English dropdown-ico

Manual FMI (V)S36

20 pages 1.6 mb
Download

Go to site of 20

Summary
  • FMI (V)S36 - page 1

    For more information, visit www .fmiproducts.com SA VE THIS BOOK This book is valuable. In addition to instructing you on how to install and maintain your appliance, it also contains information that will enable you to obtain re- placement parts or accessory items when needed. Keep it with your other important papers. This replace is approved fo ...

  • FMI (V)S36 - page 2

    www .fmiproducts.com 1 1 1026-01J 2 SAFETY W ARNING: Do not install a re pla ce in ser t in th is box unle ss the manufacturer's instructions with the insert specically state this repl ace has been tested for use with this insert. FOR YOUR SAFETY • Do not store or use gasoline or any other ammabl e vapors or liquids in the vicini ...

  • FMI (V)S36 - page 3

    www .fmiproducts.com 1 1 1026-01J 3 SPECIFICA TIONS 0" TO BOTTOM (LEF T SIDE ONLY) OUTSIDE AIR TOP SP ACERS BACK AND SIDES 3/4" AIR SP ACE HEARTH EXTENSION 52" X 16" TO PERPENDICULAR 8" EACH SIDE NO T LESS THAN 12" 1" AIRS P A CE TO COMBUSTIBLE COMBUSTIBLE WA LL BOARD 0" TO MA TERIAL NO COMBUSTIBLE MA TERIAL ...

  • FMI (V)S36 - page 4

    www .fmiproducts.com 1 1 1026-01J 4 FIREPLACE INST ALLA TION FRAMING 1. Fr am e op en ing for fir ep la ce u sin g th e dimensions shown in Figures 1 and 2. 2. If replace is to be installed directly on carpeting, tile (other than ceramic) or any combustible material other than wood ooring, the replace must be in stalled upon a metal or woo ...

  • FMI (V)S36 - page 5

    www .fmiproducts.com 1 1 1026-01J 5 DRAIN P AN (DP36) For outdoor installations, the replace enclo - sure must allow for adequate drainage and fresh air ventilation. It is recommended that a sealed, corrosion resistant catch pan with provision for drainage be installed under the replace within the replace enclosure (see Accessories on page ...

  • FMI (V)S36 - page 6

    www .fmiproducts.com 1 1 1026-01J 6 Figure 6 - Lineal Gain Hemmed End 8" Stainless Inner Pipe 12 3 / 8 " Galvanized Outer Pipe A SSEMBL Y AND INST ALLA TION OF DOUBLE W ALL CHIMNEY SYSTEM Each double wall chimney section consists of a gal vaniz ed outer pipe, a stainl ess steel inne r ue pipe and a wire spacer . The pipe sections must ...

  • FMI (V)S36 - page 7

    www .fmiproducts.com 1 1 1026-01J 7 VENTING INST ALLA TION Continued When connecting chimney directly to the replace, the inner ue pipe section must be installed rst with the l anced side up. The outer pipe sectio n can then be installed over the ue pipe section with the hemmed end up. Press down on each pipe section until the lances se ...

  • FMI (V)S36 - page 8

    www .fmiproducts.com 1 1 1026-01J 8 VENTING INST ALLA TION Continued Figure 9 - Elbow Offset B A Screws FIRESTOP SP ACERS (3600FS-8DM-1) Fire stop spacers are requi red at each poin t wh er e th e chi mne y pe net rat es a oo r spa ce. Their purpose is to establish and maintain th e req uir ed clea ranc e be tw een the ch im ney and the combusti ...

  • FMI (V)S36 - page 9

    www .fmiproducts.com 1 1 1026-01J 9 VENTING INST ALLA TION Continued 14 3 / 8 " (36.5 cm) 30" (76.2 cm) 1" (2.5 cm) 1" (2.5 cm) Minimum Measurements 1" (2.5 cm) Opening "A" Pitch Slope Opening "A" Max. Used Flashing Model No. Flat 0° 15" V6F-8DM 0-6/12 26.6° 16 1 / 8 " V6F-8DM 6/12- 12/12 45. ...

  • FMI (V)S36 - page 10

    www .fmiproducts.com 1 1 1026-01J 10 T erminations with 16" slip pipe sections are available. The R TT -8DM and RTTL-8DM are approved for flashing installations. When nee ded, these adj ust able ter mina tio ns may be used in combinat ion with the pipe asse mbly to achieve the correct chimney height. Note : In the rare instance there is a prob ...

  • FMI (V)S36 - page 11

    www .fmiproducts.com 1 1 1026-01J 11 OPTIONAL GAS LINE INST ALLA TION Figure 19 - Gas Line Knockout Side Firebrick Finished Side Refractory Knockout Plug Outside of Fireplace Gas Line Conduit Insulation Gas Conduit Cover 1/2" Dowel (see Figure 20, page 12). Note : Secure incoming gas line to wood framing to provide rigidity for threaded end . ...

  • FMI (V)S36 - page 12

    www .fmiproducts.com 1 1 1026-01J 12 OPTIONAL GAS LINE INST ALLA TION Continued CAUTION: All gas piping and connections must be tested for leaks after the installation is c om pl et ed . Af te r e ns ur in g that the gas valve is on, apply soap and water solution to all conn ectio ns and joint s. Bubbl es forming show a leak. Correct all leaks at o ...

  • FMI (V)S36 - page 13

    www .fmiproducts.com 1 1 1026-01J 13 The following tips should be followed to as - sure that both the replac e and the glass door retain their beauty and function properly . Both the ue damper and the glass doors must be fully opened before starting the re. This will prov ide sufcie nt combust ion air and maint ain safe temperatures in ...

  • FMI (V)S36 - page 14

    www .fmiproducts.com 1 1 1026-01J 14 P ARTS WOOD BURNING FIREPLACE MODELS S36, S36H, S36R, S36RH, S36-LS, VS36, VS36H, VS36R AND VS36RH 9 26 16 33 27 16 27 4 32 34 19 12 25 20 30 17 8 1 5 21 2 35 18 1 1 14 3 13 22 10 6 31 7 37/38 36 28 29 24 23 15 ...

  • FMI (V)S36 - page 15

    www .fmiproducts.com 1 1 1026-01J 15 KEY NO. P ART NO. DESCRIPTION QTY . 1 106638-01 Insulation Pan 1 2 ** Fireplace T op 1 3 106641-01 Fireplace Surround 1 4 106642-01 Air Rod Retainer 1 5 106643-01 Damper Rod Retainer 1 6 ** Firebox Bottom 1 7 ** Firebox Surround 1 8 ** Air Separator 1 9 See Below Left Refractory 1 10 See Below Right Refractory 1 ...

  • FMI (V)S36 - page 16

    www .fmiproducts.com 1 1 1026-01J 16 Rear Left Side Front Bottom Bottom Right Side KEY NO. P ART NO. DESCRIPTION QTY . 9 106658-03 Left Refractory , T extured White Brick • 1 108164-03 Left Refractory , T extured White Herringbone • 1 106658-02 Left Refractory , T extured Red Brick • • 1 108164-02 Left Refractory , T extured Red Herringbone ...

  • FMI (V)S36 - page 17

    www .fmiproducts.com 1 1 1026-01J 17 TECHNICAL SERVICE Y ou may have furt her qu esti ons a bout i nsta llat ion, o pera tion , or tr oubl esho oting . If s o, co ntact FMI PRODUCTS, LLC at 1-866-328-4537. When calling please have your model and serial numbers of your heater ready . Y ou can also visit FMI PRODUCTS, LLC’s web site at www .fmiprod ...

  • FMI (V)S36 - page 18

    www .fmiproducts.com 1 1 1026-01J 18 ACCESSORIES Continued STORM COLLAR SC1-1 For RT -8DM and RTL-8DM SC2-1 For RTT -8DM and RTTL-8DM ROUND TOP TERMINA TIONS RT -8DM, RTL-8DM ROUND TOP TERMINA TIONS WITH SLIP SECTION RTT -8DM, RTTL-8DM ROUND TOP TERMINA TIONS WITH LOUVERS RTL-8DM OUTSIDE AIR KIT FOR SIDE W ALL INST ALLA TION - AK4 OUTSIDE AIR KIT F ...

  • FMI (V)S36 - page 19

    www .fmiproducts.com 1 1 1026-01J 19 _____________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ _______________________________________ ...

  • FMI (V)S36 - page 20

    1 1 1026-01 Rev . J 02/10 2701 S. Harbor Blvd. Santa Ana, CA 92704 1-866-328-4537 www .fmipr oducts.com ...

Manufacturer FMI Category Indoor Fireplace

Documents that we receive from a manufacturer of a FMI (V)S36 can be divided into several groups. They are, among others:
- FMI technical drawings
- (V)S36 manuals
- FMI product data sheets
- information booklets
- or energy labels FMI (V)S36
All of them are important, but the most important information from the point of view of use of the device are in the user manual FMI (V)S36.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals FMI (V)S36, service manual, brief instructions and user manuals FMI (V)S36. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product FMI (V)S36.

Similar manuals

A complete manual for the device FMI (V)S36, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use FMI (V)S36 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of FMI (V)S36.

A complete FMI manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual FMI (V)S36 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the FMI (V)S36, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the FMI (V)S36, that we can find in the current document
3. Tips how to use the basic functions of the device FMI (V)S36 - which should help us in our first steps of using FMI (V)S36
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with FMI (V)S36
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of FMI (V)S36 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning FMI (V)S36?

Use the form below

If you did not solve your problem by using a manual FMI (V)S36, ask a question using the form below. If a user had a similar problem with FMI (V)S36 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)