Manual AEG 502 D

16 pages 0.23 mb
Download

Go to site of 16

Summary
  • AEG 502 D - page 1

    502 D Extractor Hood Installation and Operating Instructions ...

  • AEG 502 D - page 2

    3 Contents Electrical connections .......................................................... 4 Safety w ar nings f or electricians .............................................. 4 Appliances with 2 wires .......................................................... 5 Safety w ar nings f or kitchen unit installer ................................ 6 Gene ...

  • AEG 502 D - page 3

    4 It must be ensured that the voltage and current indicated on the rating plate agree with the voltage of the user to electricity supply. If the appliance has been equipped with a mains lead with a moulded-on type plug, the following regulations must be comply with: The plug moulded on to the lead incorporates a fuse. For replacement, use a 5 amp B ...

  • AEG 502 D - page 4

    5 The appliance must be connected to fix ed wir ing with a double pole s witched fused spur outlet with or without pilot lamp . W e strongly recommend the appliance to be connected only b y a qualified electrician who is a member of the NICEIC who will comply with the IEE and an y local regulations. NO TE: The ter minology “DOUBLE POLE” means t ...

  • AEG 502 D - page 5

    6 When the unit is used in its extractor version, a sufficiently large ventilation hole must be provided, with dimensions that are approximately the same as the outlet hole. The air outlet must not be connected to chimney flues or combus- tion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which ...

  • AEG 502 D - page 6

    7 When used as an extractor unit, the hood must be fitted with a 100mm diameter hose. If the fumes must be forced out through the wall, you must obtain a MKZ sizable wall exhaust pipe (with external exhaust and air intake), E-Nr.- 610 899 004 (Ø 120 mm) which is one of our optional parts. When installing the hood, make sure you respect the follow- ...

  • AEG 502 D - page 7

    8 Cooking vapours are cleaned by the charcoal filter (Special accessories) and ducted back into the kitchen. The AEG original KF-Plus charcoal filter is necessary for the recirculating mode (see paragraph “Special accessories”). For the recirculating mode proceed as follows: a) Remove the grid by turning knob A (fig. 2). b) Position the filter ...

  • AEG 502 D - page 8

    9 Description of the appliance 1) Light switch 2) Motor switch 3) Work surface lamp 4) Grid 4 3 Technical details Model 502 D Net weight: 5 kg Height 145 mm Width 520 mm Depth 285 mm Absorbed power: 160W Motor: 1 x 120 W Lighting: 1 x 40 Watt Lengt of the cable: 110 cm Fan powers (speed), speed in compliance with DIN 44971 Speed: 1 2 3 Extractor ve ...

  • AEG 502 D - page 9

    10 After having adjusted the hood for the version required, it may be installed. This appliance is designed for fitting in a cabinet or some other support. The opening to be made on the bottom of the wall-hung cabinet must correspond with the measurements shown in fig. 4 (495 X 260 mm). To fix the hood proceed as follows: a) remove the grid. b) Fit ...

  • AEG 502 D - page 10

    11 The hood is fitted with one variable speed motor. The most effective use of the hood is obtained by switching it on a few minutes before you start cooking and leaving it on a for approximately 5-15 minutes after having finished, thus ensuring that all that cooking odours are eliminated. Never leave a cooking hob or ring on without a pot or pan o ...

  • AEG 502 D - page 11

    12 Hood Operation A B The hood is fitted with a variable speed motor. The most effective use of the hood is obtained by switching it on a few minutes before you start cooking and leaving it on a for approximately 15 minutes after you have finished, thus ensuring all cooking odours are eliminated. The control switches are located on the unit’s fro ...

  • AEG 502 D - page 12

    13 Before performing any maintenance operation, disconnect the hood from the electricity. The hood has a metal grease filter. To clean the filter, proceed as follows: Open the grill by turning knob A (fig. 2). Pull the two plastic stops B as shown by the arrows (fig. 5) and remove the metal filter. You should take out the metal filter every four we ...

  • AEG 502 D - page 13

    14 The charcoal filter must be changed at least every 4 months. The charcoal filter cannot be washed or regenerated. The hood can only work well in the recirculating mode if the AEG recommended filter has been used, the filter is changed as recommended in this section and if the hood is cleaned and maintained as instructed in this booklet. Therefor ...

  • AEG 502 D - page 14

    15 Always turn off the electricity before replacing lamps! 1) Remove the grid (Fig. 2) in order to check the lamps and replace them if necessary. 2) Unscrew the lamps that do not work and replace them with 40W max lamps (E14). If the light does not function, check that the lamps are properly screwed before contacting a customers’ service centre. ...

  • AEG 502 D - page 15

    16 See AEG price-list for wallbox and hose accessories. KF-Plus charcoal filter E-Nr. 942 118 620 Technical assistance service You are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. When calling, please be ready to specify: 1. The mo ...

  • AEG 502 D - page 16

    AEG Hausgeräte AG Postfach 1036 D-90327 Nürnberg © Copyright by AEG H 259 226 140 L 650A ...

Manufacturer AEG Category Ventilation Hood

Documents that we receive from a manufacturer of a AEG 502 D can be divided into several groups. They are, among others:
- AEG technical drawings
- 502 D manuals
- AEG product data sheets
- information booklets
- or energy labels AEG 502 D
All of them are important, but the most important information from the point of view of use of the device are in the user manual AEG 502 D.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals AEG 502 D, service manual, brief instructions and user manuals AEG 502 D. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product AEG 502 D.

Similar manuals

A complete manual for the device AEG 502 D, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use AEG 502 D by users. Manuals are usually written by a technical writer, but in a language understandable to all users of AEG 502 D.

A complete AEG manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual AEG 502 D - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the AEG 502 D, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the AEG 502 D, that we can find in the current document
3. Tips how to use the basic functions of the device AEG 502 D - which should help us in our first steps of using AEG 502 D
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with AEG 502 D
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of AEG 502 D in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning AEG 502 D?

Use the form below

If you did not solve your problem by using a manual AEG 502 D, ask a question using the form below. If a user had a similar problem with AEG 502 D it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)