Français dropdown-ico

Manuel d’utilisation Chamberlain RDO800

24 pages 2.56 mb
Télécharger

Aller à la page of 24

Summary
  • Chamberlain RDO800 - page 1

    Installa tion an d operating instr u ctions for rolling d oor opener Mo d el RDO800-series Chamberlain GmbH Alfred-Nobel-S trasse 4 66793 Saarwellingen Germany TEL: +49 (0) 6838/907-250 F AX: +49 (0) 6838/907-179 www .liftmaster .com ...

  • Chamberlain RDO800 - page 2

    1 The Protector System must be used for all installations where the closing force as measured on the bottom of the door is over 400N (40kgf). Excessive force will interfere with the proper operation of the Safety Reverse System or damage the garage door . After installation, ensure that the parts of the door do not extend over public footpaths or r ...

  • Chamberlain RDO800 - page 3

    2 Door Requirements 3 Ensure that there is at least 45mm from the edge of the curtain to the edge of the bracket. If the roller door drums are on the edge of the curtain or are of small diameter additional clearance maybe required. If the drums are more than 60mm from the curtain edge or of small diameter extension poles maybe required. Different d ...

  • Chamberlain RDO800 - page 4

    3 Prepare Opener 5 For left hand side installations the wire jumper should be removed . Place the Opener in Manual Release mode. Pull the release cord down and across to engage the ball into the cup. The drive forks should now be able to be moved manually . NOTE: T o re-engage the opener , pull the release cord across and up. For right hand side in ...

  • Chamberlain RDO800 - page 5

    4 Installation steps 6 FOR RIGHT HAND INST ALLA TIONS (REFER SECTION 5, page 3) 1. Ensure that the opener position jumper (wire connector) is in place (refer section 5, page 3). 2. Place the opener in manual release mode (refer section 5, page 3). 3. Open the roller door fully . For safety , tie a rope around the door . 4. Ensure that the U-bolt on ...

  • Chamberlain RDO800 - page 6

    Pinning the Door 9 Use bolts or pop-rivet s (not supplied) to hold the curt ain to the door drum. 1. Pull the release cord down and across to engage the ball into the cup. Close the door manually . Pull the release cord across and release to re-engage the opener . 2. T ry to manually open the door with the opener engaged. Any excess door curtain ma ...

  • Chamberlain RDO800 - page 7

    6 Program your Opener & Remote Please note your remote controls and wall plate have already been programmed into your operator . Activate the opener only when door is in full view , free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s) ...

  • Chamberlain RDO800 - page 8

    7 Setting the Force The force, as measured on the closing edge of the door , should not exceed 400N (40kgf). If the closing force is measured to more than 400N, the Protector System must be installed. See section 14. The force setting regulates the amount of power required to open and close the door . 1. Press the purple button (1) twice to enter o ...

  • Chamberlain RDO800 - page 9

    8 CARE OF YOUR OPENER When properly installed, your opener will provide high performance with a minimum of maintenance. The opener does not require additional lubrication. Limit and Force Settings: These settings must be checked and properly set when the opener is installed. W eather conditions may cause some minor changes in the door operation, re ...

  • Chamberlain RDO800 - page 10

    9 Troubleshooting 1. The opener doesn't operate from either the green start button or the remote controls: • Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box. • Have you disabled all door locks? Review installation instruction warnings on page 1. • Is there a build-up of ice o ...

  • Chamberlain RDO800 - page 11

    10 OPERATION OF YOUR OPENER Y our opener can be activated by any of the following devices: • The green start button Hold the button down until door start s to move. • The W all Control, Outside Keylock or Keyless Entry System (if you have installed any of these accessories). • The Remote Control Transmitter or W ireless Wall Control (128LM) H ...

  • Chamberlain RDO800 - page 12

    GARAGE DOOR OPENER W ARRANTY Chamberlain warrants to the first retail purchaser of this product that the product shall be free from any defect in materials and/or workmanship for a period of 24 full months (2 years) from the date of purchase. Upon receipt of the product, the first retail purchaser is under obligation to check the product for any vi ...

  • Chamberlain RDO800 - page 13

    Installa tion and operating instr uctions for rolling door opener Model RDO800GB Chamberlain GmbH Alfred-Nobel-S trasse 4 66793 Saarwellingen Germany TEL: +49 (0) 6838/907-250 F AX: +49 (0) 6838/907-179 www .liftmaster .com ...

  • Chamberlain RDO800 - page 14

    1 The Protector System must be used for all installations where the closing force as measured on the bottom of the door is over 400N (40kgf). Excessive force will interfere with the proper operation of the Safety Reverse System or damage the garage door . After installation, ensure that the parts of the door do not extend over public footpaths or r ...

  • Chamberlain RDO800 - page 15

    2 Door Requirements 3 Ensure that there is at least 45mm from the edge of the curtain to the edge of the bracket. If the roller door drums are on the edge of the curtain or are of small diameter additional clearance maybe required. If the drums are more than 60mm from the curtain edge or of small diameter extension poles maybe required. Different d ...

  • Chamberlain RDO800 - page 16

    3 Prepare Opener 5 For left hand side installations the wire jumper should be removed . Place the Opener in Manual Release mode. Disengage: Pull the release cord down once until you hear a clicking sound. The operator is now in manual mode and may be opened or closed. Engage: T o re-engage the opener , pull the release cord down until you hear a cl ...

  • Chamberlain RDO800 - page 17

    4 Installation steps 6 FOR RIGHT HAND INST ALLA TIONS (REFER SECTION 5, page 3) 1. Ensure that the opener position jumper (wire connector) is in place (refer section 5, page 3). 2. Place the opener in manual release mode (refer section 5, page 3). 3. Open the roller door fully . For safety , tie a rope around the door . 4. Ensure that the U-bolt on ...

  • Chamberlain RDO800 - page 18

    Pinning the Door 9 Use bolts or pop-rivet s (not supplied) to hold the curt ain to the door drum. 1. Pull the release cord down and across to engage the ball into the cup. Close the door manually . Pull the release cord across and release to re-engage the opener . 2. T ry to manually open the door with the opener engaged. Any excess door curtain ma ...

  • Chamberlain RDO800 - page 19

    6 Program your Opener & Remote Please note your remote controls and wall plate have already been programmed into your operator . Activate the opener only when door is in full view , free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s) ...

  • Chamberlain RDO800 - page 20

    7 Setting the Force The force, as measured on the closing edge of the door , should not exceed 400N (40kgf). If the closing force is measured to more than 400N, the Protector System must be installed. See section 14. The force setting regulates the amount of power required to open and close the door . 1. Press the purple button (1) twice to enter o ...

  • Chamberlain RDO800 - page 21

    8 CARE OF YOUR OPENER When properly installed, your opener will provide high performance with a minimum of maintenance. The opener does not require additional lubrication. Limit and Force Settings: These settings must be checked and properly set when the opener is installed. W eather conditions may cause some minor changes in the door operation, re ...

  • Chamberlain RDO800 - page 22

    9 Troubleshooting 1. The opener doesn't operate from either the green start button or the remote controls: • Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box. • Have you disabled all door locks? Review installation instruction warnings on page 1. • Is there a build-up of ice o ...

  • Chamberlain RDO800 - page 23

    10 OPERATION OF YOUR OPENER Y our opener can be activated by any of the following devices: • The green start button Hold the button down until door start s to move. • The W all Control, Outside Keylock or Keyless Entry System (if you have installed any of these accessories). • The Remote Control Transmitter or W ireless Wall Control (128LM) H ...

  • Chamberlain RDO800 - page 24

    GARAGE DOOR OPENER W ARRANTY Chamberlain warrants to the first retail purchaser of this product that the product shall be free from any defect in materials and/or workmanship for a period of 24 full months (2 years) from the date of purchase. Upon receipt of the product, the first retail purchaser is under obligation to check the product for any vi ...

Fabricant Chamberlain Catégorie Garage Door Opener

Les documents que nous recevons du fabricant de l'appareilChamberlain RDO800 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Chamberlain
- manuels d’utilisations RDO800
- fiches produit Chamberlain
- dépliants
- ou étiquettes-énergie Chamberlain RDO800
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Chamberlain RDO800.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Chamberlain RDO800, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Chamberlain RDO800. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Chamberlain RDO800.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Chamberlain RDO800, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Chamberlain RDO800 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Chamberlain RDO800.

Le manuel d’utilisation complet Chamberlain, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Chamberlain RDO800 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Chamberlain RDO800, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lChamberlain RDO800 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Chamberlain RDO800 - qui devraient nous aider dans les premières étapes lors de l'utilisation Chamberlain RDO800
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Chamberlain RDO800
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Chamberlain RDO800 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Chamberlain RDO800?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Chamberlain RDO800, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Chamberlain RDO800 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)