English dropdown-ico

Manual Bunn 4

16 pages 1.67 mb
Download

Go to site of 16

Summary
  • Bunn 4 - page 1

    IMIX-3 IMIX-4 IMIX-5 INST ALLA TION & OPERA TING MANUAL BUNN-O-MA TIC CORPORA TION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 F AX: (217) 529-6644 37510.0000D 01/06 ©2004 Bunn-O-Matic Corporation www .bunnomatic.com ...

  • Bunn 4 - page 2

    2 BUNN-O-MA TIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) All equipment other than as specifi ed below: 2 years parts and 1 year labor . 2) Electronic circuit and/or control boards: parts and labor for 3 years. 3) Compressors on refrigeration equipment: 5 years parts and 1 year ...

  • Bunn 4 - page 3

    3 W ARNING ! Fill water tank before turning - on - thermostat or connecting appliance to power source. Use only on a properly protected circuit capable of the rated load. Electrically ground the chassis. Follow national/local electrical codes. Do not use near combustibles. F AILURE TO COMPL Y RISKS EQUIPMENT DAMAGE, FIRE, OR SHOCK HAZARD READ THE E ...

  • Bunn 4 - page 4

    4 INITIAL SET -UP 1. Apply the four non-skid pads from the parts box to the bottom of the legs. 2. Remove the drip tray assembly , drip tray bracket, and splash panel assembly from the parts box. 3. Place a set of key holes in the drip tray bracket over the lower two screws in the panel below the hopper access door; push down gently and tighten scr ...

  • Bunn 4 - page 5

    5 INITIAL fi ll & heat 1. T urn on the water supply and connect the dispenser to the power source. 2. Water will automatically fl ow into the tank to the proper level and then shut-off. This will take less than ten minutes. 3. When the tank is full of water , open the front door and place the ON/OFF/NIGHT switch in the “ON” (up- per) posi ...

  • Bunn 4 - page 6

    6 HOPPER DISPENSE RA TE OF PRODUCT The hopper dispense rates are preset at the factory . With 22 tooth gear and auger wire, the preset dispense rate is approximately 3 to 5 grams per second. With 30 tooth gear and auger wire, the preset dispense rate is approximately 5 to 7 grams per second. The hopper dispense rates can be individually programmed ...

  • Bunn 4 - page 7

    7 Adjust tank temperature (190° F maximum) Adjust minimum tank ready temper - ature for lockout (185° maximum) Adjust hopper motor speed for station selected T ANK TEMP XXX° (-) EXIT (+) READY TEMP XXX° (-) EXIT (+) DRINK STRENGTH (-) XX (+) XX° CAL XX° (-) T ank T emp (+) 235 REFILL 155 (-) EXIT (+) CAL WA TER ? PRESS DISPENSE Calibrate temp ...

  • Bunn 4 - page 8

    8 A. Enter program mode and advance to next menu B. Incriment display value positive C. Exit program mode D. Incriment display value negative E. Return to previous menu and interrupt dispense PORTION CONTROL MODELS D igital B everage C ontr ol D igital B everage C ontr ol ST OP PROGRAM HOME SCREEN The screen above will be shown when the dispenser i ...

  • Bunn 4 - page 9

    9 PROGRAMMING CUP SIZES - Portion Control Models The cup size can be programmed in portion control models by “EXAMPLE” or “TIME”. Programming by EXAMPLE is manually pressing desired dispense button, then releasing when the desired cup size is attained. The time required to fi ll the cup will be stored in the controller memory when moving t ...

  • Bunn 4 - page 10

    10 DISABLE MESSAGES ? NO EXIT YES Press and release right switch (advance to next menu), “T ANK TEMP XXX°” appears on screen. PROGRAMMING THE DISPENSER (cont.) T ANK TEMP XXX° READY TEMP XXX° (-) EXIT (+) STRENGTH ADJ. ? (-) EXIT (+) EXIT YES ENTER P ASSWORD (-) XXXX (+) CALIBRA TION ? EXIT YES LOCKS/DISABLES ? EXIT YES AUDIBLE ALARM ? NO EX ...

  • Bunn 4 - page 11

    11 XX° CAL XX° (-) T ank T emp (+) PROGRAMMING THE DISPENSER (cont.) DRINK STRENGTH 1 (-) XX (+) PRESS DISPENSE TO CHECK T ASTE T ASTE 1 OK ? NO YES SET FLA VOR 1 BY T ASTE RECIPE ENTER RECIPE # #.# gm/fl uid oz CHANGING V ALUES WILL EFFECT RPM ARE YOU SURE ? NO EXIT YES (B) Adjust hopper motor speed for station for station selected SELECT UNITS ...

  • Bunn 4 - page 12

    12 PROGRAMMING THE DISPENSER (cont.) LOW POWDER LOCK ? NO EXIT YES DISPENSE LOCKOUT NO EXIT YES RINSE ALARM ? NO EXIT YES HEAD 1 DISABLE ? NO EXIT YES SET P ASSWORD ? (-) XXXX (+) Returns to (G) (page 10) TEST SWITCHES ? Use Switch T o T est TEST HEA TER ? EXIT YES TEST REFILL ? EXIT YES TEST HOT WA TER ? EXIT YES TEST AUGERS ? DISPENSE TO TEST TES ...

  • Bunn 4 - page 13

    13 $Ú"5../-! 4)##/20/2!4)/. 6/, 43!#7)2% 6/, 43!#7)2% 3).',%0(!3%(: 3#(%-! 4)#7)2).'$)! '2!- I-) 8  '2. , ",+ ...

  • Bunn 4 - page 14

    14 "Ú"5../-! 4)##/20/2!4)/. 6/, 43!#7)2% 6/, 43!#7)2% 3).',%0(!3%(: 3#(%-! 4)#7)2).'$)! '2!- I-) 8 I-) 8  &a ...

  • Bunn 4 - page 15

    15 37510 010206 "Ú"5../-! 4)##/20/2!4)/. 6/, 43!#7)2% 3).',%0(!3%(: SCHEMA TIC WIRING DIAGRAM IMIX-3A '2. , ",+ ",+ ",+ ",+ ",+ ,)-)4 4(%2-/34 ...

  • Bunn 4 - page 16

    16 37510 010206 "Ú"5../-! 4)##/20/2!4)/. 6/, 43!#7)2% 3).',%0(!3%(: SCHEMA TIC WIRING DIAGRAM IMIXA-4/IMIXA-5 '2. , ",+ ",+ ",+ ",+ ",+ " ...

Manufacturer Bunn Category Coffeemaker

Documents that we receive from a manufacturer of a Bunn 4 can be divided into several groups. They are, among others:
- Bunn technical drawings
- 4 manuals
- Bunn product data sheets
- information booklets
- or energy labels Bunn 4
All of them are important, but the most important information from the point of view of use of the device are in the user manual Bunn 4.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Bunn 4, service manual, brief instructions and user manuals Bunn 4. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Bunn 4.

Similar manuals

A complete manual for the device Bunn 4, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Bunn 4 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Bunn 4.

A complete Bunn manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Bunn 4 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Bunn 4, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Bunn 4, that we can find in the current document
3. Tips how to use the basic functions of the device Bunn 4 - which should help us in our first steps of using Bunn 4
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Bunn 4
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Bunn 4 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Bunn 4?

Use the form below

If you did not solve your problem by using a manual Bunn 4, ask a question using the form below. If a user had a similar problem with Bunn 4 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)