indicator: Y our transmitter has a battery indicator that is shown in the upper right corner of the screen as shown left. This icon indicates a new battery shown with 3 bars. As the battery deterio- rates, the bars will disappear . 1 bar indicates the battery should be replaced. Replace battery with a fresh 1.5V AA ...

  • Audiovox PRO9801C - page 20

    128-8794 20 of 24 Page 20 T emperature Start Mode. This icon will appear when the temp start mode is activated. The vehicle will start one time automatically when the temperature reaches 0*. Caution Be certain vehicle is outside before activating this mode. T o toggle this feature on or off, from the Locked/Armed mode, press the Option and Lock but ...

  • Audiovox PRO9801C - page 21

    128-8794 21 of 24 Page 21 ...

  • Audiovox PRO9801C - page 22

    128-8794 22 of 24 Page 22 THIS P AGE LEFT BLANK INTENTIONALL Y ...

  • Audiovox PRO9801C - page 23

    128-8794 23 of 24 Page 23 PRO9801C SYSTEM FUNCTIONS A T A GLANCE DASH LED INDICA TORS RAPID FLASHING = P ASSIVE ARMING/ACTIVE REARMING SLOW FLASHING = ARMED OF F = DISARMED ON SOLID = V ALET MODE 3 FLASH...P AUSE = INT RUSI ON ZON E 3 2 FLASH...P AUSE = INT RUSI ON ZON E 2 1 FLASH...P AUSE = INT RUSI ON ZON E 1 SIREN CHIRP INDICA TORS 1 CHIRP * = A ...

  • Audiovox PRO9801C - page 24

    128-8794 24 of 24 Page 24 © 2010 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-8794 ...

Manufacturer Audiovox Category Automobile Alarm

Documents that we receive from a manufacturer of a Audiovox PRO9801C can be divided into several groups. They are, among others:
- Audiovox technical drawings
- PRO9801C manuals
- Audiovox product data sheets
- information booklets
- or energy labels Audiovox PRO9801C
All of them are important, but the most important information from the point of view of use of the device are in the user manual Audiovox PRO9801C.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Audiovox PRO9801C, service manual, brief instructions and user manuals Audiovox PRO9801C. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Audiovox PRO9801C.

Similar manuals

A complete manual for the device Audiovox PRO9801C, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Audiovox PRO9801C by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Audiovox PRO9801C.

A complete Audiovox manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Audiovox PRO9801C - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Audiovox PRO9801C, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Audiovox PRO9801C, that we can find in the current document
3. Tips how to use the basic functions of the device Audiovox PRO9801C - which should help us in our first steps of using Audiovox PRO9801C
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Audiovox PRO9801C
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Audiovox PRO9801C in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Audiovox PRO9801C?

Use the form below

If you did not solve your problem by using a manual Audiovox PRO9801C, ask a question using the form below. If a user had a similar problem with Audiovox PRO9801C it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (1)

Михалис

как установить поперечные реленги на багажник