English dropdown-ico

Manual Wayne-Dalton 6100

20 pages 5.97 mb
Download

Go to site of 20

Summary
  • Wayne-Dalton 6100 - page 1

    GARAGE DOORS & OPENERS Part No. IMPORT ANT NO TICES! Wayne-Dalton highly recommends that you read and fully under - stand the Installation Instructions and Owner’ s Manual before you attempt this installation. T o avoid possible injur y , read the enclosed instructions carefully before installing and operating the garage door . Pay close atte ...

  • Wayne-Dalton 6100 - page 2

    2 Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com A. FLAG ANGLES (AS REQUIRED): A1. Fully Adjustable (F .A.) Flag Angles A2. Quick Install (Q.I.) F ...

  • Wayne-Dalton 6100 - page 3

    I m p o r t a n t S a f e t y I n s t r u c t i o n s DEFINITION OF KEY WORDS USED IN THIS MANUAL: W ARNING W ARNING INDICA TES A POTENTIALL Y HAZARDOUS SITUA TION WHICH; IF NOT AVOIDED , COULD RESUL T IN SEVERE OR FA T AL INJURY . CAUTION: PROPER TY DAMAGE OR INJURY CAN RESUL T FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORT ANT : REQUIRED STEP FOR SA ...

  • Wayne-Dalton 6100 - page 4

    5/16” x 1 5/8” Hex head lag screws (as required) 1/4”-20 x 11/16” Self drilling screws (as required) (2) 5/16”-18 x 3/4” Carriage bolts 1/4”-20 x 9/16” Track bolts (as required) 1/4”-14 x 5/8” Self tapping screws (as required) (2) 3/8”-16 x 3/4” Truss head bolts Cotter pin 5/16” x 1-1/4” Clevis pin #8 x 1-13/32” Quadre ...

  • Wayne-Dalton 6100 - page 5

    jamb, fit the weatherstrip up tight against the temporarily attached weatherstrip in the header and flush with the inside edge of the jamb. T emporarily secure the weatherstrip with equally spaced nails. Repeat for other side. This will keep the bottom section from falling out of the opening during installation. Equally space nails approximately ...

  • Wayne-Dalton 6100 - page 6

    INST ALLA TION Before installing your door , be certain that you have read and followed all of the instruc- tions covered in the pre-installation section of this manual. Failure to do so may result in an improperly installed door . NOTE: Reference TDS 160 for general garage door terminology at www.dasma.com . Quick Install Flag Angles T ools: None ...

  • Wayne-Dalton 6100 - page 7

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com hole onto the center stile. Drill 1/16” pilot holes at the marked hole locations. Fasten both lif ...

  • Wayne-Dalton 6100 - page 8

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Bottom Section T ools: Level, Wooden shims (if necessary) 8 Center the bottom section in the door o ...

  • Wayne-Dalton 6100 - page 9

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com the a-symmetrical strut to the end cap with (2) 1/4”-20 x 11/16” self drilling screws. Fasten b ...

  • Wayne-Dalton 6100 - page 10

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Bottom rail of horizontal track Flag angle Quick Install tab Key slot Quick Install tab in place T ...

  • Wayne-Dalton 6100 - page 11

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Drum Wraps T ools: None 20 NOTE: If you don’t have drum wraps, then skip this step. Refer to Pack ...

  • Wayne-Dalton 6100 - page 12

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Vice clamps above third track roller on both sides of door Bottom section Vice clamps attached to i ...

  • Wayne-Dalton 6100 - page 13

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Last rib Drum wrap Cable drum 3rd rib 3 catches Counterbalance lift cable. Pull to clear latch Hing ...

  • Wayne-Dalton 6100 - page 14

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Horizontal tracks Door edges 3/4” To 7/8” 3/4” To 7/8” Balancing Door T ools: Ra tchet wren ...

  • Wayne-Dalton 6100 - page 15

    T orqueMaster ® Plus Reset Instructions T ools: Ra tchet wrench, 5/8” Socket, 3” Socket extension, 5/8” Wrench, (2) Vice clamps, Step ladder IMPORT ANT : THE DRA WBAR OPERA TOR FORCE SETTINGS MUST BE ADJUSTED ACCORDING TO THE MANUF ACTURER’S INSTR UCTIONS. SOME LIGHTER WEIGHT DOORS ARE DESIGNED TO OPERA TE WITH A SINGLE COUNTERBALANCE SPRI ...

  • Wayne-Dalton 6100 - page 16

    Pull Down Rope T ools: Power drill, 1/8” Drill bit, T ape measure W ARNING W ARNING DO NOT INST ALL PULL DOWN ROPE ON DOORS WITH OPERA TORS. CHILDREN MA Y BECOME ENT ANGLED IN THE ROPE CAUSING SEVERE OR F A T AL INJURY . Measure and mark the jamb approximately 48” to 50” (1220 to 1270 mm) from floor on the right or left side of jamb. Drill 1 ...

  • Wayne-Dalton 6100 - page 17

    Cleaning Y our Garage Door IMPORT ANT : DO NOT USE A PRESSURE W ASHER ON YOUR GARAGE DOOR! While factory-applied finishes on garage doors are durable, it is desirable to clean them on a routine basis. Some discoloration of the finish may occur when a door has been exposed to dirt-laden atmosphere for a period of time. Slight chalking may also occ ...

  • Wayne-Dalton 6100 - page 18

    W ARNING W ARNING NEVER REMOVE, ADJUST , OR LOOSEN THE BOL TS, SCREWS AND/OR LAG SCREWS ON THE COUNTERBALANCE (END OR CENTER BEARING BRACKETS) SYSTEM OR BO TTOM BRACKETS OF THE DOOR. THESE BRACKETS ARE CON- NECTED TO THE SPRING(S) AND ARE UNDER EXTREME TENSION. TO AVOID POSSIBLE SEVERE OR F A T AL INJURY , HAVE ANY SUCH WORK PERFORMED BY A TRAINED ...

  • Wayne-Dalton 6100 - page 19

    Lifetime Limited Warranty Model 6100 Subject to the terms and conditions contained in this Lifetime Limited Warranty , Wayne-Dalton (“Manufacturer”) warrants the steel sections of the door , which is described at the top of this page, for as long as you own the door against: i) The door becoming inoperable due to rust-through of the steel skin ...

  • Wayne-Dalton 6100 - page 20

    AFTER INST ALLA TION IS COMPLETE, F ASTEN THIS MANUAL NEAR THE GARAGE DOOR. Please Do Not Return This Product T o The Store Thank you for your pur chase. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pa ges business listings or go to the Find a Dealer section online at www .Wayne-Dalt ...

Manufacturer Wayne-Dalton Category Garage Door Opener

Documents that we receive from a manufacturer of a Wayne-Dalton 6100 can be divided into several groups. They are, among others:
- Wayne-Dalton technical drawings
- 6100 manuals
- Wayne-Dalton product data sheets
- information booklets
- or energy labels Wayne-Dalton 6100
All of them are important, but the most important information from the point of view of use of the device are in the user manual Wayne-Dalton 6100.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Wayne-Dalton 6100, service manual, brief instructions and user manuals Wayne-Dalton 6100. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Wayne-Dalton 6100.

Similar manuals

A complete manual for the device Wayne-Dalton 6100, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Wayne-Dalton 6100 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Wayne-Dalton 6100.

A complete Wayne-Dalton manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Wayne-Dalton 6100 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Wayne-Dalton 6100, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Wayne-Dalton 6100, that we can find in the current document
3. Tips how to use the basic functions of the device Wayne-Dalton 6100 - which should help us in our first steps of using Wayne-Dalton 6100
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Wayne-Dalton 6100
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Wayne-Dalton 6100 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Wayne-Dalton 6100?

Use the form below

If you did not solve your problem by using a manual Wayne-Dalton 6100, ask a question using the form below. If a user had a similar problem with Wayne-Dalton 6100 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)