English dropdown-ico

Manual Audiovox AS-9055

16 pages 0.38 mb
Download

Go to site of 16

Summary
  • Audiovox AS-9055 - page 1

    128-6832 1 of 16 Kit Contents (1) - Control Module (2) - 1 Button High Frequency Transmitters (1) - 1 Channel Code Learning Receiver (1) - Multi Pin Input/Output Harness (1) - Six Pin Power Harness (1) - Four Pin Accessory Output (Pulse Before & After Start, During Crank & After Shut Down) (2) - 30 Amp In-line Fuse Holders With Fuses (1) - ...

  • Audiovox AS-9055 - page 2

    128-6832 2 of 16 This Remote Start System is designed for use with Automatic T ransmission Vehicles Only! The unit provides wait to start input for glow plug pre-heat which will be used for all diesel applications. If this wire is not connected, then the unit will remain in the Gasoline mode setting, which will crank the car when the RF signal is r ...

  • Audiovox AS-9055 - page 3

    128-6832 3 of 16 3 THE RECEIVER/ANTENNA ASSEMBL Y : The Superheterodyne Receiver Antenna Assembly provided with this unit allows routing from below the dashboard for maximum operating range. Choose a location above the belt line (dashboard) of the vehicle for best reception. Special considerations must be made for windshield glass as some newer veh ...

  • Audiovox AS-9055 - page 4

    128-6832 4 of 16 NOTE: This wire must be connected to the vehicle side of the starter cut relay (when used). For the electrical neutral switch configuration, this connection must be made between the starter inhibit relay , (when used) and the neutral safety switch as shown in the following diagram. Failure to connect this wire to the ignition switc ...

  • Audiovox AS-9055 - page 5

    128-6832 5 of 16 VIOLET WIRE: Accessory Output Connect this wire to the Accessory wire from the ignition switch. This wire will show + 12 volts when the ignition switch is turned to the "ACCESSORY" or "ON" and "RUN" positions and will show 0 volts when the key is turned to the "OFF" and "ST ART" or ...

  • Audiovox AS-9055 - page 6

    128-6832 6 of 16 BROWN w/ BLACK Tracer Wire: Positive Inhibit Input 2 Any time + 12 Volts is applied to the Brown w/ Black tracer wire, the Remote Starter will stop operating, even if the signal is received from the transmitter. If the brake light switch in the vehicle switches + 12 Volts to the brake light circuit, connect the Brown w/ Black trace ...

  • Audiovox AS-9055 - page 7

    128-6832 7 of 16 LIGHT BLUE Wire: Ignition 3 / Shock Disable Output This wire provides a 300mA ground output that becomes active 3 seconds before the Remote Start Unit initializes, and remains grounded while running plus an additional 4 seconds after the Remote Start Unit turns off. In all of the applications described below , a relay will be requi ...

  • Audiovox AS-9055 - page 8

    128-6832 8 of 16 DARK GREEN Wire: T ach Sensor Input This wire will continually monitor the engine tach rate while the unit is under power of the Remote Start module. This wire will be routed to the vehicle ECM tach input or through the firewall into the engine compartment and connect to the negative side of the ignition coil. This Remote Start uni ...

  • Audiovox AS-9055 - page 9

    128-6832 9 of 16 NOTE: The outputs above are low current outputs and must be used with a relay if the circuit's requirement is more than 300 mA. 2 Pin Blue Connector : Programming Switch Route the gray and black wires in the 2 pin connector from the previously installed programming switch to the control module and plug it into the mating blue ...

  • Audiovox AS-9055 - page 10

    128-6832 10 of 16 10 X Pause,etc... X Pause,etc... 3. Diagnostics: 1. Be sure that programmable feature number #6 is set to the "Diagnostics On" mode. 2. Press and hold the program switch on, then turn the ignition key to the "ON" position. 3. The lights will flash and the number of flashes will indicate the reason for shutdown ...

  • Audiovox AS-9055 - page 11

    128-6832 11 of 16 11 W ARNING!! DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THE OPERA TION OF THE HOOD PIN SAFETY SHUT DOWN FEA TURE. MANUAL SHUT DOWN / ENABLE CIRCUIT : The intent of the manual shut down / enable circuit is to allow the vehicle operator to prevent operation of the Remote Start Unit regardless of the RF transmitte ...

  • Audiovox AS-9055 - page 12

    128-6832 12 of 16 configuration prevents mechanical operation while the vehicle is in gear but offers no consideration for electrical operation. Because of this potential problem, this installation requires the additional connection of a safety wire from the remote start device to the vehicle Park/Neutral ECM Input or the vehicle key in sensor . Th ...

  • Audiovox AS-9055 - page 13

    128-6832 13 of 16 METHOD 1 T o connect to the key in sensor as shown in method 1: A. Locate the control wire that connects the drivers door pin switch to the key in sensor switch. B. Cut this wire and connect the ignition cylinder side to chassis ground. C. Locate the key in sensor switch wire that connects the chime module to the ignition cylinder ...

  • Audiovox AS-9055 - page 14

    128-6832 14 of 16 14 NOTE: A second 4002 series diode may be required to maintain the integrity of the hood open, shut down circuit. If this is the case, it must be installed as shown in the diagram above. The anode (Non Striped) side must be connected to the Gray/Black wire of the Remote Start Unit. The cathode (Striped) side must be connected to ...

  • Audiovox AS-9055 - page 15

    128-6832 15 of 16 15 ...

  • Audiovox AS-9055 - page 16

    128-6832 16 of 16 © 2003 Audiovox Electronics Corp., Hauppauge, NY 1 1788 1286832 ...

Manufacturer Audiovox Category Remote Starter

Documents that we receive from a manufacturer of a Audiovox AS-9055 can be divided into several groups. They are, among others:
- Audiovox technical drawings
- AS-9055 manuals
- Audiovox product data sheets
- information booklets
- or energy labels Audiovox AS-9055
All of them are important, but the most important information from the point of view of use of the device are in the user manual Audiovox AS-9055.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Audiovox AS-9055, service manual, brief instructions and user manuals Audiovox AS-9055. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Audiovox AS-9055.

Similar manuals

A complete manual for the device Audiovox AS-9055, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Audiovox AS-9055 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Audiovox AS-9055.

A complete Audiovox manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Audiovox AS-9055 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Audiovox AS-9055, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Audiovox AS-9055, that we can find in the current document
3. Tips how to use the basic functions of the device Audiovox AS-9055 - which should help us in our first steps of using Audiovox AS-9055
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Audiovox AS-9055
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Audiovox AS-9055 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Audiovox AS-9055?

Use the form below

If you did not solve your problem by using a manual Audiovox AS-9055, ask a question using the form below. If a user had a similar problem with Audiovox AS-9055 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)