Manual Fluke 5623A

17 pages 0.09 mb
Download

Go to site of 17

Summary
  • Fluke 5623A - page 1

    5623A Platinum Resistance Thermometer User’ s Guide Rev. 5A1101 Hart Scientific ...

  • Fluke 5623A - page 2

    Rev. 5A1101 Fluke Corporation, Hart Scientific Division • 799 E. Utah Valley Drive • American Fork, UT 84003-9775 • USA Phone: +1.801.763.1600 • Telefax: +1.801.763.1010 • E-mail: support@ hartscientific.com www.hartscientific.com Subject to change without notice. • Copyright © 2004 • Printed in USA ...

  • Fluke 5623A - page 3

    T able of Contents 1 Before Y ou Start ............................1 1.1 Symbols Used ........................................ 1 1.2 Safety Information ..................................... 2 1.2.1 Warnings ................................................... 2 1.2.2 Cautions ................................................... 2 1.3 Hart Scientific ...

  • Fluke 5623A - page 4

    ii Figures Figure 1 PRT Schematic ......................................... 9 ...

  • Fluke 5623A - page 5

    iii T ables T able 1 International Electrical Symbols ................................ 1 T able 2 Specifications ......................................... 7 ...

  • Fluke 5623A - page 6

    1 Before Y ou Start 1.1 Symbols Used T able 1 list s the International Electrical Symbol s. Some or all of these symbols may be used on the instrument or in this manu al. Symbol Description AC (Alternating Current) AC-DC Battery CE Complies with European Union Directives DC Double Insulated Electric Shock Fuse PE Ground Hot Surface (Burn Hazard) Re ...

  • Fluke 5623A - page 7

    Symbol Description Canadian Standards Association OVERVOL T AGE (Installation) CA TEGORY II, Pollution Degree 2 per IEC1010-1 refers to the level of Impulse Withstand Voltage protection provided. Equipment of OVER VOL TAGE CA TE - GORY II is energy-consuming equipment to be supplied from the fixed installation. Exam - ples include household, office ...

  • Fluke 5623A - page 8

    • Keep the shipping container in case it is necessary to ship the PR T . Incor - rect packaging of the PR T for shipment can cause irreparable damage. 1.3 Hart Scientific Authorized Ser vice Centers Please contact one of the follo wing authorized Service Centers to coordinate service on your Hart product: Hart Scientific, Inc. 799 E. Utah V alley ...

  • Fluke 5623A - page 9

    Fluke South East Asia Pte Ltd. Fluke ASEAN Regional Of fice Service Center 83 Clemenceau A venue #15-15/06 Ue Square 239920 SINGAPORE Phone: +65-737-2922 T elefax: +65-737-5155 E-mail: antng@singa.fluke.com When contacting these Service Cente rs for support, please hav e the follo wing information av ailable: • Model Number • Serial Number • ...

  • Fluke 5623A - page 10

    2 Introduction 2.1 General The Platinum Resist ance Thermometers (PR T) model 5623A is designed to be a secondary standard interpolat ing instr ument con verting temperature to resis - tance. The 5623A assembly design all ows for e xposure to very cold tempera - ture (–200°C) and is an i deal reference for veri fication, monitoring or calibratin ...

  • Fluke 5623A - page 11

    3 Specifications and W arranty 3.1 Specifications See T able 2. Temperature Range –200°C to 156°C Entire Assembly Range –200°C to 156°C Accuracy (Includes calibration uncertainty and short-term stability) ±0.05°C (full range) Long-term Drift (°C) <±0.01 at 0°C per year, when used periodically at 200 Hysteresis (°C) <0.01 Tempera ...

  • Fluke 5623A - page 12

    T o exercise this warranty , the purchas er must forward the product after calling or writing an Autho rized Hart Scientific Service Center (see Section 1.3 on page 3) for authorization. The Service Center assumes NO risk for in-transit damage. THE FOREGOING W ARRANTY IS PURCHASER’S SOLE AND EXCLU - SIVE REMED Y AND IS IN LIEU OF ALL O THER W ARR ...

  • Fluke 5623A - page 13

    4 Installation 4.1 Lead Wire Identification The 5623A PR T is equipped with a four-wi re cable (see Figure 1). Four lead wires are used to cancel lead wire resistance. For best results, the readout de - vice should be equipped to handle four -terminal resistors. The lead wires are two dif ferent colors. Lead wire pairs attached to each end of the s ...

  • Fluke 5623A - page 14

    5 PR T Care and Handling Guidelines 5.1 PR T Care CA UTION: READ THIS SECTION BEFORE REMOVING THE PRT FR OM THE SHIPPING BOX OR CASE Care must be taken i n handling the PR T to maintain calibration accuracy . Care should still be used when handling the PR T ev en though the Inconel sheath is durable and provi des good protection for the sensor . Co ...

  • Fluke 5623A - page 15

    • DO NO T scre w a clamp down so tight that it dents the sheath. This can permanently damage the PR T . 12 Hart Scientific 5 PRT Care and Handling Guidelines ...

  • Fluke 5623A - page 16

    6 Operation 6.1 General For best results, be familiar with the operatio n of the heat source and the read-out instrument. Be sure to follo w the manufacturer’ s instructions for the read-out instrument and the heat source. 6.2 Immersion Requirements Stem effect can cause measurement erro rs for an y thermometer not immersed in the fluid at least ...

  • Fluke 5623A - page 17

    7 T roubleshooting 7.1 T roubleshooting In the e vent that the probe appears to function abnormall y , this section may be of use in solving the problem. Se veral possi ble problem conditions are de - scribed along with likely causes and solutions. If a problem arises, please read this section carefully and a ttempt to understand and sol ve the pro ...

Manufacturer Fluke Category Thermometer

Documents that we receive from a manufacturer of a Fluke 5623A can be divided into several groups. They are, among others:
- Fluke technical drawings
- 5623A manuals
- Fluke product data sheets
- information booklets
- or energy labels Fluke 5623A
All of them are important, but the most important information from the point of view of use of the device are in the user manual Fluke 5623A.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Fluke 5623A, service manual, brief instructions and user manuals Fluke 5623A. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Fluke 5623A.

Similar manuals

A complete manual for the device Fluke 5623A, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Fluke 5623A by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Fluke 5623A.

A complete Fluke manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Fluke 5623A - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Fluke 5623A, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Fluke 5623A, that we can find in the current document
3. Tips how to use the basic functions of the device Fluke 5623A - which should help us in our first steps of using Fluke 5623A
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Fluke 5623A
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Fluke 5623A in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Fluke 5623A?

Use the form below

If you did not solve your problem by using a manual Fluke 5623A, ask a question using the form below. If a user had a similar problem with Fluke 5623A it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)