Italiano dropdown-ico

Manuale per l’uso Alto-Shaam 4.10ESi

28 pagine 2.35 mb
Scarica

Vai alla pagina of 28

Summary
  • Alto-Shaam 4.10ESi - page 1

    MN-29805 • 08/12 printed i n u . s . a . Combitherm ® Combination Oven / Steamer CT EXPRESS™ 4•10es i 4•10esiVH   • InstallatIon W164 N9221 Water Street • P.O. Box 450 • Menomonee Falls, Wisconsin 53052-0450 USA PHONE: 262.251.3800 • 800.558.8744 u s a / c a N a d a FaX: 262.251.7067 • 800.329.8744 u . s . a . O N l y ww ...

  • Alto-Shaam 4.10ESi - page 2

    i Delivery .................................. 1 Unpacking ................................ 1 Safety Procedures and Precautions ............. 2 Installation Site Installation .......................... 3 Ventilation Requirements ................... 3 Positioning on Site ........................ 4 Lifting Instructions ........................ 5 Level ...

  • Alto-Shaam 4.10ESi - page 3

     INSTALLATION MANUAL • 1. DELIVERY This Alto-Shaam appliance has been thoroughly tested and inspected to ensure only the highest quality unit is provided. Upon receipt, check for any possible shipping damage and report it at once to the delivering carrier. See Transportation Damage and Claims section located in th ...

  • Alto-Shaam 4.10ESi - page 4

     INSTALLATION MANUAL • 2. CAUTION Used to indicate the presence of a hazard that can or will cause minor personal injury, property damage, or a potential unsafe practice if the warning included with this symbol is ignored. CAUTION Used to indicate the presence of a hazard that can or will cause minor or moderate p ...

  • Alto-Shaam 4.10ESi - page 5

     INSTALLATION MANUAL • 3. SITE INSTALLATION INSTALLATION DANGER IMPROPER INSTALLATION, ALTERATION, ADJUSTMENT, SERVICE, OR MAINTENANCE COULD RESULT IN SEVERE INJURY, DEATH, OR CAUSE PROPERTY DAMAGE. READ THE INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING OR SERVICING THIS EQUIPME ...

  • Alto-Shaam 4.10ESi - page 6

     INSTALLATION MANUAL • 4. NOTE: Note dimensions required for doorways and aisles for access of the oven and pallet to the installation site. Transport the oven in an upright and level position only. Do not tilt the oven. ® SITE INSTALLATION INSTALLATION POSITIONING ON SITE Stand the oven in a level position. Use ...

  • Alto-Shaam 4.10ESi - page 7

     INSTALLATION MANUAL • 5. LIFTING INSTRUCTIONS INSTALLATION Remove banding before lifting. Lift the unit from either side of the unit, never from the front o r back . Adjust the forks so that they do not damage any of the components under the unit. Air intake vents are located in front of the legs and must not be ...

  • Alto-Shaam 4.10ESi - page 8

     INSTALLATION MANUAL • 6. SITE INSTALLATION INSTALLATION EXHAUST VENT 18" (46cm) 4" (102mm) 4" (102mm) 20" (50cm) MINIMUM 20" (50cm) POSITIONING REQUIREMENTS q In order to ensure proper ventilation, a minimum distance of at least 4-inches (101mm) must be kept from the sides of the oven and ...

  • Alto-Shaam 4.10ESi - page 9

     INSTALLATION MANUAL • 7. ACCESSORIES CombiClean® Tablets — CE-28892 s P E c i a l l y F O r M u l a t E d FOr cOMbitHErM OvENs ➥ t w O (2) c O N t a i N E r s / bOX , 90 PackEts E a c H c O N t a i N E r Combitherm Cleaning Liquid — CE-24750 s P E c i a l l y F O r M u l a t E d FOr cOMbitHErM OvENs ➥ t ...

  • Alto-Shaam 4.10ESi - page 10

     INSTALLATION MANUAL • 8. WATER REQUIREMENTS WATER QUALITY MINIMUM STANDARDS ONE (1) COLD W A TER INLETS - DRINKING QUALITY ONE (1) W A TER INLET : 3/4" G* LI NE PR ES SU RE: 30 to 90 psi 2.8 to 6.2 bar W A TER DRAIN: 1-1/2" CONNECTION WITH A 2" MINIMUM AIR GAP INST ALLED AS CLOSE TO THE OVEN AS POS ...

  • Alto-Shaam 4.10ESi - page 11

     INSTALLATION MANUAL • 9. WATER REQUIREMENTS WATER QUALITY MINIMUM STANDARDS ONE (1) COLD W A TER INLETS - DRINKING QUALITY ONE (1) W A TER INLET : 3/4" G* LI NE PR ES SU RE: 30 to 90 psi 2.8 to 6.2 bar W A TER DRAIN: 1-1/2" CONNECTION WITH A 2" MINIMUM AIR GAP INST ALLED AS CLOSE TO THE OVEN AS POS ...

  • Alto-Shaam 4.10ESi - page 12

     INSTALLATION MANUAL •  ELECTRICAL CONNECTION INSTALLATION DANGER ENSURE POWER SOURCE MATCHES VOLTAGE IDENTIFIED ON APPLIANCE RATING TAG. DANGER To avoid electrical shock, this appliance MUST be adequately grounded in accordance with local electrical codes or, in the absence of local codes, with the curre ...

  • Alto-Shaam 4.10ESi - page 13

     INSTALLATION MANUAL • 11. ELECTRICAL CONNECTION INSTALLATION DANGER ELECTRICAL CONNECTIONS MUST BE MADE BY A QUALIFIED SERVICE TECHNICIAN IN ACCORDANCE WITH APPLICABLE ELECTRICAL CODES. INTERNAL GROUND STUD CUSTOMER MUST SUPPLY CORD INCOMING ELECTRICAL TERMINALS APPLIES TO 208-240V & 380-415V UNITS L1 L2 L3 N ...

  • Alto-Shaam 4.10ESi - page 14

     INSTALLATION MANUAL • 12. MOBILE EQUIPMENT RESTRAINT INSTALLATION Any appliance that is not furnished with a power supply cord but includes a set of casters, stand with casters, or a stacked configuration must be installed with a tether. Adequate means must be provided to limit the movement of this appliance with ...

  • Alto-Shaam 4.10ESi - page 15

     INSTALLATION MANUAL • 13. INSTALLATION WATER QUALITY REQUIREMENT WARNING TO PREVENT WATER PIPES FROM BURSTING, INCOMING WATER SUPPLY SHOULD BE TURNED OFF WHEN THE APPLIANCE IS NOT IN USE. WARNING WATER SUPPLY MUST BE OPEN WHEN CLEANING PROGRAM IS ACTIVATED. VERIFY WATER SUPPLY BEFORE STARTING CLEANING PROGRAM. US ...

  • Alto-Shaam 4.10ESi - page 16

     INSTALLATION MANUAL • 14. INSTALLATION WATER CONNECTIONS WATER SUPPLY & INSTALLATION WATER REQUIREMENTS ONE (1) COLD WATER INLET - DRINKING QUALITY ONE (1) TREATED WATER INLET: 3/4" G LINE PRESSURE: 30 to 90 psi 2.8 to 6.2 bar REFER TO PUBLISHED SPECIFIC W A TER REQUIREMENTS WATER DRAIN: 1-1/2" CONN ...

  • Alto-Shaam 4.10ESi - page 17

     INSTALLATION MANUAL • 15. INSTALLATION OPTIONAL HAND HELD SPRAY HOSE V alve bracket INSTALLATION 1 Using the valve bracket as a template for placement, and a #28 drill bit (0.14" diameter), drill two holes at the lower rear side of the unit (same side as door opening). Fasten the valve bracket using the 2 se ...

  • Alto-Shaam 4.10ESi - page 18

     INSTALLATION MANUAL • 16. INSTALLATION WATER VALVE WATER DRAINAGE NOTE: THE SHUT-OFF VALVE MUST BE IN THE OPEN POSITION WHEN THE OVEN IS BEING USED. The oven must discharge through an indirect waste pipe by means of an air gap. The drain fitting is supplied with a 1-1/2-inch (38mm) NPT thread. A union is required ...

  • Alto-Shaam 4.10ESi - page 19

     INSTALLATION MANUAL • 17. INDICATOR LIGHT If the indicator light does not illuminate, the filters may be missing or not properly aligned. Check them for proper positioning. Ventless hood and oven will not operate unless the hood is closed properly. INSTALLATION VENTLESS HOOD MODEL The Ventless Hood option is fact ...

  • Alto-Shaam 4.10ESi - page 20

     INSTALLATION MANUAL • 18. INSTALLATION VENTLESS HOOD MODEL TOP EXHAUST VENT 1 Charcoal Filter: The charcoal filter should be inspected for contaminant's on a regular basis. Replacement must be made at a minimum of three month intervals — more often if heavy contaminant's are visible or if the filter n ...

  • Alto-Shaam 4.10ESi - page 21

     INSTALLATION MANUAL • 19. INSTALLATION CT EXPRESS™ CHECKLIST Use this list as a nal check of oven installation conformance. Damage directly attributed to improper set up, installation, or cleaning can invalidate warranty claims. CLEARANCES: Left: 4" (152mm) — Service access of 18" (457mm) recomme ...

  • Alto-Shaam 4.10ESi - page 22

     INSTALLATION MANUAL •  continued on next page ERROR CODES This section is provided for the assistance of qualified technicians only and is not intended for use by untrained or unauthorized service personnel. If your Alto-Shaam ® unit is not operating properly , check the following before calling your Au ...

  • Alto-Shaam 4.10ESi - page 23

     INSTALLATION MANUAL • 21. continued on next page ERROR CODES Error Code Error Call Out in Display Description of Error Possible Cause E13   — Scale build up in ...

  • Alto-Shaam 4.10ESi - page 24

     INSTALLATION MANUAL • 22. ERROR CODES Error Code Error Call Out in Display Description of Error Possible Cause E34 Steam Generator Drain  Water level in steam generator does not drop during cleaning program  ? ...

  • Alto-Shaam 4.10ESi - page 25

     INSTALLATION MANUAL • 23. ERROR CODES Error Code Error Call Out in Display Description of Error Possible Cause E57 No Rinse Water During rinse no water    solenoid valve  ? ...

  • Alto-Shaam 4.10ESi - page 26

     INSTALLATION MANUAL • 24. ERROR CODES When the oven malfunctions, an error code will appear in the display . PRESS THE ST AR T ICON TO ACKNOWLEDGE THE ERROR. The icons that begin to flash repr esent operational modes that are still usable. When the oven fault is corrected, the Combitherm will r eturn to normal op ...

  • Alto-Shaam 4.10ESi - page 27

     INSTALLATION MANUAL • 25. ORIGINAL EQUIPMENT LIMITED WARRANTY Alto-Shaam, Inc. warrants to the original purchaser that any original part that is found to be defective in material or workmanship will, at Alto-Shaam’s option, subject to provisions hereinafter stated, be replaced with a new or rebuilt part. The la ...

  • Alto-Shaam 4.10ESi - page 28

    TRANSPORTATION DAMAGE AND CLAIMS All Alto-Shaam equipment is sold F.O.B. shipping point, and when accepted by the carrier, such shipments become the property of the consignee. Should damage occur in shipment, it is a matter between the carrier and the consignee. In such cases, the carrier is assumed to be responsible for the safe delivery of the me ...

Fabbricante Alto-Shaam Categoria Oven

I documenti che otteniamo dal fabbricante del dispositivoAlto-Shaam 4.10ESi possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Alto-Shaam
- manuali per l’uso 4.10ESi
- schede prodotto Alto-Shaam
- opuscoli
- o etichette energetiche Alto-Shaam 4.10ESi
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Alto-Shaam 4.10ESi.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Alto-Shaam 4.10ESi, manuali di manutenzione, brevi manuali o manuali utente Alto-Shaam 4.10ESi. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Alto-Shaam 4.10ESi.

Manuali per l’uso simili

Manuale completo del dispositivo Alto-Shaam 4.10ESi, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Alto-Shaam 4.10ESi dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Alto-Shaam 4.10ESi.

Il manuale per l’uso completo Alto-Shaam, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Alto-Shaam 4.10ESi - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Alto-Shaam 4.10ESi, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Alto-Shaam 4.10ESi che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Alto-Shaam 4.10ESi - che ci dovrebbe aiutare nei primi passi durante l'uso Alto-Shaam 4.10ESi
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Alto-Shaam 4.10ESi
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Alto-Shaam 4.10ESi in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Alto-Shaam 4.10ESi?

Utilizza il modulo sottostante

Se non hai risolto il problema con Alto-Shaam 4.10ESi con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Alto-Shaam 4.10ESi è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Captcha
Nuova immagine

Commenti (0)