日本語 dropdown-ico

Telex FMR-10の取扱説明書

26ページ 0.54 mb
ダウンロード

ページに移動 of 26

Summary
  • Telex FMR-10 - page 1

    Telex â Operating Instructions FMR-10 SERIES WIRELESS USER GUIDE Channel Diversity Audio RF A B 1 234 -20 -10 0 +3 T elex R CLEAR SCAN TM FMR-10 T e l e x P O W E R B A T . N O A U D I O T e l e x W T - 1 0 U H F T R A N S M I T T E R R ...

  • Telex FMR-10 - page 2

    ...

  • Telex FMR-10 - page 3

    T able of Contents Section Page 1. Quick System Setup Guide . . . . . . . . . . . . . . . . . . . . . . . 1 2. System Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 3. Detailed system/component setup instructions . . . . . . . . 4 3.1. FMR-10 Receiver Setup and Operation . . . . . . . . . . 4 3.1.1 Rack Mount Installation . ...

  • Telex FMR-10 - page 4

    T ransmitter Setup T ransmitter Setup 1. Open battery compartment, install 9 Volt battery. Make sure to observe proper battery polarity. 2. Adjust channel setting to match channel number shown on re - ceiver channel display. Replace battery cover. 3. If using bodypack transmitter, plug the microphone into the trans - mitter connector. Operating the ...

  • Telex FMR-10 - page 5

    2. System Description The Telex FMR-10 Wireless is a series of 10 channel frequency agile UHF wireless systems that combine Telex’s legendary quality and reliability with high value. The transmitters and receivers operate in the UHF frequency range. The well-designed audio circuitry ensures excellent signal-to-noise ratio with accurate sound qual ...

  • Telex FMR-10 - page 6

    3. Detailed Setup Instructions 3.1 FMR-10 Receiver Setup & Operation Receiver Setup & Operation 1. Place the receiver where there is a clear line of sight to the area where the transmitter will be used. 2. Attach either the supplied 1/4-wave antennas or two remotely mounted antennas to the antenna connectors on the rear panel of the FMR-10. ...

  • Telex FMR-10 - page 7

    CAUTION: Please make sure that the AC adapter is the cor - rect voltage for your local requirements. 4. ClearScan ™ : The FMR-10 Wireless system features ClearScan ™ . ClearScan ™ automates the process of finding a clear channel to use in setup of your FMR-10 Wireless system. To use ClearScan ™ , depress and hold down the set button for 3 s ...

  • Telex FMR-10 - page 8

    NOTE: If the system is in “lock-out”, ClearScan ™ will not fun ction. 7. Make sure the gain setting is muted or turned down on the mixer or amp channel you will connect the wireless system to. 8. Plug the audio cable (not supplied) into the output connector. NOTE: The 3-pin XLR-type connector output level is fixed, and cannot be adjusted. Now ...

  • Telex FMR-10 - page 9

    3.1.1 Rack Mount Installation 3.1.1 Rack Mount Installation The FMR-10 is supplied with rack mounts for single and double mount - ing in a standard EIA 19”/ 483mm equipment rack (see Figure 3). For rack mounting a single unit, a long and short “ear” are used. For dual side-by-side mounting, use the short “ears” and the mid sized brackets ...

  • Telex FMR-10 - page 10

    2. Install the previously removed screws. Insert an additional screw (provided in the parts pack) into the remaining holes. Tighten all screws securely. 3. Place the two assemblies side-by-side with the mid brackets to - gether. (The left bracket should fit above the right so that the countersinks are visible). Install 4 flat-head screws (Item #5) ...

  • Telex FMR-10 - page 11

    3.1.2 Antenna Placement 3.1.2 Antenna Placement For any wireless system to perform correctly, strong RF signals are mandatory. To maximize signal strength, good antenna placement must be utilized. Although some situations prohibit perfect antenna placement, here are some guidelines: 1. The antennas should be placed in a location with a clear signal ...

  • Telex FMR-10 - page 12

    If antennas are remote-mounted, separating them 6 feet (1.8m) or more and keeping them at least 2 feet (.6m) from other barriers will improve performance (see Figure 8). If you are remote mounting the antennas and require strong signal over a large area, consider using highly directional antennas such as a log-periodic. The ALP-450 available from T ...

  • Telex FMR-10 - page 13

    3.2 Handheld T ransmitter Setup 3.2 Handheld T ransmitter Setup 1. Insert battery. Slide open the hinged battery compartment cover by placing your thumb on the indents of the battery door (at the bottom of the transmitter) and gently pushing down (see Figure 9). Insert the battery, terminal end first, into the compartment, with the smaller positive ...

  • Telex FMR-10 - page 14

    4. Verify Reception. When the transmitter is turned on: (FMR-10) the RF meter will illuminate, indicating that the receiver is pick - ing up the signal. If this does not happen, make sure that the trans - mitter and receiver are set to the same channels. 5. Unmute the audio by sliding the audio switch (immediately be - low the mic element) towards ...

  • Telex FMR-10 - page 15

    3.3 Bodypack T ransmitter Setup T ransmitter Setup 1. Insert battery. Open the hinged battery compartment by placing your thumb or finger on the indent labeled OPEN on the battery door and pushing down, see Figure 11. When inserting the bat - tery, pay attention to the polarity (+/-) and insert the terminals into the battery compartment first. Clos ...

  • Telex FMR-10 - page 16

    3. Turn on the transmitter by sliding the power switch to its on po - sition. Check the condition of the battery by watching the light below the power switch. The red battery light should flash once and then go out. If the light stays on, the battery is weak and should be replaced. 4. Verify reception. When the transmitter is turned on: (FMR-10) th ...

  • Telex FMR-10 - page 17

    8. Adjust the transmit gain if necessary. Gently insert the pro - vided screwdriver or other 3/32-in. 2.4mm screwdriver into the gain adjustment located at the top edge of the battery compart - ment under the door (see Figure 11). The door has to be opened but not swung upward to make adjustments. Turn lightly until the screwdriver tip drops into t ...

  • Telex FMR-10 - page 18

    4. Guidelines/Recommendations for Best Performance Compatibility The receiver and transmitter must be set to the same channel to oper - ate together. Using Multiple Wir eless Systems Using Multiple Wir eless Systems If two or more FMR-10 Wireless and/or other VHF/UHF wireless systems are being used in the same location, proper frequency coordi - na ...

  • Telex FMR-10 - page 19

    Multiple System Setup & Multiple System Setup & ClearScan™ ClearScan ™ is most useful for finding operating frequencies for situ - ations where no more than 2 systems will be used simultaneously. When setting up more than 2 systems, use ClearScan ™ to choose the first channel of operation. Set up subsequent systems following the chann ...

  • Telex FMR-10 - page 20

    Battery Recommendations Battery Recommendations Fresh 9-volt alkaline batteries from a quality manufacturer will yield the best performance from your FMR-10 transmitters. Rechargeable 8.4-volt Ni-cad batteries can be used, but will yield much shorter op - erational time. When the transmitter switch is turned on, the red battery light will flash onc ...

  • Telex FMR-10 - page 21

    -19- 5. T roubleshooting Guide Problem Possible Causes Solutions No audio & no lights on receiver No audio & no Tx ON light on receiver No audio Low audio signal Distorted audio signal Interference Short range or drop-outs Receiver is off Transmitter is off No (or dead) battery in transmitter Faulty battery contacts in transmitter Transmitt ...

  • Telex FMR-10 - page 22

    6. FMR-10 Wir eless Series System T echnical Specifications UHF Receivers: UHF Receivers: FMR-10 Receiver UHF T ransmitters: UHF T ransmitters: WT-10 and HT-10D and HT-10D -20- Receiver Type Synthesized PLL Frequency Range (RF) Selected Frequencies between 710-866 MHz (depending on Country of Operation) Number of Selectable Channels 10 Diversity Tr ...

  • Telex FMR-10 - page 23

    -21- FCC INFORMATION The TELEX Receiver FMR-10 is authorized under Part 15 of the Federal Communication Commission. The Telex WT-10 and HT-10D Transmitters are type Ac - cepted under United States Federal Communications Com - mission Part 74. Licensing of Telex equipment is the user’s responsibility and licensability depends upon the user’s cla ...

  • Telex FMR-10 - page 24

    ACCESSORIES AND REPLACEMENT PARTS Order No. Description 450131 Plastic belt clip for bodypack 63850006 WLM-50 tie clip-horizontal 63850007 WLM-50 tie clip-vertical 64277000 WLM-50 omnidirectional lapel microphone 57013001 WLM-50 foam windscreen 70925001 ELM-22 MicroMini ™ omnidirectional lapel mic 70928001 ELM-22 mic clip 57013001 ELM-22 foam win ...

  • Telex FMR-10 - page 25

    ...

  • Telex FMR-10 - page 26

    R PN 803341 May 2001 Telex Communications Inc., 12000 Portland Ave. South, Bur nsville, MN 55337 (952) 884-4051, (800) 828-6107, Fax: (952) 887-9212 ...

メーカー Telex カテゴリー Microphone

Telex FMR-10のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- FMR-10の取扱説明書
- Telexの製品カード
- パンフレット
- またはTelex FMR-10の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Telex FMR-10の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Telex FMR-10の取り付け説明書、サービスマニュアル、簡易説明書、またはTelex FMR-10のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Telex FMR-10の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Telex FMR-10デバイスの取扱説明書はどのようなものですか？
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがTelex FMR-10を使用するのを助ける技術的文書のことです。説明書は通常、全てのTelex FMR-10ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Telexの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Telex FMR-10の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははTelex FMR-10の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Telex FMR-10に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Telex FMR-10デバイスの基本機能を使うにあたってのヒント。 Telex FMR-10のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Telex FMR-10に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるTelex FMR-10のメーカー/サービスへの連絡先に関する情報。

Telex FMR-10についてご質問がありますか？

次のフォームを使用してください

見つけた説明書を読んでもTelex FMR-10の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがTelex FMR-10で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

Captcha
新しい画像

コメント (0)