Manuel d’utilisation ResMed H4i

14 pages 0.37 mb
Télécharger

Aller à la page of 14

Summary
  • ResMed H4i - page 1

    English H4i™ HEATED H UMIDIFI ER User Guide English Patents and designs pending. HumidAire, H4i, ResControl, ResLink, R esT raxx, VP AP , VP AP A uto, A utoSet and SmartStart are trademarks of ResMed Ltd. HumidAire, AutoSet, SmartStart and VP AP are registered in U.S. P atent and T rade mark Of fice. © 2008 ResMed Ltd. 268183 -Eng /1 08 03 ResMe ...

  • ResMed H4i - page 2

    Cont ents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Indications for use 1 Contraindications 1 Components of your H4i . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 S et ting up your H4i for use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • ResMed H4i - page 3

    1 Introduction English Introduction The H4i ™ is designed to moi sten the air delivered to your airway during Positi ve Airway Pressure (PAP) therapy. Indications for use The H4i is indicated for humidification of the air del ivered from a ResMed compatible CPAP therapy device. The H4i is for use only as recommende d by a physician. Contraindicat ...

  • ResMed H4i - page 4

    2 System Setup 1 Align your H4i wi th your flow gene rator and push them together until the y click into place. 2 Connect the power cord to the socket on th e rear of your flow generator. 3 Plug the other end of the power cord into the power outlet. Place the combined unit on a firm, level surface near your bed at a level lower than your sleeping p ...

  • ResMed H4i - page 5

    3 Setting up your H4i for use English Filling the Water Chamber 1 Open the cover. 2 Remove the water chamber. 3 Fill with fresh, clean water up the maximum water level mark. 4 Return the water chamber to the docking station. 5 Close the cover ensuring that it clicks into place. ! WARNING Do not overfill the water chamber as water may ent er the flo ...

  • ResMed H4i - page 6

    4 Starting and Stopping Treatment Warming your H4i The Warm-Up feature (not available on all Re sMed PAP d evices) is used to pre-hea t the water before starting treatm ent. Skip this step if you want to start immediately. To start the Warm-Up feature: 1 Select wa rmup by pressing on the control panel. 2 The WARMING scre en will appear to indica te ...

  • ResMed H4i - page 7

    5 Cleaning and Maintenance English Cleaning and Maintenance You should regularly carry out cl eaning and maintenance of the water cha mber, cover and cover seal as described in thi s section. ! WARNING • Bewa re of electrocu tion. Do not immerse your flow ge nerator , doc king station or p ower cord in w ater . Always unp lug the devi ce before c ...

  • ResMed H4i - page 8

    6 Weekly Inspect the water chamber for wear and det erioration. Replace the water chamber if any component has cracked, become cloudy or pitted. Repla ce immediately if there is any leaking from the water chamber. White powder or deposits in the water chamber can be cleaned using a solution of one part vinegar to 10 parts water, as follows: 1 Fill ...

  • ResMed H4i - page 9

    7 Cleaning and Maintenance English Reassembling the H4i Reassemble the parts when they are clean and dry. 1 Align the cover seal to the guides on the cover and press along the edges to ensure it is fitted pr operly. 2 Put one cover arm into its pivot point on the docking station and ge ntly flex the other arm into its correspondin g point. The cove ...

  • ResMed H4i - page 10

    8 Troubleshooting If there is a problem, try the following sugg estions. If the problem cannot be so lved, contact your equipment suppl ier or ResMed. Do not open the unit. ! WARNING Service and repair sho uld only be performed by an authorized service age nt. Pro b le m Possible Cause Solu tio n Device not w orking (no displa y on LCD screen and/o ...

  • ResMed H4i - page 11

    9 T echnical Specifications English Technical Specifications Humidifier Performance The following settings have been tested at 22°C, 40% RH ambi ent conditions: Note: The manufactu rer reserves the right to change th ese specifications without notice. Symbols which appear on the device Attention, consult accompany ing documents; Type CF equipment; ...

  • ResMed H4i - page 12

    10 General Warnings A warning alerts you to possible injury. Specific warning s and cautions appear n ext to the relevant instructio ns in the manual. • Use the H4i only for its intended use as described in this manual. • Make sure that the water c hamber is empt y before transporting the H4i. • The H4i is designed only for use w ith spec ifi ...

  • ResMed H4i - page 13

    11 Limited W arranty English Limited Warranty ResMed warrants that your ResMed product shall be free from defects in material and workmanship for the period sp ecified below from the date of purc hase by the initial co nsumer. Th is wa rranty is not transf erable. Note: Some models are not available in all regi ons. If the product fails under condi ...

  • ResMed H4i - page 14

    12 ...

Fabricant ResMed Catégorie Humidifier

Les documents que nous recevons du fabricant de l'appareilResMed H4i peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques ResMed
- manuels d’utilisations H4i
- fiches produit ResMed
- dépliants
- ou étiquettes-énergie ResMed H4i
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation ResMed H4i.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation ResMed H4i, manuels d’entretien, brefs manuels ou manuels de l’utilisateur ResMed H4i. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit ResMed H4i.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil ResMed H4i, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser ResMed H4i par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs ResMed H4i.

Le manuel d’utilisation complet ResMed, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel ResMed H4i - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières ResMed H4i, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lResMed H4i qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil ResMed H4i - qui devraient nous aider dans les premières étapes lors de l'utilisation ResMed H4i
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de ResMed H4i
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service ResMed H4i dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de ResMed H4i?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec ResMed H4i, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec ResMed H4i il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)