Bedienungsanleitung Clarion APX200

16 Seiten 0.25 mb
Download

Zur Seite of 16

Summary
  • Clarion APX200 - page 1

    OPERATIONAL INSTALLATION MANUAL ...

  • Clarion APX200 - page 2

    APX200.2M Power System Amplifier INTRODUCTION The Clarion APX200.2M is a full-featured two-channel amplifier incorporating the following features: • Full frequency response with low distortion and exceptional signal to noise performance • Advanced circuit design that features bridgeable and mixed mode operation for use in various systems, inclu ...

  • Clarion APX200 - page 3

    OWNER’S MANUAL 1 DESCRIPTION The Clarion APX200.2M two-channel amplifier provides 2x70 watts of power into a 4 ohm load and 2x110 watts of power into a 2 ohm load. This full featured model is an excellent choice for a variety of marine audio sound system configurations. The APX200.2M uses an unregulated MOSFET power supply for superior control of ...

  • Clarion APX200 - page 4

    APX200.2M Power System Amplifier 2 • Gain Control - This allows you to set the nominal operating level of the amplifier. The amplifier's range, 250mV to 2.5V for RCA inputs or 500mV to 5V for speaker level inputs, can accommodate input levels from virtually any brand of source unit. • Bass Boost Contro l- The amplifier also features a &quo ...

  • Clarion APX200 - page 5

    OWNER’S MANUAL 3 CONNECTIONS FOR POWER AND SPEAKERS The rear panel of the APX200.2M contains power and speaker connections as shown below. Figure 2 1. Left Speaker Output 2. Right Speaker Output 3. Remote Turn-on Input 4. Ground Input 5. Battery + 12V Input 6. 25 Amp Fuse ...

  • Clarion APX200 - page 6

    APX200.2M Power System Amplifier 4 APPLICATIONS The Clarion APX200.2M 2-channel marine audio amplifier can be used in a variety of system applications. Here are some examples to help plan your own installation. Bridged - Mono Subwoofer System Set X-Over Mode to LP and adjust FREQ to speaker specifications. Figure 3 - In this application the amplifi ...

  • Clarion APX200 - page 7

    OWNER’S MANUAL 5 2-Channel Full-Range, Satellite, or Subwoofer Stereo System (Set INPUT SELECT Switch to STEREO) Figure 4 - In this application, the amplifier is used in stereo and drives two full-range (or satellite or subwoofer) speakers. NOTE: A passive crossover must be used with satellite speakers. Set X-Over Mode as shown. Set X-Over Mode a ...

  • Clarion APX200 - page 8

    APX200.2M Power System Amplifier 6 Mixed-Mode Satellite and Subwoofer System (Set INPUT SELECT Switch to STEREO) Subwoofer 4 Ohms NOTE: Chart values based on 4 Ohm speakers. Figure 5 - The amplifier can be configured for a mixed-mode operation. The table provides component values to create a 6dB per octave crossover at specified frequencies. Use co ...

  • Clarion APX200 - page 9

    OWNER’S MANUAL 7 INSTALLATION This section lists Mounting and Wiring Precautions for installing a Clarion APX200.2M marine amplifier. Combined with the experience of a professional installer, these safeguards provide enough detail to successfully complete an installation. If you do not have the necessary skills, do not install the amplifier yours ...

  • Clarion APX200 - page 10

    APX200.2M Power System Amplifier 8 5. Add an external fuse on the amplifier's positive (+) power lead and connect it as close as possible to the vessel's (+) battery terminal. Use a rating that equals the total current consumption at full output of all amplifiers in the system. Adding an external f use will protect the electrical system f ...

  • Clarion APX200 - page 11

    OWNER’S MANUAL 9 Figure 6 - Electrical connections for the APX200.2M ...

  • Clarion APX200 - page 12

    APX200.2M Power System Amplifier 10 SETTING THE GAIN After completing the installation, follow these steps to set the Gain Control and then perform the Final System Checks. 1. Turn the Gain Control all the way counter-clockwise. 2. Turn the vessel's Ignition Switch to the ON position. Then turn the ON/OFF Switch on the source units to the ON p ...

  • Clarion APX200 - page 13

    OWNER’S MANUAL 11 FINAL SYSTEM CHECKS 1. Start the engine and turn on the source unit. After a two-second delay, slowly increase the Volume Control and listen to the audio. If you hear any noise, static, distortion or no sound at all, check the connections, and also refer to Troubleshooting. Depending on your system design, the levels may become ...

  • Clarion APX200 - page 14

    APX200.2M Power System Amplifier 12 Problem Distorted audio. Solution Gain is not set properly, or damaged speaker cones. Review Setting Gain; inspect each speaker cone for signs of damage (i.e. frozen cone, burning smell, etc.) Problem Audio lacks punch. Solution Speakers wired incorrectly, which causes cancellation of bass frequencies. Check pola ...

  • Clarion APX200 - page 15

    OWNER’S MANUAL 13 NOTES ...

  • Clarion APX200 - page 16

    661 W. Redondo Beach Blvd. Gardena, CA 90247 1-800-GO-CLARION www.clarion-usa.com APX200.2M-10 Rev.1 (03/01) ...

Produzent Clarion Kategorie Stereo Amplifier

Dokumente, die wir vom Produzenten des Geräts Clarion APX200 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen Clarion
- Bedienungsanleitungen APX200
- Produktkarten Clarion
- Informationsbroschüren
- oder Energieetiketten Clarion APX200
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung Clarion APX200.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen Clarion APX200, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen Clarion APX200. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts Clarion APX200 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts Clarion APX200, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von Clarion APX200 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von Clarion APX200 verständlich ist.

Eine gänzliche Bedienungsanleitung von Clarion sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von Clarion APX200 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von Clarion APX200 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich Clarion APX200, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts Clarion APX200 - die uns die ersten Schritte während der Nutzung von Clarion APX200 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit Clarion APX200 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von Clarion APX200 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich Clarion APX200?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit Clarion APX200 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit Clarion APX200 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)