Manual Royal U19019 G20

24 pages 0.26 mb
Download

Go to site of 24

Summary
  • Royal U19019 G20 - page 1

    81139 Issue 3 52<$/&+(/7(1+$0 USERS INSTRU CTIONS THIS CAT I 2H APPLIANCE IS FOR USE ON NATURA L GAS G20 AT A SUPPLY PRESSURE OF 20 mbar GB and IE HAND THESE INSTRUCT IO NS TO THE USER ...

  • Royal U19019 G20 - page 2

    DESCRIPTION The Royal Cheltenham glass fronted high efficiency live fuel effect inset gas fire has been developed from the successful Roy al Cozy fires LFE using much of the techno logy and components used in the manufact ure of this appliance. The fuel bed has a reali stic coal effect util izing ceramic ‘coals’ and coal bed that allows seconda ...

  • Royal U19019 G20 - page 3

    TECHNICA L DATA Heats I nput Rates: High Setting 5.42 kW 18,500 Btu/h (Gros s) Low Setting 2.34 kW 8,000 Btu/ h This fire will run for 5.4 hour s on one therm of g a s on hig h setti ng . LOCATION OF COM BU S TI BL E SHE LV ES ABOVE F IRE SIDE OF F IRE Min. Height of 150 mm deep she lf Min. Dimensi on fro m ou ter edg e of fire above hearth = 830m ...

  • Royal U19019 G20 - page 4

    DISMANTLING THE F IRE BED FOR CLEANING (see fig.3, 4 & 5) Allow the appl iance to cool for 1 hour before handling an y components. Remove the controls cover and unscrew the two wing screws securi ng the canopy in place as shown in (fig 3). L ift the canopy off the appliance and place to one side. Support the glass panel a nd remove the four win ...

  • Royal U19019 G20 - page 5

    COAL LAYING INSTRUCTION S Lay the four front coals diagonally with the stepped corner sit ting on the sim ulated coal front and the small corner notch at the rear. L a y a further row of fo ur coal s behind the fro nt r ow with stepped corners in the rear corners of the front row, the two centre coals having no t ches in the rear top corners. L a y ...

  • Royal U19019 G20 - page 6

    Note: Should any ‘coals’ or the coal bed become damaged, lost or broken, only the correct replacem en ts must be obtained and fit ted before the appl iance is used. E x tra ‘coals’ etc. must not be added to the coal bed. The coal bed must alway s be assemb led as detai led. This a ppliance is fitted with an Oxy /pilot the purpose of wh ich ...

  • Royal U19019 G20 - page 7

    REGI STRATI ON RECORD Purchaser’ s Name ______________ ____ ____ ____ ____ ____ ____ _____ ___ ____ and Address ______________ ____ ____ ____ ____ ____ ____ _____ ___ ____ ______________ ____ ____ ____ ____ ____ ____ _____ ___ ____ Supplier’ s Name ______________ ____ ____ ____ ____ ____ ____ _____ ___ ____ and Address ______________ ____ ____ ...

  • Royal U19019 G20 - page 8

    81140 Issue 3 52<$/&+(/7(1+$0 INSTALLATION AND SERVICING INSTRUCTIONS THIS CAT I 2H APPLIANCE IS FOR USE ON NATURAL GAS G20 AT A SUPPLY PRESSURE OF 20 mbar GB and IE HAND THESE INSTRUCTIONS TO THE USER ...

  • Royal U19019 G20 - page 9

    DESCRIPTION The Roy al Chelt enham g l ass fronted high efficiency liv e fuel effect inset gas fire has been developed from the successful Roy a l Cozy fires. The fuel bed has a realistic coal effect utilising ceramic ‘c oals’ and coal bed that allows secondary air to be entrained into the bed for clean combustion, the burner is an aerated twin ...

  • Royal U19019 G20 - page 10

    INSTALLATION REGULATIONS AND REQUIREMENTS I n the interests of both the Law and of Safety , this appliance must only be installed by a competent person in accordance with the current Gas S afety (Installation and Use) Regulations or t he rules in force and t he manufacturer’ s instructions. Note: Failure to install a g as appliance correctly coul ...

  • Royal U19019 G20 - page 11

    Page 4 Clearance to side (tim ber surrounds etc .) Minimum cl earance required to any combustible materia l to the side of the appliance must be 150mm. Clearance to shelves. Minimum clearances t o undersides of a 150mm deep combustible shelf from the hearth must be 830mm. Add 12.5mm to this clearance for every 25mm increase in depth of shelf. ...

  • Royal U19019 G20 - page 12

    Page 5 ...

  • Royal U19019 G20 - page 13

    INSTALLATION USING A 5" DIAMETER METAL F LUE BOX Page 6 Important: The Flue restrictor pl ate must be removed see F ig 10. When the metal flue box is to be built-in as a false chimney breast using timber stud work with plasterboard fa cing, the flue box should be enveloped with insulation material such as rockwool or similar to prevent a build ...

  • Royal U19019 G20 - page 14

    INSTALLATION OF THE APP LIANCE Check that th e chimney conform s to the required specificati ons as previously stated. Ex amine the condition and carry out any remedial work, if the flue has been used for solid fuel it should be swept and a smoke test carried out to check that sati sfactory smoke clearance has been established. If all the smoke is ...

  • Royal U19019 G20 - page 15

    Page 7 a (ii) If the spacer frame is to be used, attach the fram e to the rear of the appliance using either the screws and captive nuts removed from the appliance or supplied in the fixing kit, see fig 8. Place the fire in the required position; mark around the perimeter of the spacer frame remove the appliance and the spacer frame from the applia ...

  • Royal U19019 G20 - page 16

    Page 8 ...

  • Royal U19019 G20 - page 17

    Page 9 ...

  • Royal U19019 G20 - page 18

    Page 10 ...

  • Royal U19019 G20 - page 19

    Page 11 ...

  • Royal U19019 G20 - page 20

    Page 12 ...

  • Royal U19019 G20 - page 21

    CHECKING OP ERATION OF F IRE Purge the air from the appliance by rotating the control to the ig nition position, push the control to allow the air in the pipework to be purged, push the piezo to ignite the Oxy /pilot. Check that the electrode is sparking between the tip of the thermocouple and continue until a pilot flame has been established. Depr ...

  • Royal U19019 G20 - page 22

    Complete the registration section at the end of this booklet. Advise that any component part of this appliance be guaranteed ag ainst defective workmanship or faulty materials for a period of twelve months from the date of purchase. Any such part will be replaced free of charge on receipt of the purchaser’ s address at the cost of postage only , ...

  • Royal U19019 G20 - page 23

    Page 15 ...

  • Royal U19019 G20 - page 24

    SHORT PA RTS LIST For spares contact the manufacturer at the address overleaf. DESCRIPTI ON CROSSLEE No GC No Piezo Ig niter 40245 397 686 Control Knob 40232 170 014 Control Valve 42143 378 092 Oxy/Pilot B urner Assembly 42313 170 415 Main I njector 42168 378 090 Complete Coal & Fibre Pack 42203 REGI STRATI ON RECORD Purchaser’ s Name ……? ...

Manufacturer Royal Category Fire Pit

Documents that we receive from a manufacturer of a Royal U19019 G20 can be divided into several groups. They are, among others:
- Royal technical drawings
- U19019 G20 manuals
- Royal product data sheets
- information booklets
- or energy labels Royal U19019 G20
All of them are important, but the most important information from the point of view of use of the device are in the user manual Royal U19019 G20.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Royal U19019 G20, service manual, brief instructions and user manuals Royal U19019 G20. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Royal U19019 G20.

Similar manuals

A complete manual for the device Royal U19019 G20, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Royal U19019 G20 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Royal U19019 G20.

A complete Royal manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Royal U19019 G20 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Royal U19019 G20, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Royal U19019 G20, that we can find in the current document
3. Tips how to use the basic functions of the device Royal U19019 G20 - which should help us in our first steps of using Royal U19019 G20
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Royal U19019 G20
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Royal U19019 G20 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Royal U19019 G20?

Use the form below

If you did not solve your problem by using a manual Royal U19019 G20, ask a question using the form below. If a user had a similar problem with Royal U19019 G20 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)