Axxess Interface Automobile Accessoriesの取扱説明書

12ページ 0.83 mb
ダウンロード

ページに移動 of 12

Summary
  • Axxess Interface Automobile Accessories - page 1

    © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORA TION 1-800-221-0932 axxessinterf ace.com INST ALLA TION INSTRUCTIONS FOR PART RF ASWC The RF ASWC is designed for adding steering wheel controls to vehicles that do not have OE steering wheel controls installed. With Aftermarket radio’s with steering wheel control outputs the RF ASWC is able to giv ...

  • Axxess Interface Automobile Accessories - page 2

    Mounting The RF ASWC T ransmitter 1. Place button pad in the OESWC transmitter with the volume up arrow (^) in the spot where you want volume up to be.(g. 1) 2. Snap in trim ring to secure keypad in place. (g. 2) 3. Install the OESWC transmitter in desired place on steering wheel, wrapping the rubber strap around the steering wheel, through t ...

  • Axxess Interface Automobile Accessories - page 3

    Wiring The OESWC Interface 1. Connect the red wire to 12 volt accessory 2. Connect the Black wire to ground (you may use the same ground that you use for the aftermarket radio) If you are using an Eclipse or Kenwood radio, plug the female 3.5mm connector with the Brown and Brown/White wires into the male 3.5mm connector of the ASWC harness. * For K ...

  • Axxess Interface Automobile Accessories - page 4

    2. T urn on the ignition and press volume up on the RF ASWC. This will “marry“ the RF ASWC to the interface. NOTE: If you are replacing a transmitter you must turn on the ignition and within the rst 10 seconds press and hold the source button for ten seconds. This will “marry the new transmitter . Programming the RF ASWC 1. Complete connec ...

  • Axxess Interface Automobile Accessories - page 5

    5. The led will then ash up to 10 times. 6. This is the end of the auto detection stage. If the RF ASWC detected the radio successfully the led will light up solid red. 7. Make sure the steering wheel control buttons function correctly in the vehicle and enjoy your radio. So what if the led does not light up solid red? Check out troubleshooting ...

  • Axxess Interface Automobile Accessories - page 6

    Once all the information above has been veried and correct, refer back to the 2 sets of led ashes during the auto detect sequence. Here is what the ashes stand for: LED Feedback The led ashes represent what brand radio the RF ASWC believes it is connected to. Each ash is for a different radio manufacturer . For example you installed ...

  • Axxess Interface Automobile Accessories - page 7

    Remapping the SWC Buttons Let’s say you have the RF ASWC programmed to your radio and you want to change the button assignment for the steering wheel controls. For instance you would like Seek Up to be Mute. NOTES: • The RF ASWC must have detected the radio it is attached to before you can remap any buttons. • Y ou can only start the remappin ...

  • Axxess Interface Automobile Accessories - page 8

    5. Follow the list below in order however pushing the steering wheel control button you want for the function below . If you want to skip a command press the V olume Up on the steering wheel, this will tell the ASWC to skip the command and go to the next one. 1. V olume Up 2. V olume Down 3. Seek Up/Next 4. Seek Down/Prev 5. Source/Mode 6. Mute 7. ...

  • Axxess Interface Automobile Accessories - page 9

    * Note: Remember not all radios will have all these commands. Please refer to the radios’ owners manual for specic commands recognized by the radio. For instance the next command to be mapped is the V olume Down command. Let’s say you want the Mode button on your steering wheel to be the V olume Down command. Hold down the Mode button till t ...

  • Axxess Interface Automobile Accessories - page 10

    2. The led will turn on then release the V olume Down button and the led will turn off. 3. The original steering wheel control settings will be restored. Manually Setting The Radio T ype 1. Within the rst 20 seconds of turning the ignition on. Press and hold down the original V olume Down button (not the V olume Down button you just remapped) fo ...

  • Axxess Interface Automobile Accessories - page 11

    4. If you have a different radio then Eclipse, press the V olume Up button again till the led goes solid red, then release V olume Up. Y ou have now programmed Kenwood. 5. Here is the chart to show how many presses of the V olume Up button is needed for which radio you are trying to program: 1st led ash is for Eclipse 2nd led ash is for Kenwo ...

  • Axxess Interface Automobile Accessories - page 12

    REV . 1/10/1 1 1-800-221-0932 axxessinterf ace.com © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORA TION INST ALLA TION INSTRUCTIONS FOR PART RF ASWC K NO WLEDGE IS P OW ER E nhance your installation and fabrication skills by enrolling in the most re cognized and re spected mobile electronics school in our industry . Log onto www .installerinstitut ...

メーカー Axxess Interface カテゴリー Automobile Accessories

Axxess Interface Automobile Accessoriesのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- Automobile Accessoriesの取扱説明書
- Axxess Interfaceの製品カード
- パンフレット
- またはAxxess Interface Automobile Accessoriesの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Axxess Interface Automobile Accessoriesの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Axxess Interface Automobile Accessoriesの取り付け説明書、サービスマニュアル、簡易説明書、またはAxxess Interface Automobile Accessoriesのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Axxess Interface Automobile Accessoriesの製品を使用するにあたって最も人気のある説明書を閲覧できます。

Axxess Interface Automobile Accessoriesデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがAxxess Interface Automobile Accessoriesを使用するのを助ける技術的文書のことです。説明書は通常、全てのAxxess Interface Automobile Accessoriesユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Axxess Interfaceの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Axxess Interface Automobile Accessoriesの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははAxxess Interface Automobile Accessoriesの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Axxess Interface Automobile Accessoriesに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Axxess Interface Automobile Accessoriesデバイスの基本機能を使うにあたってのヒント。 Axxess Interface Automobile Accessoriesのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Axxess Interface Automobile Accessoriesに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるAxxess Interface Automobile Accessoriesのメーカー/サービスへの連絡先に関する情報。

Axxess Interface Automobile Accessoriesについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもAxxess Interface Automobile Accessoriesの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがAxxess Interface Automobile Accessoriesで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (1)

TimothyDep

Roller Door Servicing & Maintenance in Adelaide As with many mechanical devices, it is recommended that your garage door be serviced every 1-2 years depending on how frequently the door is used, environmental conditions etc. This helps prevent breakdowns and of course avoids inconvenience. Over time, springs lose tension, dirt and grime builds up in the guides, buildings move and motor parts wear. We’ll take the time to correctly service your door, as opposed to just fixing the problem. We gladly offer our customers a call back option where we will contact you when your door is next due for its service. A couple of things you can do to extend the life of your door include: Keep the tracks clean at all times Lubricate the tracks – this should NEVER be done with grease or oil! Only Silicon sprayed should be used – spray a little on the tracks and then wipe through with a clean rag. So... should you door be due (or overdue!) for some tender loving care, give our friendly team a call at Fast Fix Roller Doors and we will have you booked in within days and your door back up and running the way it should be! Call us today to arrange an appointment: (08) 8182 5787 <a href="http:/fastfixrollerdoors.com.au">doors</a>