Chamberlain RDO800の取扱説明書

24ページ 2.56 mb
ダウンロード

ページに移動 of 24

Summary
  • Chamberlain RDO800 - page 1

    Installa tion an d operating instr u ctions for rolling d oor opener Mo d el RDO800-series Chamberlain GmbH Alfred-Nobel-S trasse 4 66793 Saarwellingen Germany TEL: +49 (0) 6838/907-250 F AX: +49 (0) 6838/907-179 www .liftmaster .com ...

  • Chamberlain RDO800 - page 2

    1 The Protector System must be used for all installations where the closing force as measured on the bottom of the door is over 400N (40kgf). Excessive force will interfere with the proper operation of the Safety Reverse System or damage the garage door . After installation, ensure that the parts of the door do not extend over public footpaths or r ...

  • Chamberlain RDO800 - page 3

    2 Door Requirements 3 Ensure that there is at least 45mm from the edge of the curtain to the edge of the bracket. If the roller door drums are on the edge of the curtain or are of small diameter additional clearance maybe required. If the drums are more than 60mm from the curtain edge or of small diameter extension poles maybe required. Different d ...

  • Chamberlain RDO800 - page 4

    3 Prepare Opener 5 For left hand side installations the wire jumper should be removed . Place the Opener in Manual Release mode. Pull the release cord down and across to engage the ball into the cup. The drive forks should now be able to be moved manually . NOTE: T o re-engage the opener , pull the release cord across and up. For right hand side in ...

  • Chamberlain RDO800 - page 5

    4 Installation steps 6 FOR RIGHT HAND INST ALLA TIONS (REFER SECTION 5, page 3) 1. Ensure that the opener position jumper (wire connector) is in place (refer section 5, page 3). 2. Place the opener in manual release mode (refer section 5, page 3). 3. Open the roller door fully . For safety , tie a rope around the door . 4. Ensure that the U-bolt on ...

  • Chamberlain RDO800 - page 6

    Pinning the Door 9 Use bolts or pop-rivet s (not supplied) to hold the curt ain to the door drum. 1. Pull the release cord down and across to engage the ball into the cup. Close the door manually . Pull the release cord across and release to re-engage the opener . 2. T ry to manually open the door with the opener engaged. Any excess door curtain ma ...

  • Chamberlain RDO800 - page 7

    6 Program your Opener & Remote Please note your remote controls and wall plate have already been programmed into your operator . Activate the opener only when door is in full view , free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s) ...

  • Chamberlain RDO800 - page 8

    7 Setting the Force The force, as measured on the closing edge of the door , should not exceed 400N (40kgf). If the closing force is measured to more than 400N, the Protector System must be installed. See section 14. The force setting regulates the amount of power required to open and close the door . 1. Press the purple button (1) twice to enter o ...

  • Chamberlain RDO800 - page 9

    8 CARE OF YOUR OPENER When properly installed, your opener will provide high performance with a minimum of maintenance. The opener does not require additional lubrication. Limit and Force Settings: These settings must be checked and properly set when the opener is installed. W eather conditions may cause some minor changes in the door operation, re ...

  • Chamberlain RDO800 - page 10

    9 Troubleshooting 1. The opener doesn't operate from either the green start button or the remote controls: • Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box. • Have you disabled all door locks? Review installation instruction warnings on page 1. • Is there a build-up of ice o ...

  • Chamberlain RDO800 - page 11

    10 OPERATION OF YOUR OPENER Y our opener can be activated by any of the following devices: • The green start button Hold the button down until door start s to move. • The W all Control, Outside Keylock or Keyless Entry System (if you have installed any of these accessories). • The Remote Control Transmitter or W ireless Wall Control (128LM) H ...

  • Chamberlain RDO800 - page 12

    GARAGE DOOR OPENER W ARRANTY Chamberlain warrants to the first retail purchaser of this product that the product shall be free from any defect in materials and/or workmanship for a period of 24 full months (2 years) from the date of purchase. Upon receipt of the product, the first retail purchaser is under obligation to check the product for any vi ...

  • Chamberlain RDO800 - page 13

    Installa tion and operating instr uctions for rolling door opener Model RDO800GB Chamberlain GmbH Alfred-Nobel-S trasse 4 66793 Saarwellingen Germany TEL: +49 (0) 6838/907-250 F AX: +49 (0) 6838/907-179 www .liftmaster .com ...

  • Chamberlain RDO800 - page 14

    1 The Protector System must be used for all installations where the closing force as measured on the bottom of the door is over 400N (40kgf). Excessive force will interfere with the proper operation of the Safety Reverse System or damage the garage door . After installation, ensure that the parts of the door do not extend over public footpaths or r ...

  • Chamberlain RDO800 - page 15

    2 Door Requirements 3 Ensure that there is at least 45mm from the edge of the curtain to the edge of the bracket. If the roller door drums are on the edge of the curtain or are of small diameter additional clearance maybe required. If the drums are more than 60mm from the curtain edge or of small diameter extension poles maybe required. Different d ...

  • Chamberlain RDO800 - page 16

    3 Prepare Opener 5 For left hand side installations the wire jumper should be removed . Place the Opener in Manual Release mode. Disengage: Pull the release cord down once until you hear a clicking sound. The operator is now in manual mode and may be opened or closed. Engage: T o re-engage the opener , pull the release cord down until you hear a cl ...

  • Chamberlain RDO800 - page 17

    4 Installation steps 6 FOR RIGHT HAND INST ALLA TIONS (REFER SECTION 5, page 3) 1. Ensure that the opener position jumper (wire connector) is in place (refer section 5, page 3). 2. Place the opener in manual release mode (refer section 5, page 3). 3. Open the roller door fully . For safety , tie a rope around the door . 4. Ensure that the U-bolt on ...

  • Chamberlain RDO800 - page 18

    Pinning the Door 9 Use bolts or pop-rivet s (not supplied) to hold the curt ain to the door drum. 1. Pull the release cord down and across to engage the ball into the cup. Close the door manually . Pull the release cord across and release to re-engage the opener . 2. T ry to manually open the door with the opener engaged. Any excess door curtain ma ...

  • Chamberlain RDO800 - page 19

    6 Program your Opener & Remote Please note your remote controls and wall plate have already been programmed into your operator . Activate the opener only when door is in full view , free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s) ...

  • Chamberlain RDO800 - page 20

    7 Setting the Force The force, as measured on the closing edge of the door , should not exceed 400N (40kgf). If the closing force is measured to more than 400N, the Protector System must be installed. See section 14. The force setting regulates the amount of power required to open and close the door . 1. Press the purple button (1) twice to enter o ...

  • Chamberlain RDO800 - page 21

    8 CARE OF YOUR OPENER When properly installed, your opener will provide high performance with a minimum of maintenance. The opener does not require additional lubrication. Limit and Force Settings: These settings must be checked and properly set when the opener is installed. W eather conditions may cause some minor changes in the door operation, re ...

  • Chamberlain RDO800 - page 22

    9 Troubleshooting 1. The opener doesn't operate from either the green start button or the remote controls: • Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box. • Have you disabled all door locks? Review installation instruction warnings on page 1. • Is there a build-up of ice o ...

  • Chamberlain RDO800 - page 23

    10 OPERATION OF YOUR OPENER Y our opener can be activated by any of the following devices: • The green start button Hold the button down until door start s to move. • The W all Control, Outside Keylock or Keyless Entry System (if you have installed any of these accessories). • The Remote Control Transmitter or W ireless Wall Control (128LM) H ...

  • Chamberlain RDO800 - page 24

    GARAGE DOOR OPENER W ARRANTY Chamberlain warrants to the first retail purchaser of this product that the product shall be free from any defect in materials and/or workmanship for a period of 24 full months (2 years) from the date of purchase. Upon receipt of the product, the first retail purchaser is under obligation to check the product for any vi ...

メーカー Chamberlain カテゴリー Garage Door Opener

Chamberlain RDO800のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- RDO800の取扱説明書
- Chamberlainの製品カード
- パンフレット
- またはChamberlain RDO800の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Chamberlain RDO800の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Chamberlain RDO800の取り付け説明書、サービスマニュアル、簡易説明書、またはChamberlain RDO800のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Chamberlain RDO800の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Chamberlain RDO800デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがChamberlain RDO800を使用するのを助ける技術的文書のことです。説明書は通常、全てのChamberlain RDO800ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Chamberlainの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Chamberlain RDO800の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははChamberlain RDO800の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Chamberlain RDO800に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Chamberlain RDO800デバイスの基本機能を使うにあたってのヒント。 Chamberlain RDO800のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Chamberlain RDO800に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるChamberlain RDO800のメーカー/サービスへの連絡先に関する情報。

Chamberlain RDO800についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもChamberlain RDO800の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがChamberlain RDO800で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)