English dropdown-ico

Manual Greenheck Fan 474051

12 pages 1.19 mb
Download

Go to site of 12

Summary
  • Greenheck Fan 474051 - page 1

    1 Fiberglass Centrifugal Fan Installation, Operation and Maintenance Manual Please read and save these instructions. Read car efully before attempting to assemble, install, operate or maintain the product described. Pr otect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury ...

  • Greenheck Fan 474051 - page 2

    2 Model BCSW-FRP Fans are pr otected against damage during shipment. If the unit cannot be installed and operated immediately , precautions need to be taken to pr event deterioration of the unit during storage. The user assumes responsibility of the fan and accessories while in storage. The manufacturer will not be r esponsible for damage during st ...

  • Greenheck Fan 474051 - page 3

    3 Model BCSW-FRP CAUTION When installing a fan, ensure the pr oper protective devices are used to pr otect personnel from moving parts and other hazards. A complete line of protective accessories ar e available from Greenheck including belt guar ds, shaft guards, and electrical disconnects. Electrical Disconnects All fan motors should have disconne ...

  • Greenheck Fan 474051 - page 4

    4 Model BCSW-FRP Ducted Outlet Installations Discharge Duct Turns - Duct turns located near the fan discharge should always be in the direction of the fan rotation. Fan performance is reduced when duct turns are made immediately off the fan discharge. T o achieve cataloged fan performance there should be at least three equivalent duct diameters of ...

  • Greenheck Fan 474051 - page 5

    5 Model BCSW-FRP Bases (Foundation and Isolation) In order to assur e continued alignment, a high strength, non-shrink epoxy gr out is recommended to provide the desir ed mechanical properties for support of the fan. This type of support ensures the appropriate transmission of static and dynamic loads to the equipment foundation. T o eliminate vibr ...

  • Greenheck Fan 474051 - page 6

    6 Model BCSW-FRP Radial Gap, Overlap and Wheel Alignment Efficient fan performance can be maintained by having the correct radial gap, overlap and wheel alignment. These items should be checked after the fan has been in operation for 24 hours and before start-up after the unit has been serviced. Radial Gap is adjusted by loosening the housing bolts ...

  • Greenheck Fan 474051 - page 7

    7 Model BCSW-FRP Flexible Couplings (Arr . 8 Only) Check for misalignment between the coupling halves. Parallel and angular misalignment and separation gap are illustrated below . Refer to coupling manufacturer’ s installation instructions for allowable misalignment and separation gap tolerances. When correcting for misalignment using shims, the ...

  • Greenheck Fan 474051 - page 8

    8 Model BCSW-FRP Vibration Excessive vibration is the most frequent pr oblem experienced during initial start-up. Left unchecked, excessive vibration can cause a multitude of problems, including structural and/or component failure. Many of these conditions can be discovered by car eful observation. Refer to the troubleshooting section of this manua ...

  • Greenheck Fan 474051 - page 9

    9 Model BCSW-FRP Routine Maintenance Once the unit has been put into operation, a routine maintenance schedule should be set up to accomplish the following: 1. Lubrication of bearings and motor (see below). 2. Wheel, housing, bolts and set screws on the entire fan should be checked for tightness. 3. Any dirt accumulation on the wheel or in the hous ...

  • Greenheck Fan 474051 - page 10

    10 Model BCSW-FRP Parts List Housing Wheel Gasket Backplate Shaft Guard Shaft Seal Shaft Belt Guard Belt Guard Cover Belt Motor Pulley Shaft Pulley Adjustable Motor Slide Base Bearings Inlet Cone Outlet Flange Base/Housing Foot Angle (4) Access Door with Gasket V-Belt Drives V -belt drives must be checked on a regular basis for wear , tension, alig ...

  • Greenheck Fan 474051 - page 11

    11 Model BCSW-FRP Problem Cause Corrective Action Excessive Noise Wheel rubbing (inlet) Adjust wheel. Tighten wheel hub or bearing collars on shaft. V -belt drive Tighten Sheaves on motor/fan shaft. Adjust belt tension. Align sheaves properly (see V -Belt Drives section). Replace worn belts or sheaves. Bearings Replace defective bearing(s). Lubrica ...

  • Greenheck Fan 474051 - page 12

    12 474051 • BCSW-FRP , Rev . 1, November 2010 Copyright 2010 © Greenheck Fan Corporation ® Phone:(715)359-6171•Fax:(715)355-2399•E-mail:gfcinfo@greenheck.com• W ebsite: www .greenheck.com AMCA Publication 410-96, Safety Practices for Users and Installers of Industrial and Commercial Fans, pr ovides additio ...

Manufacturer Greenheck Fan Category Fan

Documents that we receive from a manufacturer of a Greenheck Fan 474051 can be divided into several groups. They are, among others:
- Greenheck Fan technical drawings
- 474051 manuals
- Greenheck Fan product data sheets
- information booklets
- or energy labels Greenheck Fan 474051
All of them are important, but the most important information from the point of view of use of the device are in the user manual Greenheck Fan 474051.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Greenheck Fan 474051, service manual, brief instructions and user manuals Greenheck Fan 474051. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Greenheck Fan 474051.

Similar manuals

A complete manual for the device Greenheck Fan 474051, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Greenheck Fan 474051 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Greenheck Fan 474051.

A complete Greenheck Fan manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Greenheck Fan 474051 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Greenheck Fan 474051, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Greenheck Fan 474051, that we can find in the current document
3. Tips how to use the basic functions of the device Greenheck Fan 474051 - which should help us in our first steps of using Greenheck Fan 474051
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Greenheck Fan 474051
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Greenheck Fan 474051 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Greenheck Fan 474051?

Use the form below

If you did not solve your problem by using a manual Greenheck Fan 474051, ask a question using the form below. If a user had a similar problem with Greenheck Fan 474051 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)