Manual Crimestopper Security Products CS-9704

12 pages 0.24 mb
Download

Go to site of 12

Summary
  • Crimestopper Security Products CS-9704 - page 1

    CS-9704RS INTEGRATED ALARM/REMOTE START SYSTEM INSTALLATION / OPERATING MANUAL INTRODUCTION: This is a combination vehicle security alarm and tach-l ess remote start system for 12-volt motor vehicles. There are a variety of built-in features, which you may or may not use. Some require the addition of a relay, diode or other component to function pr ...

  • Crimestopper Security Products CS-9704 - page 2

    INSTALLATION CAUTIONS & WARNINGS 1. BEFORE BEGINNING , check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS, ABS BRAKES, AND BATTERY). 2. TO PREVENT A POSSIBLE DEAD BATTERY remove vehicle dome light fuse while working on the vehicle. MAKE CERTAIN TO REINSTALL FUSE PRIOR TO TESTING FOR DOOR TRIGGERS. 3. DO ...

  • Crimestopper Security Products CS-9704 - page 3

    WIRING J-1 6 PIN HI-CURRENT CONNECTORS (See Wire diagram at back of manual for Details) RED : +12V INPUT RED : +12V INPUT (30 Amp) BROWN: IGNITION 1 (Secondary Ign. Output) YELLOW: IGNITION 1 (Primary Ign. Output AND Input) ORANGE: ACCESSORY (20 Amp) PURPLE: STARTER OUTPUT J-2 10 PIN MAIN HARNESS PLUG WHITE WIRE : PIN 1 : PARKING LIGHT CIRCUIT Conn ...

  • Crimestopper Security Products CS-9704 - page 4

    WIRING GRAY WIRE: PIN 6: Engine Monitor (used for tach mode only) Used to monitor when the engine is running. Connect to negat ive terminal of ignition coil, crankshaft position sensor or ECM/PCM tach wire. An alternate method is to wrap several turns around a spark plug wire and fasten with wire ties or hi-temp plastic clamps. See programming sele ...

  • Crimestopper Security Products CS-9704 - page 5

    WIRING J-3 2 PIN PLUG (WHITE) RED-BLACK WIRE: PIN 1: DOME LIGHT ILLUMINATION (-) ( REQUIRES RELAY ) Connect to terminal 85 of relay. This wire turns the dom e light on for 30 seconds upon disarming of the alarm. If the ignition is turned on or the alarm is re-armed, the dome light will turn off again. WHITE-YELLOW: PIN 2: HORN HONK OUTPUT (-) (MAY ...

  • Crimestopper Security Products CS-9704 - page 6

    This system performs the following tasks by pressing one of the buttons on the hand-held transmitter: • ARM / LOCK • DISARM / UNLOCK • TRUNK POP • REMOTE START • PANIC Note: You may not have all of the available features depending on your particular installation. Some features require additional parts and/or labor. #3 #1 TRA NSMIT TER BUT ...

  • Crimestopper Security Products CS-9704 - page 7

    REMOTE ENGINE START: Press and hold the Remote Start button on the transmitter until you hear 3 siren chirps (release button) then the parking lights will turn on. The vehicle will start and run for 15 minutes unless you press the Remote Start transmitter button again or press the foot brake in the vehicle. If the vehicle fails to start on the firs ...

  • Crimestopper Security Products CS-9704 - page 8

    ACTIVE RE-ARMING: Active Re-arming means that the system will re-arm itself 30 seconds after disarmed with the transmitter if a door has not been opened. This is handy if the vehicle is acci dentally disarmed without you knowing it. This feature can also be turned off with the programming options. OVERRIDE: If you have lost the transmitter or it st ...

  • Crimestopper Security Products CS-9704 - page 9

    9 To eliminate siren chirps, turn the ignition on and press t he transmitter’s remote start button for about 3 seconds. You will hear a short double chirp. After the ignition is turned off, there will be no siren chirps for arm, disarm and remote start engage/reset confirmation. To revert back to siren chirps, perform the same procedure (there wi ...

  • Crimestopper Security Products CS-9704 - page 10

    This feature controls the length of time the starter stays engaged. If the default (0.8 seconds) is not long enough to start the engine, change the setting to1.25 seconds. GAS / DIESEL: Set this switch to select the proper vehicle fuel type. Selecting Diesel delays starter activation about 10 seconds to allow warming of glow plugs. TACHLESS or ENGI ...

  • Crimestopper Security Products CS-9704 - page 11

    UNIT SHUTS DOWN 4-5 SECONDS AFTER REMOTE STARTING: The unit does not sense the engine in Tachless mode. Turn dip switch #4 OFF and wrap the gray wire around a plug/coil wire. The module will sense inducted RF/Engine noise in the gray wire allow the engine to stay running longer than 4-5 seconds. EXTENDED RANGE ANTENNA: The supplied antenna plugs in ...

  • Crimestopper Security Products CS-9704 - page 12

    IGNITION 1 IGNITION 1 AC C / I G N 2 BA TTERY ST ARTER +BR A KE SW I TCH (-) HOOD /TRUNK SW I TCH (+) DOOR SWITCH YELLOW IGNITION SWITCH VIO LET GREEN BLUE 30A MP 20A MP 10A MP FUSE FUSE FUSE 1 2 GRA Y 0 3 4 5 6 7 8 USE ONL Y ONE FUSE FOR BOTH RE D WIRES BROW N: IGN+ YELLO W: IGN+ ORA NGE: A CC+/IGN 2 VIOLE T : ST ARTER+ BRO WN BLA CK CHA SSI S GRO ...

Manufacturer Crimestopper Security Products Category Home Security System

Documents that we receive from a manufacturer of a Crimestopper Security Products CS-9704 can be divided into several groups. They are, among others:
- Crimestopper Security Products technical drawings
- CS-9704 manuals
- Crimestopper Security Products product data sheets
- information booklets
- or energy labels Crimestopper Security Products CS-9704
All of them are important, but the most important information from the point of view of use of the device are in the user manual Crimestopper Security Products CS-9704.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Crimestopper Security Products CS-9704, service manual, brief instructions and user manuals Crimestopper Security Products CS-9704. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Crimestopper Security Products CS-9704.

A complete manual for the device Crimestopper Security Products CS-9704, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Crimestopper Security Products CS-9704 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Crimestopper Security Products CS-9704.

A complete Crimestopper Security Products manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Crimestopper Security Products CS-9704 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Crimestopper Security Products CS-9704, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Crimestopper Security Products CS-9704, that we can find in the current document
3. Tips how to use the basic functions of the device Crimestopper Security Products CS-9704 - which should help us in our first steps of using Crimestopper Security Products CS-9704
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Crimestopper Security Products CS-9704
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Crimestopper Security Products CS-9704 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Crimestopper Security Products CS-9704?

Use the form below

If you did not solve your problem by using a manual Crimestopper Security Products CS-9704, ask a question using the form below. If a user had a similar problem with Crimestopper Security Products CS-9704 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)