English dropdown-ico

Manual Troy-Bilt TB525CS

28 pages 8.35 mb
Download

Go to site of 28

Summary
  • Troy-Bilt TB525CS - page 1

    Operator’ s Manual 4-Cycle Gas T rimmer TB525CS T ABLE OF CONTENTS Service Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Rules for Safe Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Know Y our Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Troy-Bilt TB525CS - page 2

    READ ALL INSTRUCTIONS BEFORE OPERA TING • Read the instructions carefully . Be familiar with the controls and proper use of the unit. • Do not operate this unit when tired, ill, or under the influence of alcohol, drugs, or medication. • Children and teens under the age of 15 must not use the unit, except for teens guided by an adult. • All ...

  • Troy-Bilt TB525CS - page 3

    RULES FOR SAFE OPERA TION • SAFETY AND INTERNA TIONAL SYMBOLS • This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety , assembly , operating, maintenance, and repair information. • SAFETY ALERT SYMBOL Indicates danger , war ni ...

  • Troy-Bilt TB525CS - page 4

    OIL AND FUEL INFORMA TION 4 INST ALL CUTTING ATT ACHMENT SHIELD Use the following instructions if the cutting attachment shield on your unit is not installed. Use only the instructions that apply to the type of shaft and shield that your unit is equipped with. INST ALLING THE CUTTING HEAD SHIELD 1. Place the cutting attachment shield onto the shaft ...

  • Troy-Bilt TB525CS - page 5

    5 OPERA TING INSTRUCTIONS OPERA TING THE EZ-LINK™ SYSTEM The EZ-Link™ system enables the use of these optional Add-Ons: Mach 4 ® T rimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AF720 Hedge T rimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Troy-Bilt TB525CS - page 6

    3. Wash the filter in deter gent and water (Fig. 31). Rinse the filter thoroughly and allow it to dry . 4. Apply enough clean SAE 30 motor oil to lightly coat the filter (Fig. 32). 5. Squeeze the filter to spread and remove excess oil (Fig. 33). 6. Replace the filter (Fig. 34). NOTE: If the unit is operated without the air filter , you will VOID th ...

  • Troy-Bilt TB525CS - page 7

    6. Pull the starter rope slowly to bring the piston to the top of its travel, (known as top dead center). Check that: • The piston is at the top of its travel while looking in the spark plug hole (Fig. 37). • Both rocker arms move freely , and both valves are closed. If these statements are not true, repeat this step. 7. Slide the feeler gauge ...

  • Troy-Bilt TB525CS - page 8

    8 NOTES ...

  • Troy-Bilt TB525CS - page 9

    NE RETOURNEZ P AS CE PRODUIT Pour une assistance, veuillez appeler le 1-800-828-5500 (E.U.) ou le 1-800-668-1238 (Canada) ou visitez le site : www .troybilt.com Manuel de L ’utilisateur Désherbeuse à gaz à 4-temps TB525CS T ABLE DES MA TIÈRES Service technique . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .F1 Consign ...

  • Troy-Bilt TB525CS - page 10

    CONSIGNES DE SÉCURITÉ LIRE TOUTES LES INSTRUCTIONS A V ANT UTILISA TION • V euillez lire les instructions avec soin. Familiarisez-vous avec les commandes et l'utilisation correcte de cet appar eil. • N'utilisez pas l'appareil si vous êtes fatigué, malade ou sous l'ef fet de l'alcool, de drogues ou de médicaments. ? ...

  • Troy-Bilt TB525CS - page 11

    CONSIGNES DE SÉCURITÉ SYMBOLES DE SÉCURITÉ ET INTERNA TIONAUX Ce manuel de l'utilisateur décrit les symboles et pictogrammes de sécurité et internationaux pouvant apparaître sur ce produit. Consultez le manuel de l'utilisateur pour les informations concernant la sécurité, le montage, le fonctionnement, l'entretien et les r? ...

  • Troy-Bilt TB525CS - page 12

    INST ALLATION DU PROTECTEUR D'ACCESSOIRE DE COUPE Suivez les instructions suivantes si le protecteur d'accessoire de coupe n'est pas installé sur l'appareil. INST ALLATION DU PROTECTEUR D'ACCESSOIRE DE COUPE 1. Placez le protecteur d'accessoire de coupe sur le corps de l'arbre au-dessus de l'ensemble de brid ...

  • Troy-Bilt TB525CS - page 13

    F5 MODE D'EMPLOI • Le bras gauche est droit et la main tient la poignée. • L'appareil est au-dessous de la ceinture. • L'accessoire de coupe est parallèle au sol et touche facilement la végétation sans que l'opérateur ne doive se pencher . RÉGLAGE DE LA LONGUEUR DU FIL L'accessoire de coupe Bump Head MC vous per ...

  • Troy-Bilt TB525CS - page 14

    VÉRIFICA TION DU NIVEAU D'HUILE Nous ne saurions trop insister sur l'importance de la vérification du niveau d'huile du carter moteur et de son maintien. Vérifiez l'huile avant chaque utilisation: 1. Arrêtez le moteur et laissez l’huile s’écouler dans le carter moteur . 2. Placez la machine sur une surface plane avec le ...

  • Troy-Bilt TB525CS - page 15

    F7 ENTRETIEN ET RÉP ARA TIONS 6. Tirez lentement sur la corde de démarrage pour ramener le piston au sommet de sa course dit « point mort haut ». Vérifiez que: • Le piston est au sommet de sa course lorsqu’on regarde par le trou de la bougie (Fig. 37) • Les deux culbuteurs se déplacent librement et les deux soupapes sont fermées Si ce ...

  • Troy-Bilt TB525CS - page 16

    F8 NOTES ...

  • Troy-Bilt TB525CS - page 17

    Recortador de 4 Ciclos a Gasolina TB525CS P ART NO. 769-04579 P01 (2/09) Manual del Operador INDICE DE CONTENIDOS Llamadas a apoyo al cliente . . . . . . . . . . . . . . . . . . . . . . . . . . . . E1 Normas para una operación segura . . . . . . . . . . . . . . . . . . . . . . E2 Conozca su unidad . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Troy-Bilt TB525CS - page 18

    LEA TODAS LAS INSTRUCCIONES ANTES DE LA OPERACION • Lea todas las instrucciones con cuidado. Conozca bien los controles y el uso correcto de la unidad. • No opere esta unidad si está cansado, enfermo, o bajo los efectos del alcohol, drogas o medicamentos. • Los niños y los adolescentes menores de 15 años no deben operar las unidades, excep ...

  • Troy-Bilt TB525CS - page 19

    NORMAS P ARA UNA OPERACIÓN SEGURA • SIMBOLOS DE SEGURIDAD E INTERNACIONALES • Este manual del operador describe los símbolos y figuras de seguridad e internacionales que pueden aparecer en este producto. Lea el manual del operador para obtener información completa acerca de la seguridad, ensamble, operación y mantenimiento y r eparación. ? ...

  • Troy-Bilt TB525CS - page 20

    TIPO DE ACEITE RECOMENDADO El uso de un aceite del tipo y peso correctos en el cigüeñal es extremadamente importante. V erifique el aceite antes de cada uso y cambie el aceite con frecuencia. Si no usa el aceite correcto, o utiliza aceite sucio, puede causar el desgaste y falla prematuros del motor . Use un aceite de buena calidad SAE 30 de API ( ...

  • Troy-Bilt TB525CS - page 21

    INST ALACIÓN DE LA LÍNEA Utilice siempre línea de reemplazo de 2.41 mm (0.095 pulg) del fabricante de equipo original. NOT A: Es posible que sea necesario quitar la línea vieja antes de instalar la nueva. De ser así, consulte la sección Remoción de la línea vieja o de obstrucciones. 1. Alinee las flechas de la perilla del cabezal de corte c ...

  • Troy-Bilt TB525CS - page 22

    AJUSTE DEL CARBURADOR La velocidad mínima del motor puede ser ajustada. Puede tener acceso al tornillo de ajuste de mínima a través de un orificio en la parte superior de la cubierta del motor (Fig. 35). NOT A: Los ajustes descuidados pueden dañar su motor seriamente. Los ajustes del carburador deben ser realizados por un proveedor de servicio ...

  • Troy-Bilt TB525CS - page 23

    2. Arranque el motor y déjelo funcionar hasta que se ahogue. Esto asegura que toda la gasolina se haya drenado del carburador . 3. Deje enfriar el motor . Saque la bujía de encendido y coloque 5 gotas de aceite de motor de buena calidad en el cilindro. Tire de la cuer da de arranque lentamente para distribuir el aceite. Vuelva a instalar la bují ...

  • Troy-Bilt TB525CS - page 24

    CAUSA ACCIÓN El accesorio de corte está atascado de hierba Pare el motor y limpie el accesorio de corte El filtro de aire está sucio Limpie o cambie el filtro de aire Parachispas obstruido Limpie o cambie el parachispas CAUSA ACCIÓN El combustible es viejo Drene el tanque de gasolina / Agregue combustible nueva El accesorio de corte está atasc ...

  • Troy-Bilt TB525CS - page 25

    E9 NOTES ...

  • Troy-Bilt TB525CS - page 26

    E10 NOTES ...

  • Troy-Bilt TB525CS - page 27

    E11 NOTES ...

  • Troy-Bilt TB525CS - page 28

    The limited warranty set forth below is given by T roy-Bilt LLC (“TROY -BIL T”) with respect with new merchandise purchased and used in the United States, its possessions and territories. TROY -BIL T warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and wi ...

Manufacturer Troy-Bilt Category Trimmer

Documents that we receive from a manufacturer of a Troy-Bilt TB525CS can be divided into several groups. They are, among others:
- Troy-Bilt technical drawings
- TB525CS manuals
- Troy-Bilt product data sheets
- information booklets
- or energy labels Troy-Bilt TB525CS
All of them are important, but the most important information from the point of view of use of the device are in the user manual Troy-Bilt TB525CS.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Troy-Bilt TB525CS, service manual, brief instructions and user manuals Troy-Bilt TB525CS. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Troy-Bilt TB525CS.

Similar manuals

A complete manual for the device Troy-Bilt TB525CS, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Troy-Bilt TB525CS by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Troy-Bilt TB525CS.

A complete Troy-Bilt manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Troy-Bilt TB525CS - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Troy-Bilt TB525CS, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Troy-Bilt TB525CS, that we can find in the current document
3. Tips how to use the basic functions of the device Troy-Bilt TB525CS - which should help us in our first steps of using Troy-Bilt TB525CS
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Troy-Bilt TB525CS
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Troy-Bilt TB525CS in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Troy-Bilt TB525CS?

Use the form below

If you did not solve your problem by using a manual Troy-Bilt TB525CS, ask a question using the form below. If a user had a similar problem with Troy-Bilt TB525CS it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)