-
Heat Controller CDG SERIES - page 1
INST ALLA TION INSTRUCTIONS W ARNING These instructions are intended as an aid to qualified licensed service personnel for proper installation, adjust- ment and operation of this unit. Read these instructions thoroughly before attempting installation or operation. Failure to follow these instructions may result in improper installation, adjustment, ...
-
Heat Controller CDG SERIES - page 2
Cased/Uncased Coils INST ALLA TION INSTRUCTIONS Heat Contr oller , Inc. 1 1.0 MODEL NOMENCLA TURE .....................................................................................2 2.0 SAFETY ...................................................................................................................3 3.0 GENERAL ......................... ...
-
Heat Controller CDG SERIES - page 3
Heat Contr oller , Inc. INST ALLA TION INSTRUCTIONS Cased/Uncased Coils 2 1.0 Model Nomenclature C D G 18 F A - A C = Uncased Coil M = Multi Postion Cased Coil Design Series R-410A Refrigerant 18 = 18,000 BTUH 24 = 24,000 BTUH 30 = 30,000 BTUH 36 = 36,000 BTUH 42 = 42,000 BTUH 48 = 48,000 BTUH 60 = 60,000 BTUH F = Flowrater (Piston) T = TXV A = 14 ...
-
Heat Controller CDG SERIES - page 4
Cased/Uncased Coils INST ALLA TION INSTRUCTIONS Heat Contr oller , Inc. 3 When you see the symbols below on labels or in manual, be alert to the potential or immediate hazards of personal injury , property and/or product damage. It is the owner ’s or installer ’s responsibility to comply with all safety instructions and information accompanying ...
-
Heat Controller CDG SERIES - page 5
Heat Contr oller , Inc. INST ALLA TION INSTRUCTIONS Cased/Uncased Coils 4 The unit can be positioned for bottom return air in the upow position, left and right return in the horizon - tal position, top return in downow position. 3.1 Codes & Regulations This product is designed and manufactured to comply with national codes. Installation i ...
-
Heat Controller CDG SERIES - page 6
Cased/Uncased Coils INST ALLA TION INSTRUCTIONS Heat Contr oller , Inc. 5 AUXILIARY DRAIN CONNECTION 3/4'' NPT FEMALE PIPE THREAD 3/4'' NPT FEMALE PIPE T HREAD A W 21'' 20'' W1 19'' H V APOR LINE CONNECTION COPPER (SWEAT ) LIQUID LINE CONNECTION COPPER (SWEAT ) COIL ACCESS P ANEL HORIZONT AL DRAIN C ...
-
Heat Controller CDG SERIES - page 7
Heat Contr oller , Inc. INST ALLA TION INSTRUCTIONS Cased/Uncased Coils 6 H The Max.resistant pressure of evaporator is up to 16MPa (2320PSI) TOP AIR STOP LIQUID LINE CONNECTION V APOR LINE CONNECTION W D AUXILIARY DRAIN CONNECTION 3/4'' NPT FEMALE PIPE THREAD PRIMARY DRAIN CONNETION 3/4'' NPT FEMALE PIPE THREAD The Max. pressur ...
-
Heat Controller CDG SERIES - page 8
Cased/Uncased Coils INST ALLA TION INSTRUCTIONS Heat Contr oller , Inc. 7 4.0 Installation Instructions 4.1 Parts Contact your distributor for authorized replacement parts. 4.2 Pre-Installation Instructions Carefully read all instructions for installation prior to installing product. Make sure each step or procedure is understood and any special co ...
-
Heat Controller CDG SERIES - page 9
Heat Contr oller , Inc. INST ALLA TION INSTRUCTIONS Cased/Uncased Coils 8 5.0 Drain Applications 5.1 Condensate Drain Piping Consult local codes for special requirements. T o provide extra protection from water damage, install an additional auxiliary drain pan, provided by installer under the entire unit with a separate drain line. Manufacturer wil ...
-
Heat Controller CDG SERIES - page 10
Cased/Uncased Coils INST ALLA TION INSTRUCTIONS Heat Contr oller , Inc. 9 Drain pan has two drain connections on each side to provide exibility of connection and drainage. Make sure pan has proper pitch and plugged if second connection is not used. It is highly recommended to use the secondary drain line to prevent overow when the primary dra ...
-
Heat Controller CDG SERIES - page 11
Heat Contr oller , Inc. INST ALLA TION INSTRUCTIONS Cased/Uncased Coils 10 6.0 Refrigerant Connections T o prevent refrigerant leak, use proper tools to ensure clean, burr-free cut. Use brazing shield when welding close to the cabinet surface and wet rag to protect rubber grommet. Brazing alloy should be at least 5% silver content. 6.1 Flowrator Pi ...
-
Heat Controller CDG SERIES - page 12
Cased/Uncased Coils INST ALLA TION INSTRUCTIONS Heat Contr oller , Inc. 1 1 Condensing Unit Model No. HCI Indoor Coil PISTON SIZE Cased Coil Uncased Coil RSG18S-1D RSG18R-1D MDG18F A -A CDG18F A - A 0.050 MDG18FB-A CDG18FB- A RSG2 4S-1D RSG2 4R-1D MDG2 4F A- A CDG2 4F A - A 0.053 MDG2 4FB- A CDG2 4FB- A RSG30S-1D RSG30R-1D MDG30F A -A CDG30FA-A 0.0 ...
-
Heat Controller CDG SERIES - page 13
04/2009 0 7 /201 1 ...
¿Tienes una pregunta acerca de Heat Controller CDG SERIES?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Heat Controller CDG SERIES, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Heat Controller CDG SERIES probablemente compartirá una forma de solucionarlo.