English dropdown-ico

Manual Procom ML100HPA

23 pages 1.45 mb
Download

Go to site of 23

Summary
  • Procom ML100HPA - page 1

    INFRARED VENT -FREE PROP ANE/LP GAS SP ACE H E AT E R ML060HP A ML100HP A ML100TP A TOLL-FREE NUMBER: 1-877-886-5989 W ARNING: Improper installation, adjustment, alteration, service or mainte- nance can cause injury or property damage. Refer to this manual for correct installation and operational procedures. For assistance or additional info rmatio ...

  • Procom ML100HPA - page 2

    2 IMPORT ANT SAFETY INFORMA TION Keep the appliance area clear and free from combustible materials, gasoline, and other flammable vapors and liquids. 1. This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible f or use with other gases. 2. Do not place propane/LP supply tank(s) inside any ...

  • Procom ML100HPA - page 3

    3 PRODUCT IDENTIFICA TION SAFETY DEVICE A standard requirement for all vent-free room heaters. T his heater has a pilot with an Oxygen Depletion Sensor(ODS) safety shutoff system. The ODS/pilot shuts off the heater if there is not enough fresh air. PIEZO IGNITION SYSTEM This heater is equipped with a piezo ignitor. This system requires no matches, ...

  • Procom ML100HPA - page 4

    4 FRESH AIR FOR COMBUSTION AND VENTILA TION PROVIDING ADEQUA TE VENTILA TION The following are excerpts from National Fuel Gas Code. NFP A 54/ANS Z223.1, Section 5.3. Air for Combustion and V entilation. All spaces in homes fall into one of the three following ventilation classifications: 1. Unusually T ight Construction 2. Unconfined Space 3. Conf ...

  • Procom ML100HPA - page 5

    5 W ARNING: Rework worksheet, adding the space of the adjoining unconfined space. The combined spaces must have enough fresh air to supply all appliances in both spaces. AIR FOR COMBUSTION AND VENTILA TION Continued VENTILA TION AIR V entilation Air From Inside Building This fresh air would come from an adjoining unconfined space. When ventilating ...

  • Procom ML100HPA - page 6

    6 VENTILA TION AIR V entilation Air From Outdoors Provide extra fresh air by using ventilation grills or ducts: Y ou must provide two permanent openings: one within 12 " of the ceiling and one within 12 " of the floor. Connect these items directly to the outdoors or spaces open to the outdoors. These spaces include attics and crawl spaces ...

  • Procom ML100HPA - page 7

    7 INST ALLA TION Figure 4 -Mounting clearances As V iewed From Front of Heater W ARNING: Maintain the minimum clearances shown in Figure 4. If you can, provide greater clearances from floor, ceiling, and joining wall. Figure 7 - Mounting Bracket Clearances Figure 6 - Removing Lower Front Panel Of Heater F ASTENING HEA TER TO W ALL Mounting Bracket ...

  • Procom ML100HPA - page 8

    8 INST ALLA TION Figure 10 - Mounting Heater Onto Mounting Bracket Figure 8 - Folding Anchor Figure 9 - Popping Open Anchor Wing For Thin Walls Attaching Mounting Bracket T o W all Note: W all anchors, mounting screws, and spacers are in hardware package. The hardware package is provided with heater. Attaching to W all Stud Method For attaching mou ...

  • Procom ML100HPA - page 9

    9 INST ALLA TION CONNECTING TO GAS SUPPL Y W ARNING: A qualified service person must connect heater to gas supply. Follow all local codes. W ARNING: This appliance requires a 3/8 " NPT (National Pipe Thread) inlet connection to the pressure regulator. CAUTION: Never connect heater directly to the propane/LP supply. This heater requires an exte ...

  • Procom ML100HPA - page 10

    10 Figure 14 -Equipment Shutoff Valve INST ALLA TION CHECKING GAS CONNECTIONS W ARNING: T est all gas piping and connections for leaks after installing or servicing. Cor- rect all leaks at once. W ARNING: Never use an open flame to check for a leak. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a leak. Correct all lea ...

  • Procom ML100HPA - page 11

    11 Figure 17 - Control Knob In The OFF Position Figure 18 - Pilot OPERA TING YOUR HEA TER Manual Control Models: ML060HP A,ML100HP A  LIGHTING  INSTRUCTIONS 1. STOP! Read the safety information on the side of heater. 2. Check that gas supply to heater is on. 3. Push in gas control knob slightly and turn clockwise to the OFF position. ( see Fi ...

  • Procom ML100HPA - page 12

    12 OPERA TING YOUR HEA TER THERMOST A T MODEL ML100TP A  FOR YOUR SAFETY  READ BEFORE LIGHTING A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly. B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier t ...

  • Procom ML100HPA - page 13

    13 INSPECTING BURNER Figure 24 - Correct Pilot Flame Pattern Figure 25 - Incorrect Pilot Flame Pattern Figure 27 - Incorrect Burner Flame Pattern Figure 26 - Correct Burner Flame Pattern ODS/PILOT AND BURNER  Use a vacuum cleaner, pres - surized air, or a small, sof t bristled brush to clean. CLEANING BURNER PILOT AIR INLET HOLE We recommend tha ...

  • Procom ML100HPA - page 14

    14 TROUBLESHOOTING Note : All troubleshooting items are listed in order of operation. W ARNING: Only a qualified service person should service and repair heater. CAUTION: Never use a wire, needle, or similar object to clean ODS/pilot. This can damage ODS/pilot unit. OBSERVED PROBLEM When ignitor button is pressed and control knob is pressed in and ...

  • Procom ML100HPA - page 15

    15 TROUBLESHOOTING Continued OBSERVED PROBLEM Burner(s)does not light after ODS/pilot is lit. Delayed ignition of burner(s). Burner backfiring during combustion. Burner plaque(s) does not glow. Slight smoke or odor during initial operation. Heater produces a clicking/ticking noise just after burner is lit or shut off. White powder residue forming w ...

  • Procom ML100HPA - page 16

    16 TROUBLESHOOTING Continued W ARNING: If you smell gas  Shut off gas supply .  Do not try to light any appliance.  Do not touch any electrical switch; do not use any phone in your building.  Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.  If you cannot reach your gas supplier, ...

  • Procom ML100HPA - page 17

    17 SPECIFICA TIONS Btu(available) Gas T ype Ignition Pressure Regulator setting Inlet Gas Pressure* (inches of water) Maximum Minimum Dimensions, Inches (HxWxD) Heater Carton Weight (pounds) Heater Shipping ML060HP A 6,000 propane/LP Only Piezo 10 " W.C. 14 " 11 " 19-1/8 × 14-1/8 × 6-3/8 22 × 16-3/4 × 8-1/8 12 15 Note: Dimensions ...

  • Procom ML100HPA - page 18

    18 ILLUSTRA TED P ARTS BREAKDOWN ML060HP A ...

  • Procom ML100HPA - page 19

    19 P ARTS LIST ML060HP A This list contains replaceable parts for your heater. When ordering replacement parts, follow the instructions listed under Replacement Parts on page17 of this manual. KEY NO. 1 2 3 4 5 5-1 5-2 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 PA R T NUMBER MB10008 MB09003 ML006-02 MB19006 ND1308x600x9 ND0803-6 ND0807-B2 ML026 ...

  • Procom ML100HPA - page 20

    20 ILLUSTRA TED P ARTS BREAKDOWN ML100HP A ...

  • Procom ML100HPA - page 21

    21 P ARTS LIST ML100HP A This list contains replaceable parts for your heater. When ordering replacement parts, follow the instructions listed under Replacement Parts on page17 of this manual. KEY NO. 1 2 3 4 5 5-1 5-2 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 PA R T NUMBER MB10008 MB09003 ML006-01 MB19006 ND1308x600x9 ND0803-6 ND0807-B2 ML ...

  • Procom ML100HPA - page 22

    22 ILLUSTRA TED P ARTS BREAKDOWN ML100TP A ...

  • Procom ML100HPA - page 23

    23 P ART LIST ML100TP A KEY NO. 1 2 3 4 5 5-1 5-2 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 PA R T NUMBER MB10007 MB09003 ML006-01 MB19006 ND1308x600x9 ND0803-6 ND0807-B2 ML026-02 ML069-02 845-4.8x60Z SIT544-000 ML1 1 1-02 ML056-03 MB40037 MB40039 MB40038 MB40040 ML090-04 MB40041 NRV81FI-10 ML129-02 ML079-01 MB29003 ML060-02 ML083-03 MB2800 ...

Manufacturer Procom Category Electric Heater

Documents that we receive from a manufacturer of a Procom ML100HPA can be divided into several groups. They are, among others:
- Procom technical drawings
- ML100HPA manuals
- Procom product data sheets
- information booklets
- or energy labels Procom ML100HPA
All of them are important, but the most important information from the point of view of use of the device are in the user manual Procom ML100HPA.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Procom ML100HPA, service manual, brief instructions and user manuals Procom ML100HPA. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Procom ML100HPA.

Similar manuals

A complete manual for the device Procom ML100HPA, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Procom ML100HPA by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Procom ML100HPA.

A complete Procom manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Procom ML100HPA - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Procom ML100HPA, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Procom ML100HPA, that we can find in the current document
3. Tips how to use the basic functions of the device Procom ML100HPA - which should help us in our first steps of using Procom ML100HPA
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Procom ML100HPA
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Procom ML100HPA in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Procom ML100HPA?

Use the form below

If you did not solve your problem by using a manual Procom ML100HPA, ask a question using the form below. If a user had a similar problem with Procom ML100HPA it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)