Manual Pentair Quasar

12 pages 0.29 mb
Download

Go to site of 12

Summary
  • Pentair Quasar - page 1

    REV. F 1-6-05 1 P/N 98748000 Quasar ™ Light and Return W ater Flow for Above Ground Pools Owners Manual Pentair Water Pool and Spa, Inc. 1620 Hawkins Ave., Sanford, NC 27330 • (919) 566-8000 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400 Visit us on the Internet at: www.pentairpool.com Important Notice Attention Installer. T ...

  • Pentair Quasar - page 2

    P/N 98748000 2 REV. F 1-6-05 SECTION I. IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following. 1. This light can be installed on storable above ground or permanent above ground pools. 2. A storable pool has a maximum water depth of 42 inches and ...

  • Pentair Quasar - page 3

    REV. F 1-6-05 3 P/N 98748000 NOTE Retain the gaskets supplied and keep them accessible. 3. Use the Teflon™ tape provided. Snugly wrap the threaded wall flange in a clockwise direction (as viewed from the back) starting at the edge of the threads; see Figure 2. Work towards the flange lip (overlapping 1/2 of the tape width with each wrap) then bac ...

  • Pentair Quasar - page 4

    P/N 98748000 4 REV. F 1-6-05 NOTE For narrow, interlocking, extruded aluminum wall panels, center flange between the ridges while viewed from the inside of the pool. Add the spacer and additional gasket to the flange before inserting the flange through the wall panel. This is necessary to accommodate a fountain attachment. 1 1 . With the inlet port ...

  • Pentair Quasar - page 5

    REV. F 1-6-05 5 P/N 98748000 1 6 . Now, from inside the pool, push the bulb assembly and flow director with the red cap/plug in place into the fitting body until the bulb assembly/flow director are nearly flush against the inside pool wall. 1 7 . Thread the bulb assembly nut until it just touches the fitting body, then finger tighten. CAUTION Do no ...

  • Pentair Quasar - page 6

    P/N 98748000 6 REV. F 1-6-05 ¿¿¿WHAT IS A GFCI??? A ‘Ground Fault Circuit Interrupter’ is an electrical safety device designed to measure electrical leakage in a circuit. It is far more sensitive than a standard circuit breaker. GFCI equipped breakers and outlet combinations react to unsafe leakage and shut the power off before electrical sh ...

  • Pentair Quasar - page 7

    REV. F 1-6-05 7 P/N 98748000 W ARNING Do not attach or hang anything but this cord from the cord cap through the hole in the body to the transformer housing. Attaching or hanging items from this location can result in failure to the body or the pool wall which can result in serious personal injury and/or property damage. 5 . Reinstall the snap-on c ...

  • Pentair Quasar - page 8

    P/N 98748000 8 REV. F 1-6-05 1 1 . Place the junction box cover on the junction box bottom so that the junction box can more easily snap into the transformer box; see Figure 15. Snap the pieces together, then remove junction box cover. 1 2 . Mount the transformer box on a pool support approximately 18 inches above the ground, in a position accessib ...

  • Pentair Quasar - page 9

    REV. F 1-6-05 9 P/N 98748000 SECTION V. RELAMPING INSTRUCTIONS W ARNING Risk of electric shock. Disconnect power before servicing this unit. Failure to disconnect power can result in death or severe personal injury. 1 . It is desirable to reduce the water level to the lower edge of the flow director. This makes bulb assembly replacement easier, but ...

  • Pentair Quasar - page 10

    P/N 98748000 10 REV. F 1-6-05 8 . Thread the bulb assembly nut until it just touches the fitting body, then finger tighten. CAUTION Do not over tighten as adjustability of flow director may be impaired and/or damage to parts causing leakage may occur. If low director does not rotate by hand, nut is too tight. 9. Take the red cap/plug off and gently ...

  • Pentair Quasar - page 11

    REV. F 1-6-05 11 P/N 98748000 7 . Remove the bulb assembly by pulling on the flow director while pushing the bulb assembly from the outside of the pool. NOTE The fitting body, threaded wall flange and gaskets may remain attached to the pool wall when winterizing, but should be removed if pool is to be stored. 8. For storable pools: remove the trans ...

  • Pentair Quasar - page 12

    P/N 98748000 12 REV. F 1-6-05 SA VE THESE INSTRUCTIONS. Pentair Water Pool and Spa, Inc. 1620 Hawkins Ave., Sanford, NC 27330 • (919) 566-8000 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400 Visit us on the Internet at: www.pentairpool.com © 2004 Pentair Water Pool and Spa Incorporated. All rights reserved. Information in this ...

Manufacturer Pentair Category Swimming Pool

Documents that we receive from a manufacturer of a Pentair Quasar can be divided into several groups. They are, among others:
- Pentair technical drawings
- Quasar manuals
- Pentair product data sheets
- information booklets
- or energy labels Pentair Quasar
All of them are important, but the most important information from the point of view of use of the device are in the user manual Pentair Quasar.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Pentair Quasar, service manual, brief instructions and user manuals Pentair Quasar. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Pentair Quasar.

Similar manuals

A complete manual for the device Pentair Quasar, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Pentair Quasar by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Pentair Quasar.

A complete Pentair manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Pentair Quasar - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Pentair Quasar, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Pentair Quasar, that we can find in the current document
3. Tips how to use the basic functions of the device Pentair Quasar - which should help us in our first steps of using Pentair Quasar
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Pentair Quasar
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Pentair Quasar in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Pentair Quasar?

Use the form below

If you did not solve your problem by using a manual Pentair Quasar, ask a question using the form below. If a user had a similar problem with Pentair Quasar it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)