Bedienungsanleitung a/d/s/ P650

14 Seiten 1.09 mb
Download

Zur Seite of 14

Summary
  • a/d/s/ P650 - page 1

    analog and digital systems P 4 5 0 / P 6 5 0 / P 8 5 0 owners manual 00-3009 REV A ©2001 analog and digital systems, inc. 300 wildwood avenue, woburn, massachusetts 01801 781.729.1140 www.adst.com ...

  • a/d/s/ P650 - page 2

    1 26 table of contents introduction 1 about this manual 2 features of your PowerPlateTM 2 warning and tips 3 system planning 4 signal sources 4 system configurations 6 mounting locations 11 installation 12 controls and connections 13 multi-crossTM crossover and configurations 16 tuning 17 troubleshooting 19 specifications 21 warranty information 22 ...

  • a/d/s/ P650 - page 3

    25 2 specifications amplifier section power output 4 W (watts) 1 50/channel 150/bridged channel pair power output 2 W (watts) 2 75/channel distortion all channels driven 0.1% 20Hz to 20,000Hz frequency response ±1dB 10Hz to 30,000Hz signal-to-noise ratio full bandwidth @ rated output power >90dB damping factor @ output connector full bandwidth ...

  • a/d/s/ P650 - page 4

    3 24 W arnings and tips Always disconnect the battery ground wire before doing any work on your vehicle. Reconnect the cable only after the installation is complete and the wiring has been checked to make sure that there are no problems. If your radio features a code type security system, be sure you know the code before disconnecting the battery! ...

  • a/d/s/ P650 - page 5

    23 4 T roubleshooting symptom possible cause action to take no output low or no remote turn-on input check remote turn-on voltage output at amplifier and cor rect as needed fuse blown check power wire integrity and reversed polarity, repair as needed and replace fuse power wires not connected check power wire and ground connections and repair or re ...

  • a/d/s/ P650 - page 6

    5 22 P450 system diagrams System 1 - P450 used in 4-channel mode with front and rear full range speakers. System 2 - P450 used in 2-channel bridged mode with full range speakers. ...

  • a/d/s/ P650 - page 7

    21 6 System 3 - Two P450’s; one is used to drive front tweeters and midrange drivers, the second is used in 2-channel bridged mode for subwoofers. Subwoofer level can be controlled by using the source’s front output for the first P450 and the rear output for the second P450. ...

  • a/d/s/ P650 - page 8

    7 20 System 1 – P650 used in 6-channel mode. Channels 1/2 are high-passed for front speakers. Chan- nels 3/4 are high-passed for rear speakers. Channels 5/6 are low-passed for subwoofers. Although shown with 4-channels of input, the source unit can be either 2- or 4-channel. System 2 – P650 used in 6-channel mode. Channels 1/2 are high-passed f ...

  • a/d/s/ P650 - page 9

    19 8 adjusting input sensitivity The input sensitivity setting is important to ensure proper performance, low noise levels, and maxi- mum system reliability. As a general rule, components at the "front end" of the system should be set as high as possible with the input sensitivity of the amplifier set as low as possible while still pro- v ...

  • a/d/s/ P650 - page 10

    9 18 P850 system diagrams System 1 – P850 used in 6-channel mode. Channels 1/2 are high-passed for front speakers chan- nels 3/4 are high-passed for rear speakers, and channels 5/6 and 7/8 are bridged low-pass for sub- woofers. Although shown with 4-channels of input, the source unit can be either 2- or 4-channel. System 2 – The P850 is used in ...

  • a/d/s/ P650 - page 11

    17 10 xover control 5/6 (P650) – The crossover selection for channels 5&6 has three possibilities: When the switch is in the left position, the crossover section of the amplifier is bypassed. Channel 5&6 output is full range. When the switch is the center position, channels 5&6 are filtered through a 12dB per octave high-pass crossove ...

  • a/d/s/ P650 - page 12

    11 16 installation 1. Disconnect the battery ground cable. Reconnect the ground cable only after the installation is complete and the wiring has been checked to make sure that there are no problems. If your radio features a code type security system, be sure you know the code before disconnecting the battery! 2. Run a minimum AWG #8 power wire dire ...

  • a/d/s/ P650 - page 13

    15 12 internal signal routing, cont’d Channels 5/6 input switch (P650 and P850) – selects input from three possibili - ties. When the switch is in the left position, channels 5/6 receive input from the 5/6 DIN inputs. When the switch is in the center position, channels 5/6 receive input from channels 1/2 RCA input. When the switch is in the rig ...

  • a/d/s/ P650 - page 14

    13 14 signal sources Due to the wide input level adjustment range, all a/d/s/ PowerPlates TM can be driven with either a conventional preamplifier drive signal or the amplified signal from a powered source unit. This makes the PowerPlate TM perfect for upgrading an OEM (Original Equipment Manufacturer) stereo system while retaining the factory inst ...

Produzent a/d/s/ Kategorie Car Stereo System

Dokumente, die wir vom Produzenten des Geräts a/d/s/ P650 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen a/d/s/
- Bedienungsanleitungen P650
- Produktkarten a/d/s/
- Informationsbroschüren
- oder Energieetiketten a/d/s/ P650
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung a/d/s/ P650.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen a/d/s/ P650, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen a/d/s/ P650. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts a/d/s/ P650 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts a/d/s/ P650, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von a/d/s/ P650 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von a/d/s/ P650 verständlich ist.

Eine gänzliche Bedienungsanleitung von a/d/s/ sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von a/d/s/ P650 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von a/d/s/ P650 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich a/d/s/ P650, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts a/d/s/ P650 - die uns die ersten Schritte während der Nutzung von a/d/s/ P650 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit a/d/s/ P650 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von a/d/s/ P650 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich a/d/s/ P650?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit a/d/s/ P650 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit a/d/s/ P650 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)