English dropdown-ico

Manual Smarthome 7307

15 pages 0.43 mb
Download

Go to site of 15

Summary
  • Smarthome 7307 - page 1

    T otal Protection Alarm System SMARTHOME™ #7307 PA T . D410633 Patents Pending SMARTHOME.COM™ 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com Order #7307 ...

  • Smarthome 7307 - page 2

    – 2 – Y our Guide to the T otal Protection Alarm System SMARTHOME™ #7307 – 3 – P ACKAGE CONTENTS........................................................................4 OVE R VIE W ....................................................................................... . 5 PLANNING YOUR HOME SECURITY NEEDS................................. ...

  • Smarthome 7307 - page 3

    P ACKAGE CONTENTS Everything required for installation is included with this package 1 Control Panel (SC-001) includes: 1 antenna (installed) 1 AC adapter 1 9 volt alkaline battery T wo sets of Door/Window Sensors (WT-433), each set includes: 1 transmitter 1 magnetic switch 1 magnet 2 spacers 1 12 volt alkaline battery (installed) 1 Motion Sensor ( ...

  • Smarthome 7307 - page 4

    – 6 – PLANNING YOUR HOME SECURITY NEEDS Before you begin to install your security system, analyze the premises to determine your security needs. Consider those doors and windows which are more likely to be used as points of entry by an intruder , the ones that are poorly lit or the entrances that can not be seen from the street. Sketch a map of ...

  • Smarthome 7307 - page 5

    4. Attach the unit to the wall. If hanging the unit, insert two screws using the template provided. If screwing the back directly to the wall, take the back plate right off by prying apart one hinge. Use as much force as needed. The plastic hinge will not break. 5. Using the template, attach the backplate on to the wall with 4 screws. 6. Mount the ...

  • Smarthome 7307 - page 6

    – 10 – (Cont. : Installing the motion sensor (PS-433) Set the switch on the side t o "TEST" and allow 60 seconds for the unit to warm up. ( when using test mode, a signal will not be sent to the Control Panel ). Now walk in the area you want the motion sensor to detect movement in. If movement is detected, the red light on the front o ...

  • Smarthome 7307 - page 7

    LIGHTS AND SOUNDS If you make a mistake while programming, the Control Panel emits three short beeps. That means the system has cleared and you must start the pro- gramming sequence from the beginning. If you get lost in the programming sequence or have made a mistake and want to start over again, press the [ * ] on the key pad of the Control Panel ...

  • Smarthome 7307 - page 8

    – 14 – ST ANDARD PROGRAMMING Option 2: Home Sequence - T o arm your system when someone remains in the premises. 1. Press the current MPIN [ 0 0 0 ]. 2. Press [ C ]. Y ou hear a long beep. The arm light and the red lights in zones 3 and 4 go on. Both the green and red lights flash in zone 1 for 45 seconds which gives you 45 seconds t o le ave t ...

  • Smarthome 7307 - page 9

    – 16 – KEYCHAIN TRANSMITTER (4B-434) TO DISARM THE SYSTEM, OR DEACTIV A TE THE SIREN USING THE KEYCHAIN TRANSMITTER When the system is armed: Press button #3. The red light on the transmitter flashes and the Control Panel beeps twice. The system is now disarmed. When the siren is sounding: Press button #3. The red light on the transmitter flash ...

  • Smarthome 7307 - page 10

    – 18 – SECONDAR Y PERSONAL IDENTIFICA TION NUMBER (SPIN) Y ou may want to give someone limited access to the system, (baby sitter , cleaner , repairman etc.). For this purpose the SC-100 provides you with the option of adding up to 3 separate SPIN. A SPIN can be any number of 3 digits or more. Y ou can use a SPIN to arm and disarm the system bu ...

  • Smarthome 7307 - page 11

    – 20 – ADV ANCED PROGRAMMING T o program sensors to send their signals to a different zone, you must first clear them from communicating with their current zone. TO CLEAR A ZONE 1. Enter the current MPIN. 2. Press [ B ]. 3. Press the number key to identify current zone [ 1, 2, 3 or 4 ]. The zone light(s) will flash for eight seconds. 4. While t ...

  • Smarthome 7307 - page 12

    – 23 – ADV ANCED PROGRAMMING 1. Enter the current MPIN. 2. Press [ A ]. 3. Press [ A ]. Y ou will hear a long beep. The arm light, the red and green lights in zones 1 and the red lights in zones 3 and 4 go on. Zone 1 has the entry delay to allow someone to enter through the front door and deactivate the system before the siren sounds. This opti ...

  • Smarthome 7307 - page 13

    – 25 – Below is a table summarizing all the preprogrammed sequences. Sequence Zone 1 Zone 2 Zones 3 & 4 When sequence should be used FOR TESTIN G MPIN A # chime chime chime use for testing after installation and to test batteries, also use as a subtle chime when a remote sensor has been activated BASIC PRO GR AMMING MPIN B C exit delay off ...

  • Smarthome 7307 - page 14

    – 27 – BA TTER Y MAINTENANCE MOTION SENSOR BA TTER Y The Motion Sensor operates on a 9 volt alkaline battery accessible beneath a sliding panel on the botto m of the unit. All re mote sensors come with the battery already installed. Disarm the Control Panel before replacing all batteries. When the battery level i s lo w , the Motion Sensor will ...

  • Smarthome 7307 - page 15

    KEYCHAIN TRANSMITTER BA TTER Y The Keychain Transmitter operates on a 12 volt alkaline battery which is installed at the factory . There are two screws on the back of the transmitter that holds the case together . T o replace the Keychain T ransmitter battery: 1. Undo the two screws on the back of the transmitter . The back will then come off. 2. U ...

Manufacturer Smarthome Category Home Security System

Documents that we receive from a manufacturer of a Smarthome 7307 can be divided into several groups. They are, among others:
- Smarthome technical drawings
- 7307 manuals
- Smarthome product data sheets
- information booklets
- or energy labels Smarthome 7307
All of them are important, but the most important information from the point of view of use of the device are in the user manual Smarthome 7307.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Smarthome 7307, service manual, brief instructions and user manuals Smarthome 7307. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Smarthome 7307.

Similar manuals

A complete manual for the device Smarthome 7307, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Smarthome 7307 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Smarthome 7307.

A complete Smarthome manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Smarthome 7307 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Smarthome 7307, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Smarthome 7307, that we can find in the current document
3. Tips how to use the basic functions of the device Smarthome 7307 - which should help us in our first steps of using Smarthome 7307
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Smarthome 7307
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Smarthome 7307 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Smarthome 7307?

Use the form below

If you did not solve your problem by using a manual Smarthome 7307, ask a question using the form below. If a user had a similar problem with Smarthome 7307 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)