Manuel d’utilisation Campbell Hausfeld CS115

20 pages 0.44 mb
Télécharger

Aller à la page of 20

Summary
  • Campbell Hausfeld CS115 - page 1

    INSTRUCTION MANUAL CS1 15 Barometric Pressure Sensor 3/03 Copyright (c) 2002-2003 Campbell Scientific, Inc. ...

  • Campbell Hausfeld CS115 - page 2

    Warranty and Assistance The CS115 BAROMETR IC PRESS URE SE NSOR is w arranted by CAMPBELL SCIENTIFIC, INC. to be f ree from def ects in m aterials and workmanship und er no rmal use a nd ser vice fo r twelve ( 12 ) months fr om date of shipment unle ss spec ified othe rwise. B atte ries ha ve no warr anty. CAMP BE LL SCIENTIFIC, INC.' s obliga ...

  • Campbell Hausfeld CS115 - page 3

    i CS115 Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab for links to specific sections. 1. Introducti on ................................................................. 1 2. Specifications ............................................................. 2 2.1 ...

  • Campbell Hausfeld CS115 - page 4

    This is a blank page. ...

  • Campbell Hausfeld CS115 - page 5

    1 CS115 Barometric Pressure Sensor The CS115 Barometric Pressure Sensor us es the resonant silicon technology pressure sensor developed by Druck. The sensor outputs a variable frequency which can be measured using the datalogger' s period averaging instruction or pulse count instruction. The entire process is essentially digital from sensor el ...

  • Campbell Hausfeld CS115 - page 6

    CS115 Barometric Pr essure Sensor 2 2. Specifications 2.1 Performance Measurem ent R ange: 600 mb t o 1100 mb (hPa) Operating Tem perature Range: -40°C to +60°C Hum idity Ran ge: non- condens ing Media Compatibility: non-corrosive gas Total Accuracy 1 : at 20°C ±0.3 mb -10°C to +50°C ±0.5 mb -20°C to +60°C ±1.5 mb -40°C to +60°C ±2.0 m ...

  • Campbell Hausfeld CS115 - page 7

    CS115 Barometric Pr essure Sensor 3 3. Installation 3.1 Venting and Condensati on To p revent condensation, install the se nsor in an en vironm entally protected enclosure, com plete w ith desiccant w hich should be chan ged at regular intervals. A s the sen sor mus t detect the external am bient pressu re the enclosu re mus t not be ‘hermeticall ...

  • Campbell Hausfeld CS115 - page 8

    CS115 Barometric Pr essure Sensor 4 As y ou m ount the sen sor onto the back plate of the enclosu re, place the fork lu g under the m ountin g screw to accomplish the proper groun ding of the s ensor as show n i n Fig ure 3-1. 3.3 Jumper Settings The CS115 ha s tw o operating m odes, ‘ contin uous’ and ‘tri ggered’ . It is norm ally shipped ...

  • Campbell Hausfeld CS115 - page 9

    CS115 Barometric Pr essure Sensor 5 4. Wiring The CS115 w iring instru ctions f or the exam ple program s are sh own in Table 4-1. For datal oggers C R500, CR510, C R10(X), CR 23X, and CR5000, analog ch annel is us ed for period averagin g meas uremen t. For CR7, 21X and CR9000 pu lse chann el is us ed for pulse cou nt m easurem ent. TABLE 4-1. Wir ...

  • Campbell Hausfeld CS115 - page 10

    CS115 Barometric Pr essure Sensor 6 Once th e CS115 is tu rned on one m inu te before every hour, an d the correct measu rement is m ade, it is then copied into the current variable called "Pressure" . The sensor is then turned off im m ediately follow ing the meas uremen t. In thi s exam ple, the CR 5000 measu res the CS 115 once every h ...

  • Campbell Hausfeld CS115 - page 11

    CS115 Barometric Pr essure Sensor 7 5.1 Period Averaging Measurement Examples 5.1.1 Period Averaging Measurement Example fo r CR10(X) EXAMPLE 1. Sam ple Program for CR 10(X) ;{CR 10X} ; *Table 1 Prog ram 01: 1 Execution Interval (seconds ) ;Turn on C S115 one m inut e before the h our ; 1: If tim e is (P92) 1: 59 Minutes (Seconds --) in to a 2: 60 ...

  • Campbell Hausfeld CS115 - page 12

    CS115 Barometric Pr essure Sensor 8 8: Sam ple (P70) 1: 1 Reps 2: 1* Loc [ P_m b ] *Table 2 Prog ram 02: 0.0000 Execution In terval (secon ds) *Table 3 S ubroutin es End Program -Input Loca tio ns- 1 P_m b * Proper entries w ill vary w ith program an d datalogger channel, and input location assign ments. 5.1.2 Period Averaging Measurement Example f ...

  • Campbell Hausfeld CS115 - page 13

    CS115 Barometric Pr essure Sensor 9 ;T urn off CS1 15 ; 4: Do (P86) 1: 58* Set Port 8* Low 5: If tim e is (P92) 1: 0 Minutes (Secon ds --) in to a 2: 60 Interval (sam e un its as above) 3: 1 0 Set Out put Flag H igh (Flag 0 ) 6: Real Tim e (P77) 1: 0110 Day ,Hour/Mi nute (m idnig ht = 0000) 7: Sam ple (P70) 1: 1 Reps 2: 1* Loc [ P_m b ] *Table 2 Pr ...

  • Campbell Hausfeld CS115 - page 14

    CS115 Barometric Pr essure Sensor 10 3: Period A verage (SE) (P27) 1: 1 Reps 2: 14 200 kHz Max Freq @ 500 m V Peak to Peak, F req Output 3: 24* SE Chan nel 4: 10 No. of Cy cles 5: 5 Timeou t (unit s = 0.01 seconds) 6: 1* Loc [ P_m b ] 7: 1000 Mult 8: 0.0 Of fset ;T urn off CS1 15 ; 4: Do (P86) 1: 51* Set Port 1* Low 5: End (P95) 6: If tim e is (P92 ...

  • Campbell Hausfeld CS115 - page 15

    CS115 Barometric Pr essure Sensor 11 5.1.4 Period Averaging Measurement Example fo r CR5000 in a Fast Executing Program at 10Hz EXAMPLE 4. Sam pl e Program for C R5000 ‘CR5000 ' 'Sample Progr am to Measure C S115 Barometri c Pressur e Sensor ' ' Public CS115_Freq, Pressu re Units Pressure = mb Begi nPr og Scan (100,m Sec,3,0) ...

  • Campbell Hausfeld CS115 - page 16

    CS115 Barometric Pr essure Sensor 12 5.2 Pulse Count Measure ment Exampl e 5.2.1 Pulse Count Measu rement Example for 21X EXAMPLE 5. Sam ple Program for 21X ;{21X} ; *Table 1 Prog ram 01: 1 Execution Interval (seconds ) 1: If tim e is (P92) 1: 59 Minu tes into a 2: 60 Minu te Interval 3: 46* Set Port 6* Hig h 2: If tim e is (P92) 1: 0 Minutes into ...

  • Campbell Hausfeld CS115 - page 17

    CS115 Barometric Pr essure Sensor 13 *Table 3 S ubroutin es End Program -Input Loca tio ns- 1 P_mb 1 1 1 * Proper entries w ill vary w ith program an d datalogger channel, and input location assign ments. 5.3 Output Resolution When s toring th e valu es from the CS115 t o a datalogger’ s fin al storage location, or to a da ta table, care must be ...

  • Campbell Hausfeld CS115 - page 18

    CS115 Barometric Pr essure Sensor 14 The corrections in volved can be signi ficant: e.g ., at 1000 mb an d 20°C, barometric pressure w ill decrease by 1.1 mb for ev ery 10 meter in crease in altitude. 7. Maintenance and Calibration Since the sen sor is sem i-sealed, m inim um m aintenan ce is required. 1. Visually inspect the cable conn ectio n to ...

  • Campbell Hausfeld CS115 - page 19

    Thi s is a b lank p age . ...

  • Campbell Hausfeld CS115 - page 20

    Campbell Scie ntific Com panies Campbell Scientific, Inc. (CS I) 815 West 1 800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com info@campb ellsci.com Campbell Scientif ic Africa Pty. Ltd. (CSAf) PO B ox 24 50 Somers et West 7129 SOUTH AFRICA www.csafrica.co.za sales@csafrica.co.za Campbell Scientific Au st ralia Pt y. Ltd. (CSA) PO B ox 4 ...

Fabricant Campbell Hausfeld Catégorie Marine Instruments

Les documents que nous recevons du fabricant de l'appareilCampbell Hausfeld CS115 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Campbell Hausfeld
- manuels d’utilisations CS115
- fiches produit Campbell Hausfeld
- dépliants
- ou étiquettes-énergie Campbell Hausfeld CS115
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Campbell Hausfeld CS115.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Campbell Hausfeld CS115, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Campbell Hausfeld CS115. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Campbell Hausfeld CS115.

Manuel d’utilisation complet de l’appareil Campbell Hausfeld CS115, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Campbell Hausfeld CS115 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Campbell Hausfeld CS115.

Le manuel d’utilisation complet Campbell Hausfeld, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Campbell Hausfeld CS115 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Campbell Hausfeld CS115, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lCampbell Hausfeld CS115 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Campbell Hausfeld CS115 - qui devraient nous aider dans les premières étapes lors de l'utilisation Campbell Hausfeld CS115
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Campbell Hausfeld CS115
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Campbell Hausfeld CS115 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Campbell Hausfeld CS115?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Campbell Hausfeld CS115, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Campbell Hausfeld CS115 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)