English dropdown-ico

Manual Denso CLASSIC PLUS 14

26 pages 2.58 mb
Download

Go to site of 26

Summary
  • Denso CLASSIC PLUS 14 - page 1

    T echnical Services Department DSCA P/N: LA990009-1217 Fourth Issue: April 2003 GAC P/N: LA484007-1431 Printed in the U.S.A. DENSO SALES CALIFORNIA, INC. 3900 Via Or o Avenue Long Beach CA 90810-1868 800-264-9573 / 310-834-6352 www .movincool.com OPERA TION MANUAL CLASSIC PLUS 14 and CLASSIC PLUS 26 READ THIS MANUAL CAREFULL Y FOR INSTRUCTIONS ON C ...

  • Denso CLASSIC PLUS 14 - page 2

    LIMITED W ARRANTY DENSO SALES CALIFORNIA, INC. ("DENSO") warrants its MOVINCOOL Products only to the extent stated in its of ficial written warranties. Unless otherwise specifically provided in writing by DENSO, DENSO warrants to end- user that the Products shall be fr ee of defects in materials or workmanship and will function in accorda ...

  • Denso CLASSIC PLUS 14 - page 3

    OPERA TION MANUAL CLASSIC PLUS 14 and CLASSIC PLUS 26 ...

  • Denso CLASSIC PLUS 14 - page 4

    ii ...

  • Denso CLASSIC PLUS 14 - page 5

    iii TABLE OF CONTENTS FOREWORD ............................................................................................ 1 Definition of T erms .......................................................................... 1 GENERAL WARNINGS & CAUTIONS .................................................... 2 INVENTOR Y & ASSEMBL Y ............ ...

  • Denso CLASSIC PLUS 14 - page 6

    iv ...

  • Denso CLASSIC PLUS 14 - page 7

    1 FOREWORD Congratulations on pur chasing the MovinCool portable air conditioner . This manual explains how to assemble, install, operate, and maintain the MovinCool Classic Plus 14 and Classic Plus 26 portable air condi- tioning units. Please r ead this operation manual thoroughly to familiar - ize yourself with the features of the unit and to ens ...

  • Denso CLASSIC PLUS 14 - page 8

    2 GENERAL W ARNINGS & CAUTIONS • All electrical work, if necessary , should only be performed by qualified electrical personnel. Repair to electrical components by non-certified technicians may result in personal injur y and/or damage to the unit. All electrical components replaced must be genuine MovinCool parts, purchased fr om an authorize ...

  • Denso CLASSIC PLUS 14 - page 9

    3 INVENTOR Y & ASSEMBL Y Inventory After unpacking your MovinCool unit, please check to make sur e you have the following items: ❏ Classic Plus 14 or Classic Plus 26 MovinCool Unit (1) ❏ Cool Air Outlet Ducts (2) ❏ Screws (8) ❏ Operation Manual/W arranty Card (1) NOTE: If any of these items were not included in the box or appear damaged ...

  • Denso CLASSIC PLUS 14 - page 10

    4 INVENTOR Y & ASSEMBL Y Assembly  CAUTION: Befor e assembling make sure the unit is on a flat, level surface and the casters ar e in the LOCKED position. (Both the Classic Plus 14 and Classic Plus 26 MovinCool units have locking swivel casters in the front only .) Install each cool air outlet duct using 4 screws each as shown. NOTE: Do not ...

  • Denso CLASSIC PLUS 14 - page 11

    5 INST ALLA TION Choosing and Installation Site  CAUTION: Following are some pr ecautions to consider before choosing your installation site. Please review car efully as improper installation may r esult in personal injury or damage to the unit. • Do not use the unit in areas wher e leakage of flammable gas may occur . • Do not use the unit ...

  • Denso CLASSIC PLUS 14 - page 12

    6 INST ALLA TION (cont.) Moving the Unit Unlock the casters and push the MovinCool unit fr om the front panel edge to a flat, level surface and set the casters back to the LOCKED position. FRONT P ANEL EDGE LOCKED UNLOCKED ...

  • Denso CLASSIC PLUS 14 - page 13

    7 INST ALLA TION (cont.) Plugging in the Unit • Check the pr ongs and sur face of the power cor d plug for dust/dirt. If dust and/or dirt are pr esent, wipe off with a clean, dry cloth. • Check the power cor d, plug and prongs for damage or excess play . If any damage or excess play is found, contact your MovinCool r eseller for r epair . • F ...

  • Denso CLASSIC PLUS 14 - page 14

    8 FEA TURES Both models feature: • An electronic contr ol panel which allows the user to control the unit’ s operation easily . • Dual fan speeds (either High or Low) in both COOL and Fan Only modes. •A digital display that indicates the temperatur e SET POINT (either Fahrenheit or Celsius) in which the COOL Mode will operate. This is also ...

  • Denso CLASSIC PLUS 14 - page 15

    9 OPERA TION Control Panel Befor e operating the unit, it is impor tant to familiarize yourself with the basic controls located on the contr ol panel. ➀ C OOL ON/OFF Activates/deactivates the COOL mode/ Button turns the unit off. ➁ F AN ON/OFF Activates/deactivates the HIGH or LOW Buttons fan mode. ➂ SE T TEMP Incr eases/decreases the tempera ...

  • Denso CLASSIC PLUS 14 - page 16

    10 OPERA TION (cont.) Operating in COOL Mode The unit can be operated in COOL mode by pr essing the COOL ON/OFF button (LED illuminates). NOTE: In COOL mode the unit can only be turned off by pressing the COOL ON/OFF button again, not by pressing the fan buttons. ➀ Change the fan speed by pr essing the HIGH or LOW fan buttons. ➁ Change the temp ...

  • Denso CLASSIC PLUS 14 - page 17

    11 OPERA TION (cont.) Operating Modes Both Classic Plus models operate in 2 modes, F AN Only and COOL . When in F AN Only mode the unit circulates the surrounding air . When in COOL mode, the compressor is engaged and cool air is circulated. ■ COOL Mode Both models will operate in F AN Only mode for approximately 120 seconds before the compr esso ...

  • Denso CLASSIC PLUS 14 - page 18

    12 OPERA TION (cont.) Emptying the Drain T ank During COOL mode, condensate will accumulate in the drain tank. When the drain tank becomes full, the FULL T ANK LED will flash and the unit will shut off automatically . NOTE: If you want to empty the drain tank, while the unit is in operation, press the COOL ON/OFF button to turn the unit off. CAP ? ...

  • Denso CLASSIC PLUS 14 - page 19

    13 OPERA TION (cont.) DRAIN PUMP KIT (Optional) (Classic Plus 14 model ONL Y) A drain pump kit (CPK-3) is available to allow continuous operation and to eliminate the need for a drain tank. • When the water collects to level (A) in the pump reservoir , the drain pump begins to operate and dischar ge the water . DISCHARGE HOSE DRAIN PUMP DRAIN PUM ...

  • Denso CLASSIC PLUS 14 - page 20

    14 OPERA TION (cont.) DRAIN PUMP KIT (Optional) (Classic Plus 26 model ONL Y) A drain pump kit (CPK-4) is available to allow continuous operation and to eliminate the need for a drain tank. • When the water collects to level (A) in the pump reservoir , the drain pump begins to operate and dischar ge the water . DISCHARGE HOSE DRAIN PUMP DRAIN PUM ...

  • Denso CLASSIC PLUS 14 - page 21

    15 DAIL Y INSPECTION & MAINTENANCE Emptying the Drain T ank To empty the drain tank, refer to instructions on page 12. Cleaning the Air Filters Clean the air filters once a week. If the unit is used in a dusty environ- ment, mor e frequent cleaning may be requir ed. A dirty air filter reduces air output r esulting in a decrease in cooling capac ...

  • Denso CLASSIC PLUS 14 - page 22

    16 DAIL Y INSPECTION & MAINTENANCE (cont.) In-Season/Off-Season Inspection & Maintenance ■ In-Season ➀ Check the prongs and surface of the power cor d plug for dust and/or dirt. If dust and/or dirt are pr esent, wipe off with a clean, dry cloth. ➁ Check the power cord, plug and pr ongs for damage or excess play . If any damage or exce ...

  • Denso CLASSIC PLUS 14 - page 23

    17 Self-Diagnostic Codes Self-Diagnostic Codes will be displayed on the Contr ol Board under the following conditions: Code Condition dF When the evaporator thermistor disengages the compr essor . FL When the drain tank switch shuts off the unit ( FULL T ANK LED flashes). AS When unit disengages the com- pressor while the condensate pump is dischar ...

  • Denso CLASSIC PLUS 14 - page 24

    18 TECHNICAL SPECIFICA TIONS MODEL ITEM/FEA TURES Classic Plus 14 Classic Plus 26 Rating Conditions dry bulb 95 o F (35 o C) 95 o F (35 o C) wet bulb 83 o F (28.3 o C) 83 o F (28.3 o C) humidity (60%) (60%) Specifications power frequency 60Hz 60Hz line voltage, single phase 115 V 208/230V power consumption 1.41 Kw 3.37/3.24 Kw current consumption 1 ...

  • Denso CLASSIC PLUS 14 - page 25

    LIMITED W ARRANTY DENSO SALES CALIFORNIA, INC. ("DENSO") warrants its MOVINCOOL Products only to the extent stated in its of ficial written warranties. Unless otherwise specifically provided in writing by DENSO, DENSO warrants to end- user that the Products shall be fr ee of defects in materials or workmanship and will function in accorda ...

  • Denso CLASSIC PLUS 14 - page 26

    T echnical Services Department DSCA P/N: LA990009-1217 Fourth Issue: April 2003 GAC P/N: LA484007-1431 Printed in the U.S.A. DENSO SALES CALIFORNIA, INC. 3900 Via Or o Avenue Long Beach CA 90810-1868 800-264-9573 / 310-834-6352 www .movincool.com OPERA TION MANUAL CLASSIC PLUS 14 and CLASSIC PLUS 26 READ THIS MANUAL CAREFULL Y FOR INSTRUCTIONS ON C ...

Manufacturer Denso Category Air Conditioner

Documents that we receive from a manufacturer of a Denso CLASSIC PLUS 14 can be divided into several groups. They are, among others:
- Denso technical drawings
- CLASSIC PLUS 14 manuals
- Denso product data sheets
- information booklets
- or energy labels Denso CLASSIC PLUS 14
All of them are important, but the most important information from the point of view of use of the device are in the user manual Denso CLASSIC PLUS 14.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Denso CLASSIC PLUS 14, service manual, brief instructions and user manuals Denso CLASSIC PLUS 14. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Denso CLASSIC PLUS 14.

Similar manuals

A complete manual for the device Denso CLASSIC PLUS 14, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Denso CLASSIC PLUS 14 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Denso CLASSIC PLUS 14.

A complete Denso manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Denso CLASSIC PLUS 14 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Denso CLASSIC PLUS 14, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Denso CLASSIC PLUS 14, that we can find in the current document
3. Tips how to use the basic functions of the device Denso CLASSIC PLUS 14 - which should help us in our first steps of using Denso CLASSIC PLUS 14
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Denso CLASSIC PLUS 14
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Denso CLASSIC PLUS 14 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Denso CLASSIC PLUS 14?

Use the form below

If you did not solve your problem by using a manual Denso CLASSIC PLUS 14, ask a question using the form below. If a user had a similar problem with Denso CLASSIC PLUS 14 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)