English dropdown-ico

Manual Carrier 30MPA

16 pages 3.64 mb
Download

Go to site of 16

Summary
  • Carrier 30MPA - page 1

    Manufacturer reserves the right to disco ntinue, or change at any time, specifications or de signs without not ice and without inc urring obligations. Catalog No . 04-533000 54-01 Printed in U .S.A. Fo rm 30MP-1SI Pg 1 910 1-10 Replaces: Ne w Installation Instr uctions CONTENTS Page GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Carrier 30MPA - page 2

    2 INST ALLA TION Location — Do not store units in an area exposed to weath- er because of sensitive contro l mechanisms and electronic devices. Locate unit indoors. See Fig. 4 and 5 for unit dimen- sional details. When considering location, consult National Electrical Code (NEC) and local code requirements. Allow sufficient space for wiring, pipi ...

  • Carrier 30MPA - page 3

    3 52.30 1328 [] STD UNIT 55.00 1397 [] OPTIONAL SOUND ENCLOSURE 57.00 [1448] 29.13 740 [] STD UNIT 32.00 813 [] 62.50 1588 [] OPTIONAL SOUND ENCLOSURE 32.12 [816] MOBILITY KIT (WHEEL) OPTIONAL 3.85 98 [] E D F OPTIONAL SOUND ENCLOSURE 48.42 [1230] OPTIONAL SOUND ENCLOSURE 65.05 [1652] 4.00 [102] ISOLATOR-OPTIONAL C B A 4.03 102 [] 1.75 44 [] 4.46 [ ...

  • Carrier 30MPA - page 4

    4  Fig. 5 — Dimensions — 30MPW015-045 Units NO TES: 1. Operating weight includes w eight of water and refrigerant. 2. Denotes center of gravity . 3. Dimensions are shown in inc hes. Dimensions in [ ] are in millimeters . 4. Allow 36-in. (914 mm) clear ance on control panel end, opposite control panel end and a b ov e the unit. All clearan ...

  • Carrier 30MPA - page 5

    5 Table 1A — 30MPA Air-Cooled and 30MPW Liquid-Cooled Unit s — English * With optional hot gas b ypass. NO TES: 1. Operating weight includes refrigerant operating charge and weight of fluid in the heat exchangers. 2. 30MPW units are shipped with full operating charge. UNIT 30MP A,MPW 015 020 030 040 045 NOMINAL T ON S 15 20 30 40 45 OPERA TING ...

  • Carrier 30MPA - page 6

    6 T abl e 1B — 30MPA Air-Cooled a nd 30MPW Liquid-Cooled Units — SI * With optional hot gas b ypass. NO TES: 1. Operating weight includes refrigerant operating charge and weight of fluid in the heat exchangers. 2. 30MPW units are shipped with full operating charge. UNIT 30MP A,MPW 015 020 030 040 045 NOMINAL KW 54 71 10 8 13 8 161 OPERA TING WT ...

  • Carrier 30MPA - page 7

    7 Step 3 — Place the Unit NOTE: These units ar e not suitable for unpr otected outdoor use . Carrier recommends that these units be located in the base- ment or on the ground floor . However , if it is necessary to lo- cate the unit on an upper floor , be sure the structure has been designed to support the unit weight. If necessary , add structur ...

  • Carrier 30MPA - page 8

    8 NO TES: 1. Chiller must b e installed le v el to maintain proper compressor oil return. 2. Wiring and pip ing shown are general points-of- connection guides only and are not intended for a spe- cific installation. Wiring and piping shown are f or a q uick ov erview of system and are not in accordance with recognized standards. Units should b e in ...

  • Carrier 30MPA - page 9

    9 NO TES: 1. Chiller must b e installed lev el to maintain proper compr essor oil return. 2. Wir ing and piping show n are general poi nts-of-connection guides only and ar e not intended for a specific installa tion. Wiring and pip- ing shown are f or a q uic k ov erview of system and are no t in accor- dance with recognize d standards . Units shou ...

  • Carrier 30MPA - page 10

    10 3. Install the inside coupling half over the gasket and then install the outer half. Connect with nuts and bolts. T ighten the nuts equally on both sides. Ensure there is no gap be- tween the two halves of the coupling. 4. Alternately tighten the nuts with a wrench to draw the coupling halves together uniformly . The joint is now complete. 30MPW ...

  • Carrier 30MPA - page 11

    11 120 1 100 80 e Drop (kPa) 40 60 Water Pressur e 20 0 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Liters/second 12 3 5 4 40 30 35 1 5 4 3 2 25 30 Drop () 15 20 Water Pressure 5 10 0 0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170 180 190 200 210 220 230 240 GPM Fig. 11 — Condenser W ater Pressure Drop ENGLISH SI LEGEND 1 — 30MP015 2 ...

  • Carrier 30MPA - page 12

    12 120 3 100 1 80 e Drop (kPa) 40 60 Water Pressur e 20 0 0123456789 1 0 1 1 1 2 1 3 Liters/second 1 2 3 4 5 0 5 10 15 20 25 30 35 40 0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170 180 190 200 Water Pressure Drop () GPM 15 4 3 2 Fig. 12 — Ev aporator W ater Pressure Drop ENGLISH SI LEGEND 1 — 30MP015 2— 30MP020 3— 30MP030 4 ...

  • Carrier 30MPA - page 13

    13 Step 6 — Fill the Chilled W ater Loop W A TER SYSTEM CLEANING — P r o pe r wa t e r sy s t em cleaning is of vital importance. Excessive particulates in the water system can cause excessive pump seal wear , reduce or stop flow , and cause damage of other com ponents. W ater quality should be maintained within the limits indicated in T able 2 ...

  • Carrier 30MPA - page 14

    14 Ensure the following when filling the system: 1. Remove temporary bypass piping and cleaning/flushing equipment. 2. Check to make sure all drain plugs are installed. 3. Open the blow-down valve to flush the strainer . Normally , a closed system needs to be filled only once. The actual filling process is generally a fairly simple procedure. All a ...

  • Carrier 30MPA - page 15

    15 EXAMPLE: Supply voltage is 240-3-60. AB = 243 v BC = 236 v AC = 238 v A verage V oltage = 243 + 236 + 238 3 = 239 v Determine maximum deviation from average voltage: (AB) 243 – 239 = 4 v (BC) 239 – 236 = 3 v (AC) 239 – 238 = 1 v Maximum deviation is 4 v . Determine percent voltage imbalance: % V oltage Imbalance = 100 x 4 239 =1 . 7 % This ...

  • Carrier 30MPA - page 16

    Manufacturer reserves the right to disco ntinue, or change at any time, specificatio ns or designs without notice and without inc urring obligations. Catalog No . 04-53300054-0 1 Printed in U .S.A. Form 30MP-1SI Pg 16 910 1-10 Replaces: Ne w Copy right 2010 Carrier Cor poration Fig. 16 — T y pical Low V oltag e Control Wiring NO TES: 1. F actory ...

Manufacturer Carrier Category Refrigerator

Documents that we receive from a manufacturer of a Carrier 30MPA can be divided into several groups. They are, among others:
- Carrier technical drawings
- 30MPA manuals
- Carrier product data sheets
- information booklets
- or energy labels Carrier 30MPA
All of them are important, but the most important information from the point of view of use of the device are in the user manual Carrier 30MPA.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Carrier 30MPA, service manual, brief instructions and user manuals Carrier 30MPA. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Carrier 30MPA.

Similar manuals

A complete manual for the device Carrier 30MPA, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Carrier 30MPA by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Carrier 30MPA.

A complete Carrier manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Carrier 30MPA - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Carrier 30MPA, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Carrier 30MPA, that we can find in the current document
3. Tips how to use the basic functions of the device Carrier 30MPA - which should help us in our first steps of using Carrier 30MPA
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Carrier 30MPA
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Carrier 30MPA in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Carrier 30MPA?

Use the form below

If you did not solve your problem by using a manual Carrier 30MPA, ask a question using the form below. If a user had a similar problem with Carrier 30MPA it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)